1. Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your E-ACE 10-Inch Car DVR Mirror Video Recorder. We strive for accuracy, but specifications and details may vary slightly due to product improvements.
Important Notes:
- The dimensions provided are approximate values.
- Illustrations are for illustrative purposes only and may differ from actual products.
- Product specifications and appearance are subject to change without prior notice for improvement.
2. Product Overview
The E-ACE 10-Inch Car DVR Mirror Video Recorder offers dual-lens recording, a 9.66-inch touch screen, night vision, and loop recording capabilities. It is designed to provide clear video evidence for safer driving.

Parts Identification

- TF Card Slot
- Rear Camera Interface
- Power Input
- Reset Button
- Power Button
Package Contents

- Car charger
- Fixed bandage
- Instructions (User Manual)
- Card reader
- Optional: 1080P Rear view camera + 6/10 m cable
- Optional: Buck line (Hardwire kit)
3. Setup
Installation Guidelines
- Before use, remove the protective film and shoot some videos to test camera quality.
- Use only the original power supply. Using other brands may damage or burn the equipment.
- For parking monitoring or motion detection, a buck line (hardwire kit) is required to connect the video recorder to the car battery (sold separately).
- Install the unit near the rear-view mirror for maximum wide-angle landscape recording.
- Ensure the lens is within the wiper range for clear recording even in rain.
- Do not touch the lens with fingers; oil can leave unclear video. Clean the lens regularly with a soft cloth. Avoid chemical detergents, gasoline, alcohol, or antistatic sprays.
- This product is suitable for most cars. For trucks, consider the length of the car charger line.
- Scan the QR code in the manual for an installation video. Professional auto mechanic installation is highly recommended.
Power Button Functions
- Turn On: Press and hold the Power Button for 2 seconds. The device will start automatically.
- Turn Off: Press and hold the Power Button for 2 seconds to save video files and settings, then the device will shut down.
- Display On/Off: In power-on state, press the Power Button to turn the display black, press again to turn it on.
Initial Settings
- Language: Navigate to settings to change the OSD language. If your desired language is not available, contact support for new firmware.
- Time Zone: Set your local time zone in the settings menu.
- SD Card: Format the Micro SD card before first use. A Class 10 or above Micro SD card (up to 128GB) is recommended.
4. Operating Instructions
Main Interface and Touch Controls

