1. Introduction
Product Overview
The LED Underwater Light is designed for use in aquariums, diving ponds, pools, and fountains. It features a high-brightness LED emitter, offering a long lifespan and low heat generation. This light is easy to install and provides brilliant illumination for various aquatic environments.
Key Features
- New and high-quality construction.
- Fully submersible and perfectly sealed, with IP67 waterproof rating.
- Equipped with an LED bulb, offering 180-degree light direction.
- Adjustable stand allows for vertical or horizontal mounting and precise light aiming.
- Ideal for illuminating and coloring aquariums, fountains, and ponds, enhancing the aesthetic of garden ponds.
- Super bright, long-lasting, and easy to install.
2. Setup and Installation
Package Contents
- 1 x LED Underwater Light (RGB versions include a remote controller).
Mounting
The light features a self-contained installation method with an adjustable stand. It can be mounted vertically or horizontally. Use the adjustable stand to point the light at your desired angle.

Figure 1: LED Underwater Light with mounting bracket and wiring.
Electrical Connection
This LED underwater light operates on AC/DC 12V. Ensure your power supply matches these specifications before connecting. The light comes with two wires (typically red and blue/black). Connect these wires to your 12V AC or DC power source. For RGB models, ensure the remote controller is accessible for operation.
Important: Always disconnect power before making any electrical connections. If you are unsure about electrical wiring, consult a qualified electrician.
Placement
The light is fully submersible and perfectly sealed (IP67 rated), making it suitable for direct placement in water features such as fountains, ponds, and pools.

Figure 2: Examples of LED underwater lights installed in fountains and pools.
3. Operation
Powering On/Off
Once properly installed and connected to a 12V power source, the light will illuminate when power is supplied. To turn off the light, disconnect the power supply.
Light Color Selection (for RGB models)
For RGB models, a remote controller is included to change light colors and modes. Point the remote at the light to select desired colors (Red, Green, Blue, etc.) or dynamic lighting effects.

Figure 3: RGB LED light with its dedicated remote controller.
White and Warm White models provide a single, consistent light color.

Figure 4: Comparison of White and Warm White illumination.
Projection
The light has a projection distance of 30M-50M, providing ample illumination for various water features.
Video 1: Product demonstration showing different shell colors and light outputs (White, Warm White, RGB).
4. Maintenance
Cleaning
Periodically clean the lens of the light to ensure optimal brightness and light projection. Use a soft cloth and mild soap solution if necessary. Avoid abrasive cleaners that could scratch the lens.
Inspection
Regularly inspect the light for any signs of damage, especially to the cable and the housing seals. While the light is IP67 rated, prolonged exposure or physical damage can compromise its waterproof integrity. Ensure all screws are tight and the housing is intact.
5. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Light does not turn on | No power supply | Check 12V power connection and source. |
| Incorrect voltage | Ensure power supply is AC/DC 12V. | |
| Damaged wiring | Inspect wiring for cuts or loose connections. | |
| RGB remote not working | Remote battery low/dead | Replace remote battery. |
| Obstruction between remote and light | Ensure clear line of sight. | |
| Water inside housing | Seal compromised | Immediately disconnect power. Inspect housing for cracks or damage to seals. This product is designed to be waterproof (IP67), but damage can occur. |
| Screws rusting | Non-stainless steel screws used | While the product is designed for underwater use, some components like screws may be susceptible to rust over time. Consider replacing with stainless steel screws if rust appears. |
6. Specifications
| Attribute | Value |
|---|---|
| Power | 10W |
| Input Voltage | AC/DC 12V |
| Light Source | LED bulbs |
| Light Color Options | White, Warm White, RGB |
| Body Material | Aluminum |
| Shell Color Options | Silver, Black |
| Waterproof Rating | IP67 |
| Protection Level | IP67 |
| Projection Distance | 30M - 50M |
| Installation Method | Self-contained |
| Warranty | 2 Years |
| Certifications | CE |
| Light Head Diameter | ~74 mm |
| Light Head Height | ~76 mm |
| Total Height (with bracket) | ~95 mm |
| Bracket Width | ~60 mm |
| Bracket Hole Spacing | ~40 mm |
| Package Length | 20 cm |
| Package Width | 15 cm |
| Package Height | 12 cm |
| Package Weight | 0.252 kg |
7. User Tips
- Brightness: Users have noted the excellent brightness of these lights. For optimal effect, consider placement that maximizes light spread in your water feature.
- Lens Type: Some users prefer this model over those with convex lenses for its light output characteristics.
- Waterproofing: Although rated IP67, regularly check the integrity of seals and ensure all components are securely fastened, especially if the light is permanently submerged. If replacing screws, use stainless steel to prevent rust.
- Dimensions: Before purchasing or installing, verify the maximum diameter of the housing to ensure it fits your intended location. Refer to the specifications section for detailed measurements.
- Power Supply: Always double-check that your power supply is a stable AC/DC 12V to prevent damage to the LED light.
8. Warranty and Support
Warranty Information
This product comes with a 2-year warranty from the date of purchase. The warranty covers manufacturing defects and malfunctions under normal use. Please retain your proof of purchase for warranty claims.
Customer Support
For any questions, technical assistance, or warranty claims, please contact the seller or manufacturer through your purchase platform. Refer to the user manual (PDF) available for download from the product page for additional details.
User manual (PDF) available at: Product Manual PDF