1. Introduction
Thank you for choosing the ZOHAN EM037 Bluetooth 5.0 Electronic Hearing Protection Earmuffs. This manual provides essential information for the safe and effective use of your new device. Please read it thoroughly before operation.
Key Features:
- Bluetooth 5.0 Technology for hands-free calling and wireless music.
- Built-in rechargeable battery with USB charging.
- Effective Noise Reduction Rating (NRR) of 25dB and Signal-to-Noise Ratio (SNR) of 30dB.
- Deep Bass & Truly Stereo sound.
- Infinite playtime via the 3.5mm audio port (wired mode).
- Premium padded headband and breathable, comfortable ear cushions for extended wear.
Package Contents:
- ZOHAN EM037 Bluetooth Earmuffs
- USB Charging Cable
- 3.5mm Audio Cable
- Premium Leather Bag
- User Manual
2. Safety Information
To ensure proper hearing protection and safe operation, please observe the following:
- Always ensure the earmuffs are properly fitted to achieve the stated Noise Reduction Rating (NRR).
- Do not modify the earmuffs, as this may compromise their protective capabilities.
- Keep the device away from extreme temperatures, moisture, and corrosive materials.
- Use only the provided charging cable or a certified USB charger.
- Avoid listening to music at excessively high volumes for prolonged periods to prevent hearing damage.
- Be aware of your surroundings when using the earmuffs, especially in environments where situational awareness is critical.
3. Setup
3.1 Charging the Headset
The earmuffs feature a built-in 1500mAh rechargeable lithium battery. To charge:
- Connect the included USB charging cable to the charging port on the earmuffs.
- Plug the other end of the USB cable into a compatible USB charger (e.g., car charger, power bank, computer USB port).
- The LED indicator will glow red while charging.
- Once fully charged (approximately 4 hours), the LED indicator will turn solid blue.
Low Battery Warning: When the battery level drops below 20%, the headset will announce "Low Battery" every minute for 20 minutes. Please charge the headset promptly to prevent automatic shutdown.
3.2 Fitting the Headset
Proper fit is crucial for effective noise reduction and comfort:
- Fully extend the headband and place the ear cups over your ears.
- Adjust the headband by sliding it up or down until the ear cups fit snugly and comfortably over your ears.
- Ensure the ear cushions form a firm seal around your ears.
- Do not allow hair or clothing to obstruct the ear or the earmuff's secure fit.
- Ensure the ear cups are not sitting crooked or askew over your ears.
4. Operating Instructions
4.1 Controls Overview
- Power Button (Center): Controls power on/off and play/pause.
- Tuning Buttons (Left/Right Arrows): Controls track skipping and volume adjustment.
- Connect BT (M Button): Used for Bluetooth pairing, answering/ending calls, and replaying.
- USB Charging Port: For charging the internal battery.
- AUX JACK: For wired audio connection.
- LED Indicator: Shows power, charging, and Bluetooth status.
4.2 Power On/Off
- To Power On: Press and hold the Power Button (center) for 2 seconds. A voice assist will announce power on.
- To Power Off: Press and hold the Power Button (center) for 3 seconds. A voice assist will announce power off.
4.3 Bluetooth Pairing
- Ensure the earmuffs are powered on and in pairing mode (LED blinking blue). If not, long press the 'M' button for 10 seconds to enter pairing mode.
- Enable Bluetooth on your mobile device (smartphone, tablet, etc.).
- Search for available devices and select "EM037" from the list.
- Once connected successfully, you will hear "Bluetooth Connected".
- The earmuffs will automatically connect to the last paired device when powered on. For some devices, you may need to manually confirm the connection.
4.4 Phone Mode Operations
| Action | Button Press | Touch and Hold |
|---|---|---|
| Pick up / Hang up call | Press 'M' button | |
| Replay last number | Touch and hold 'M' button | |
| Mute / Unmute microphone | Single press 'M' button | |
| Switch between calls (during a second incoming call) | Double press 'M' button | Long press 'M' for 2 seconds (to end second call and switch to first) |
| Reject incoming call | Long press 'M' for 2 seconds |
4.5 Music Mode Operations
| Action | Button Press | Touch and Hold |
|---|---|---|
| Play / Pause music | Press 'M' button | |
| Next track | Double press right arrow button | |
| Previous track | Triple press left arrow button | |
| Adjust volume | Touch and hold left/right arrow buttons |
4.6 Audio Input Mode (Wired Connection)
For continuous listening without battery drain, you can use the wired connection:
- Connect one end of the included 3.5mm stereo audio cable to the AUX JACK on the earmuffs.
