1. Important Safety Instructions
- To prevent electric shock, do not place the device near a water source, and do not immerse the product mainframe in water or other liquids.
- Read all relevant information and safety instructions carefully before using the product for the first time.
- Do not tie or knot the main power cord. To avoid tripping over the power cord, do not let it hang over the edge of a table or cabinet.
- Ensure the voltage matches the specification label located on the bottom of the product host. This mixer operates on AC power supply, and the speed regulating knob must be turned off (position '0') before connecting to power.
- This product is suitable for indoor use only; do not use outdoors.
- Do not place the device near fire sources, flammable materials (curtains, textiles, etc.), induction cookers, ovens, or other heat sources.
- Place the device on a horizontal, stable surface before use.
- Position the device as close to the power supply as possible so that power can be disconnected quickly and easily.
- This device must be operated at its rated voltage. If unsure about power supply details, consult your supplier or local power supply company.
- Do not attempt to repair the machine yourself. Opening or moving the cover may expose you to electric shock or injury.
- The device must be serviced by an authorized after-sale or qualified repair shop for maintenance.
- Keep the appliance away from children and out of their reach.
- This device is designed for specific functions and should only be used within its intended scope.
- Do not use the mixer without supervision or for continuous, unattended operation.
- Do not touch the moving parts with your fingers during operation.
- When cleaning the fuselage, the power plug must be unplugged.
2. Product Overview
Familiarize yourself with the components of your BioloMix Stand Mixer:
- Top cover
- Planets wheel
- Stainless steel bowl
- Lower body
- Upper body
- Head button
- Time display window
- Time adjustment button
- Speed knob
- Bottom
- Bowl Cover
- Dough hook
- Flat beater
- Whisk
3. Setup and Installation
Before first use, ensure all parts are thoroughly cleaned (refer to the Cleaning section).
3.1. Installing the Bowl Cover
- Place the head of the machine in a horizontal position.
- Position the bowl cover upward into the body.
- Rotate the bowl cover clockwise until it clicks into place, indicating it is locked.
3.2. Installing the Stainless Steel Bowl
- Press the "raise" button to lift the head of the machine.
- Install the stainless steel bowl as shown in the picture.
- Clamp it clockwise until secure.
3.3. Installing Accessories (Dough Hook, Flat Beater, Whisk)
To install an accessory, insert it into the clamping slot of the planetary wheel shaft. Lift it upward with a little force, then rotate counterclockwise to secure it. The machine cannot be switched on when installing mixing parts.
4. Operating Instructions
Upon power-on, the lamp circle lights up once then goes off, and the digital display shows "00:00". The product enters standby mode. If the speed knob is not at "0", the digital display will flash "00:00", requiring you to turn the knob to "0" before starting. The product features 6 speeds, "0" for standby, "P" for pulse maximum speed, and 1-6 for working speeds from low to high.
4.1. Kneading Dough (Dough Hook)
- Place flour and water into the stainless steel bowl. Install the bowl cover, stainless steel bowl, and Dough hook according to the installation instructions.
- For western-style dough (e.g., cake, pizza), a flour-to-water ratio of 5:3 is suggested. Minimum: 300g flour, 180g water. Maximum: 1500g flour, 900ml water.
- For Chinese dough (e.g., steamed bread, stuffed bun), a flour-to-water ratio of 2:1 is suggested. Maximum flour: 1000g. Cream/milk/water and other liquids combined should not be less than 500g. Reduce water proportion if reducing flour.
- Use speeds 1-3 for heavy mixtures.
- Recommended operation: 30 seconds at Speed 1, 30 seconds at Speed 2, 4 minutes at Speed 3. Rest for 15-30 minutes after every 5 minutes of continuous operation to prevent overheating.
4.2. Mixing (Flat Beater)
- Place ingredients (e.g., salad, fruit, milk) into the stainless steel bowl. Install the bowl cover, stainless steel bowl, and Flat beater according to the installation instructions.
- Minimum mixing capacity: 500g. Maximum mixing capacity: 1500g. Do not exceed the maximum capacity to prevent overflow.
- Use speeds 1-4 for medium mixtures.
- For butter or cream mixtures, use speeds 1-2 for 1 minute, then speeds 3-5 for 4 minutes. Too high a speed may cause spillage.
4.3. Whisking (Whisk)
- Place 3-10 egg whites into the stainless steel bowl. Install the bowl cover, stainless steel bowl, and whisk according to the installation instructions.
- For mixing cream and other easily expandable liquids, the maximum capacity of the bowl is 1.0L.
- Use speeds 5-6 for light mixtures.