- Screen Swipe (Up/Down): Change the display position of the current camera video screen.
- Screen Swipe (Left/Right): Change the video display source (front view, rear view, split screen). Sliding left/right on the brightness part adjusts screen brightness.
- Locking (EMR Emergency): In video mode, click the lock icon to lock the current video (adds 20s to the current video time as a locked file). Click again to unlock.
- Audio Switch: Click the audio icon to turn recording audio on/off.
- Video Recording: The default icon for video state is a camera. Click to change video status.
- Take Photo: Click the photo icon to take a picture while recording.
Playback Interface
- Access: Click the 'Playback' icon on the main interface.
- File Types: View normal recording files, locked video files, and photo files.
- File Storage: Front camera recordings are in "front_norm", rear camera in "back_norm". Locked files are in "front_emr" and "back_emr". Photo files are in "front_photo" and "back_photo".
- Navigation: Swipe up/down to select files.
- Camera Switching: Switch between front and rear camera files during playback.
- Delete: Select a file and click the delete icon.
- Select All: Select all files for bulk operations.
Settings Menu
- Resolution: Adjust video resolution (4K/2.5K/1080P/720P).
- Brightness: Adjust screen brightness by sliding up/down or left/right.
- License Plate: Set your license plate number.
- WiFi: Enable/disable WiFi. The icon turns green when connected to the mobile app. Scan the QR code in settings to download the WiFi APK.
- GPS: The GPS icon turns white when the module is plugged in and green when a signal is received. GPS speed (km/h or mph) will be displayed.
- G-Sensor: Adjust sensitivity (OFF/LOW/MIDDLE/HIGH). Detects sudden shakes/collisions to lock footage.
- Parking Monitor: Adjust sensitivity (OFF/LOW/MIDDLE/HIGH). Automatically records when vibration is detected while parked (requires hardwire kit).
- Time Lapse Recording: Select recording intervals (off, 5 hours, 12 hours, 24 hours) and contraction intervals (0.5s, 1s, 5s). Requires ACC function to be on and a hardwire kit.
- Stream Media: OFF/ON. When ON, rear camera is full screen. When OFF, front camera is full screen.
- Screen Sleep: Set screensaver to off, 10s, 30s, or 3 minutes. Recording continues even when the screen is off.
5. Maintenance
- Cleaning: Regularly clean the lens with a soft cloth to remove dust. Avoid chemical detergents, gasoline, alcohol, or antistatic sprays.
- SD Card Formatting: Periodically format the Micro SD card to ensure optimal performance and prevent issues with locked files.
- Factory Reset: If encountering persistent issues, a factory reset can restore all settings to their default values. This option is available in the settings menu.
6. Troubleshooting
Frequently Asked Questions
- Dash cam cannot be turned on:
- Plug in the car charger and press the On-Off key for ~3 seconds.
- Charge for ~5 minutes, then manually restore factory settings.
- Press the Reset button with a pin to restore factory settings.
- Dash cam turns on/off automatically:
- The dash cam requires constant power from the car charger. The built-in battery is small and primarily for parking monitor mode.
- Use a genuine Class 10 or above Micro SD Card and format it before use.
- Product cannot read the card:
- Use a genuine Class 10 or above Micro SD Card. Format the SD Card on a computer, then insert it correctly (there will be slight rebound resistance).
- Video function cannot be used normally:
- Format the micro SD card in the dash cam before using. Support 16GB/32GB/64GB/128GB micro SD card, Class 10 or above is recommended.
- Product cannot be used normally after a period of time:
- High G-sensor sensitivity can lead to too many locked files, preventing loop recording. Manually delete locked files or set G-sensor to medium/low.
- Avoid using motion detection when not driving.
- Rear camera doesn't work:
- Check if the rear camera is connected properly and tightly.
- Image from rear camera is upside down:
- The rear camera is installed in the wrong direction. Adjust its physical orientation.
- Screen turns black after ~1 minute:
- The Screen Dormant function is enabled in settings. Turn it off.
- Product cannot set date and time correctly:
- Ensure sufficient power. Go to system settings, find date/time option, set it, then manually turn off the dash cam to save.
- Product heats up automatically:
- Normal for prolonged use or high car temperatures.
- Recorded image is unclear:
- Remove protective films from both front and rear camera lenses.
- Check if the windshield is clean.
- Button sound is noisy:
- Select "OFF" for the operation voice (OFF/ON) button in system settings.
7. Specifications
| Attribute | Value |
|---|---|
| Brand Name | E-ACE |
| Aperture | F 2.0 |
| Warranty | 365 Days |
| Cable Length (Rear Camera) | 6 meters |
| Dimensions (W x H x D) | 9.66 Inches |
| Input/Output | Jack 2.0 |
| Power Source | Corded Electric |
| Data Storage Capacity | Up to 128GB |
| Built-in Screen | Yes |
| Loop-Cycle Recording Feature | Yes |
| Audio Recorded | Yes |
| Maximum Video Frame Rate | 30 FPS |
| NightShot Function | Yes |
| Rear Camera | Yes (Optional) |
| Battery Life | Connect With Charger Work |
| Original Package | Yes |
| Touch Screen | Yes |
| Screen Ratio | 16:9 |
| Memory Card Required Reading Speed | Class 10 |
| View angle | 170° |
| Camera Resolution | 1920x1080 |
| Video Code | MJPG |
| Video Format | AVI |
| Is Batteries Included | Yes |
| Special Features | G-Sensor, Digital zoom, motion detection, sd/mmc card, With Rearview Mirror, Anti Surge Voltage Impact, Waterproof, Anti Fog, Anti Vibration, Real Time Surveillance, Automatic White Balance, Wide Dynamic Range |
| Max External Memory | 128G |
| Number Of Lenses | 2 |
| Imaging Sensor | GC2053 |
| Pixels | 500Mega |
| Display Size | Other (9.66 Inches) |
| OSD Language | Arabic, Chinese (Simplified), Chinese (Traditional), Dutch, English, French, German, Hebrew, Hungarian, Italian, Japanese, Korean, Polish, Portuguese, Romanian, Russian, Spanish, Turkish, Ukrainian, Vietnamese |
| GPS logger | None |
| Battery | built-in |
| Assembly Mode | Rearview Mirror |
| Chipset Manufacturer | Generalplus |
| Frames Per Second | 25 |
| Origin | Mainland China |
| Display | IPS |
| Item Type | Car DVR |
| Certification | CE, FCC, RoHS, UL, pse, weee |
| Battery Capacity(mAh) | 300-500mah |
| Interface | AV-In, USB2.0, Micro SD/TF |
8. User Tips
- Heat Resistance: This product has been noted by users to work well even in high temperatures, suggesting good heat resistance.
- Language Settings: If the device is in an unfamiliar language (e.g., Russian), navigate to the settings menu to change the OSD language to English or your preferred language.
- Rear Camera Connection: Ensure the rear camera cable is securely connected. If you need a longer cable for larger vehicles like trucks or caravans, check for compatible extensions. The manual specifies a 6-meter cable for the rear camera.
- SD Card Compatibility: Always use a Class 10 or higher Micro SD card (up to 128GB) and format it in the device before first use to avoid card reading or video recording issues.
- Parking Monitor: To utilize the parking monitor function effectively, a hardwire kit (buck line) is required to provide continuous power to the device when the vehicle is off.
- No SIM Card Slot: This device is a dashcam and does not support SIM cards for cellular connectivity. Any messages about inserting a SIM card are likely due to a misunderstanding of the product's features.
- Unfocused Camera: If the main camera appears unfocused, ensure all protective films have been removed from the lens and that the lens itself is clean.
9. Warranty and Support
Warranty Information
- 30-Day Money-Back Guarantee: Return your undamaged product within 30 days of purchase for a full refund for any reason.
- 12-Month Warranty: For 12 months from the date of purchase, we will address all quality-related issues with a replacement or full refund.
Friendly Reminder: Always read the user manual and ensure the product is used as instructed. When contacting for support, have your product handy for troubleshooting.
Limitations: Our return and exchange service is limited to purchases made from authorized stores. If purchased through a different retailer, please contact them directly. Unauthorized reselling of our products is prohibited.
Contact Information
For further assistance or inquiries, please use the following contact details:
- Email: fireking@e-ace.cn
- Phone: +86 0755-8464 4084
- Tel (WhatsApp): +86-18127083357
You can also refer to the full user manual in PDF format for more detailed information: View User Manual (PDF)