- Connect the other end of the cable to the 3.5mm audio output port of your device.
- In wired mode, control input volume, play/pause, track selection, and calls directly from your connected device.
5. Specifications
| Feature | Specification |
|---|---|
| Model Number | EM037 |
| Brand Name | ZOHAN |
| Bluetooth Version | 5.0 |
| Noise Reduction Rating (NRR) | 25dB |
| Signal-to-Noise Ratio (SNR) | 30dB |
| Battery Capacity | 1500mAh Lithium Battery |
| Bluetooth Playtime | >40 Hours |
| Wired Playtime | 48+ Hours (infinite with external power) |
| Bluetooth Range | Up to 80ft |
| Charging Time | Approx. 4 Hours |
| Certification | CE |
| FCC ID | 2AYWU-EM037 |
| Package Dimensions (L x W x H) | 23 cm x 18 cm x 13 cm |
| Package Weight | 0.521 kg |
6. Maintenance
- Cleaning: Wipe the earmuffs with a soft, damp cloth. Do not use abrasive cleaners or immerse the device in water.
- Storage: When not in use, store the earmuffs in the provided premium leather bag to protect them from dust, dirt, and damage. Store in a cool, dry place.
- Ear Cushions: Periodically inspect ear cushions for wear and tear. Replace if damaged to maintain optimal noise reduction and comfort. Snap-in ear cushions make replacement easy.
7. Troubleshooting
- No Power / Device Not Turning On:
- Ensure the battery is charged. Connect to a USB charger and check the LED indicator.
- Unable to Pair via Bluetooth:
- Make sure Bluetooth is enabled on your device and the earmuffs are in pairing mode (LED blinking blue). Try re-pairing by long pressing the 'M' button for 10 seconds. Ensure no other devices are actively connected to the earmuffs.
- No Sound / Poor Sound Quality:
- Check the volume levels on both the earmuffs and your connected device. Ensure the earmuffs are properly fitted over your ears for optimal sound and noise reduction. If using wired mode, ensure the 3.5mm audio cable is securely connected to both devices.
- Microphone Not Working During Calls:
- Ensure the microphone is not muted. Check your phone's settings to ensure the earmuffs are selected as the audio input device.
- Does not support active noise cancellation (ANC):
- The EM037 provides passive noise reduction (NRR 25dB, SNR 30dB) through its design and materials, not active noise cancellation with a dedicated button.
- Cannot connect to two phones simultaneously:
- This product does not support multipoint connections. It can only be connected to one Bluetooth device at a time.
8. User Tips
- The sound quality is well-balanced and suitable for audiobooks, podcasts, and general music listening, rather than high-fidelity audio.
- The earmuffs offer a secure and comfortable fit, even for extended periods. Initial tightness may ease with regular use.
- The Bluetooth range is robust, maintaining connection even with some obstacles.
- Expect excellent battery life, often lasting several days with moderate daily use.
- The physical buttons are tactile and easy to operate, even when wearing gloves.
- Due to effective noise isolation, exercise caution when using the earmuffs in environments where situational awareness (e.g., traffic) is critical.
9. Warranty and Support
PROHEAR offers a 3-YEAR-WARRANTY for this product. Customer satisfaction is our top priority.
If you have any questions, suggestions, concerns, or issues, please do not hesitate to contact us:
Email: support@proheartac.com
Our friendly customer service team aims to respond within 24 hours.
10. FCC and ISED Compliance
PROHEAR EM037 FCC Statement BT Note
FCC ID: 2AYWU-EM037
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and.
- This device must accept any interference received, including interference that may cause undesired operation.
PROHEAR EM037 ISED Note
IC: 29764-EM037
NOTE: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
- L'appareil ne doit pas produire de brouillage;
- L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune autre antenne ou émetteur. Cet équipement devrait être installé et actionné avec une distance minimum de 20 centimètres entre le radiateur et votre corps.