- For liquid foods like fresh milk, to prevent spillage, start with speeds 1-3 for 1 minute, then use speed 6 for 4 minutes.
4.4. Timer Mode
- The machine can set a working time of up to 15 minutes. Press the +/- buttons to adjust the time in 15-second intervals. Holding +/- for 1.5 seconds will adjust the time automatically in 30-second intervals until 15:00 or 00:00 is displayed.
- To change the time during operation, press +/-. The display will adjust by 15 seconds based on the current time. Release the button, and the new time will start counting down after approximately 2 seconds.
- To reset the display time, press +/- simultaneously.
Note on Overheat Protection:
The machine has an overheat protection function. Continuous kneading operations can cause the internal temperature to rise, activating this protection. The machine will automatically stop, and the digital LED will flash "HOT" as a warning. To prevent food waste, allow the machine to cool for 15-30 minutes after each kneading session.
5. Maintenance and Cleaning
- Before cleaning, ensure the speed knob is in the "0" position, unplug the power cord, and allow the machine to cool.
- To clean the outside of the machine, use a dry or damp cloth with a mild cleaning agent. Do not allow water or cleaning agent to enter the machine to prevent damage or electric shock.
- Do not clean the inside or outside of the machine with abrasive materials or alcohol.
- Do not submerge the machine in water.
- Exercise caution during cleaning to avoid damage from sharp or rotating parts.
- For the stainless steel bowl, use warm water (below 40 degrees Celsius) and a neutral detergent. Do not use abrasive cleaners or lotions with special acid/alkali compositions.
- When cleaning the Dough hook, Flat beater, and whisk, use warm water (below 40 degrees Celsius) and a neutral detergent. These accessories cannot be washed with high-temperature water or in a dishwasher.
- After cleaning, thoroughly dry the Dough hook, Flat beater, whisk, and other accessories before storage.
6. Troubleshooting: Fault Code Table
| Code | Description | Solution |
|---|---|---|
| E1 | Hall transducer is abnormal (Signal line broken or motor blocked) | Contact customer support or a qualified technician. |
| E2 | NTC signal is abnormal (Signal line is disconnected and motor working temperature is not detected) | Contact customer support or a qualified technician. |
| HOT | Motor overheat protection | Automatic recovery after cooling (allow 15-30 minutes). |
7. Specifications
| Attribute | Value |
|---|---|
| Model Number | BM601 |
| Brand Name | Biolomix |
| Launch Year | 2022 |
| Available Color | Red/Black/Grey/Silver |
| Mixing Bowl Capacity | 6L |
| Number of Speed Settings | 6+P Speed |
| Max Continuous Operating Time | 20 Minutes |
| Motor Type | DC Quiet Motor |
| Power (W) | 1200W |
| Noise Level | ≤60dB |
| Timer Function | Max 15 minutes timed auto shutdown |
| Housing | Plastic |
| Mixing Bowl Material | Stainless steel |
| Accessory Type | Dough Hook, Flat Beater, Mixing Bowl, Wire Whip |
| Certification | CE, RoHS |
| Voltage | 220 V |
| Structure | Stand / Table |
| Feature | Tilt-Head Design |
| Origin | Mainland China |
| Package Length | 41 cm |
| Package Width | 27 cm |
| Package Height | 40 cm |
| Package Weight | 5.4 kg |
8. User Tips
- For kneading hard dough, 250 to 300 grams of flour works well. The mixer can handle up to 500 grams for snacks and bread without issues.
- The mixer's quiet DC motor is a notable feature, making it suitable for use without excessive noise.
- The foam padding and anti-slip silicone suction feet ensure the mixer remains stable, even at higher speeds, preventing it from moving across the counter.
- While effective for whipping cream, the speed might not be as fast as some dedicated whipping tools, but it gets the job done.
- The 6L bowl capacity is generous and convenient for family-sized batches.
9. Warranty and Support
For any inquiries or support, please contact the manufacturer:
Manufacture: BioloMix Trading Co.,Ltd
Address: No.6, Shaingkeng Road, Liaobu Town, Dongguan City, Guangdong Province, 523401, China.
E-mail: Biolomix@vigormix.com
An official user manual in PDF format is available for detailed guidance: View User Manual (PDF)
10. Package Contents
The following items are included in the package:
- Main machine: 1
- Stainless steel bowl: 1
- Bowl cover: 1
- Flat beater: 1
- Dough hook: 1
- Whisk: 1
- Instructions manual: 1
- Warranty card: 1
11. Product Demonstration Video
Watch this video for a visual guide on how to use your BioloMix Stand Mixer: