BONDA Tuya Wi-Fi Smart Touch Switch User Manual

1. Product Overview

The BONDA Tuya Wi-Fi Smart Touch Switch is a modern, intelligent light switch designed for convenient control of your lighting. It features a luxury glass panel, touch-sensitive buttons, and can be controlled via Wi-Fi through the Smart Life/Tuya Smart app, voice commands with Amazon Alexa or Google Home, and an RF433 remote control. This switch supports both neutral wire and no-neutral wire installations.

Figure 1: Luxury Glass Panel Design. The panel resists deformation and fading, offering easy maintenance and cleaning.

2. Safety Information

• Always turn off the main power supply at the circuit breaker before performing any electrical work.
• Ensure wiring is done by a qualified electrician if you are unsure.
• Do not operate the switch with wet hands.
• This device is for indoor use only.

3. Installation Guide

3.1. Preparation

1. Turn off Power: Locate your circuit breaker and turn off the power to the light switch you are replacing. Verify power is off with a voltage tester.
2. Remove Old Switch: Carefully remove the faceplate and unscrew your existing light switch from the wall box. Disconnect the wires.
3. Remove Smart Switch Panel: Use a screwdriver to gently pry off the glass front panel of the BONDA Smart Switch.

3.2. Wiring Diagrams

The BONDA Smart Touch Switch supports two wiring methods: with a neutral wire or without a neutral wire (single live wire). Please refer to the appropriate diagram below for your installation.

Figure 2: Installation Wiring Diagram (Refer to original image for full detail).

Method A: With Neutral Wire (N Terminal Support)

• Fire Wire (Live): Connects to the 'L' terminal on the switch.
• Lamp Wires (Load): Connects to 'L1', 'L2', 'L3', 'L4' terminals on the switch, corresponding to each gang.
• Neutral Wire: Connects to the 'N' terminal on the switch.

Method B: Without Neutral Wire (Single Live Wire)

This method requires the installation of a capacitor (included) for stable operation, especially with LED or low-power lights.

• Live Wire: Connects to the 'L' terminal on the switch.
• Lamp Wires (Load): Connects to 'L1', 'L2', 'L3', 'L4' terminals on the switch.
• Capacitor Installation: Connect the provided capacitor across the first lamp wire (L1) and the neutral wire of the light fixture. This is crucial for preventing flickering or unstable operation.

3.3. Finalizing Installation

1. After wiring, carefully push the switch into the wall box and secure it with screws.
2. Reattach the glass front panel by aligning it and pressing firmly until it clicks into place.
3. Restore power at the circuit breaker. The switch's indicator light should illuminate.

4. Operating Instructions

4.1. App Download & Registration

1. Download App: Scan the QR code below or search for