1. Safety Instructions
Warnings
- The body of the shaver can be cleaned with water only after being disconnected from the charging cable.
- Do not disassemble the body to replace the battery.
- Always hold the plug when plugging in or unplugging the charging cable. Never directly pull the cable.
- Do not charge this shaver for extended periods of time while leaving it unattended, and do not charge it longer than 24 hours.
- This shaver contains a built-in rechargeable battery, and should never be exposed to fire, nor charged, used, or stored in high-temperature environments.
- Do not place or insert any foreign objects into this shaver.
- Do not modify or repair this shaver yourself.
- Detach the hand-held part from the supply cord before cleaning it in water.
Precautions
- Immediately stop using the charging cable if it is damaged or working improperly.
- If the charging cable is damaged, it must be replaced with a genuine charging cable purchased from the manufacturer or after-sales service department.
- Keep this shaver out of reach of children.
- Make sure the charging port is dry when charging.
- Use a 5 V charger when charging.
- Fully charge the shaver at least once every six months, if it will not be used for an extended period of time.
Notes
- This shaver is intended for indoor use only.
- This shaver is intended for use by a single individual only.
- When traveling, make sure to install the protective cover and enable the travel lock to protect the shaver.
- It is recommended to charge, use, and store this shaver at temperatures between 5°C to 35°C.
- Do not wrap the charging cable around the shaver to avoid damage to the cable.
- This shaver is only suitable for facial hair, and is not recommended to be used to shave one's head or other parts of the body.
- This shaver meets the IPX7 standards for waterproofing and can be cleaned with water. However, it should not be immersed in water for an extended period of time.
- It is normal for water to drip through the gaps of the body when rinsing the shaver. However, this poses no danger since all electronic components are enclosed in an independent waterproof compartment inside the shaver. Standing it upright can help get rid of the water quickly.
- This shaver is not intended for use by people (including children) with reduced physical, sensory, or mental capabilities, or a lack of experience and knowledge, unless they are under the supervision of or have been given instructions concerning the use of the shaver by a person responsible for their safety.
2. Product Overview
Familiarize yourself with the components of your XIAOMI MIJIA S500 Electric Shaver.

Figure 2.1: Product Components
1. Protective Cover, 2. Shaving Head, 3. On/Off Button, 4. Body, 5. Indicators (Speed, Travel Lock, Clean/Error, Battery Level), 6. User Manual, 7. Cleaning Brush, 8. Info Card, 9. Charging Cable, 10. Charging Port (keep dry).
3. Setup: Charging Your Shaver
Before first use, or when the battery is low, charge your shaver using the provided Type-C charging cable and a USB-A adapter (5V charger recommended).
Charging Process:
- Ensure the charging port is completely dry before connecting the cable.
- Connect the Type-C end of the charging cable to the shaver's charging port.
- Connect the USB-A end to a compatible 5V USB-A power adapter.
- While charging, the battery level indicator on the shaver will blink slowly, and the number will increase.
- Once fully charged, the battery level indicator will display '100%' and stop blinking.

Figure 3.1: Connecting the Charging Cable

Figure 3.2: Shaver Charging
Note: The shaver supports plug-and-play, meaning you can use it while charging if the battery is low. However, never use the shaver in the shower when the charging port is wet during charging.
Battery Level Indication:
| Battery Level | Indicator Status |
|---|---|
| 100-5% (While Using) | On |
| <5% (While Using) | Blinking |
| 0% (While Using) | Unable to turn on |
| 0-100% (While Charging) | Blinking slowly |
| 100% (While Charging) | On |
4. Operating Instructions
How to Use:
It is normal for the skin to be slightly irritated after the first few shaves. It is recommended to regularly use the shaver (at least 3 times a week) for 3 weeks to allow the skin to adapt as quickly as possible.
- Turning On/Off: Press the button to turn the shaver on/off. Once on, the battery level indicator will display, and the clean/error, travel lock, and speed indicators will sequentially turn on and off. All indicators go off when the shaver is turned off.
- Switching Modes: When the shaver is on, press and hold the button for 1 second to switch between speed mode (speed indicator on) and standard mode (speed indicator off).
- Shaving Technique: Apply gentle pressure while shaving your face in circular motions. It is not necessary to repeatedly shave the same area for a clean shave. For optimal results, shave dry.

Figure 4.1: Recommended Shaving Motion

Figure 4.2: Dry Shaving

Figure 4.3: Wet Shaving with Foam
Important: Improper use can damage the shaving head and blades. Always check if the shaving head and blades are intact before use. Stop using immediately if damaged.
Travel Lock:
The shaver features a travel lock to prevent accidental activation during transport.
- Enabling Travel Lock: With the shaver off, press and hold the button for 3 seconds. The travel lock indicator will turn on for 3 seconds, then go off, confirming activation.
- Disabling Travel Lock: If the travel lock is enabled, pressing the button will cause the travel lock and battery level indicators to blink. To disable, press and hold the button for 3 seconds. The indicators will blink and go off, and the shaver will turn on.

Figure 4.4: Travel Lock Enabled
5. Maintenance: Cleaning & Care
Regular cleaning ensures optimal performance and extends the life of your shaver. The clean/error indicator will blink for 5 seconds after turning on, and every 30 minutes of use, to remind you to clean the stubble buildup.
- Preparation: Ensure the shaver is turned off and not charging before cleaning.
- Rinse Shaving Head: Rinse the shaving head under a faucet. Warm water is recommended.
- Remove Shaving Head: Gently remove the shaving head from the shaver body.
- Clean Stubble: Rinse away stubble buildup with water or use the cleaning brush to remove it.
- Clean Inside Shaving Head: Turn over the shaving head to clean its inside under a faucet. Use warm water. Do not use a towel or paper towel to wipe the head.
- Reinstall Shaving Head: Wipe away any excess water from the shaving head holder, and then reinstall the shaving head.
- Protect Charging Port: When cleaning the shaver, use the protective cover to cover the charging port. Ensure the charging port is dry before plugging in the cable to charge.

Figure 5.1: Rinsing the Shaving Head

Figure 5.2: Removing the Shaving Head

Figure 5.3: Cleaning Stubble from Shaving Head

Figure 5.4: Cleaning the Inside of the Shaving Head

Figure 5.5: Reinstalling the Shaving Head

Figure 5.6: Protecting the Charging Port
Recommendation: To maintain shaver performance, it is recommended to replace the shaving head every two years. Replacements can be purchased from www.mi.com.
6. Troubleshooting
Refer to the table below for common issues and their solutions.
| Issue | Possible Causes | Solution |
|---|---|---|
| Poor-quality shaving | Shaving head is damaged or worn out | Replace with a genuine shaving head |
| Shaving head is clogged up with stubbles | Thoroughly clean the shaving head | |
| Low or depleted battery | Connect the charging cable to charge | |
| The shaver does not work after pressing the button | On/off button does not function | Return the shaver to after-sales service for repair |
| Travel lock is enabled | Press and hold the button for 3 seconds to disable | |
| Indicator light is in error or does not light up | Low battery, needs to be charged | Charge the shaver |
| Circuit board is damaged | Return the shaver to after-sales service for repair | |
| Irritated skin after shaving | Shaving head is damaged or worn out | Replace with a genuine shaving head |
| It takes a certain period of time for your skin to adapt to the shaver | Skin irritation will fade after 2-3 weeks of use | |
| Unable to charge | Shaver is damaged | Return the shaver to after-sales service for repair |
| Ambient temperature is too low/high to charge | Charge in environments with a temperature between 5°C to 35°C | |
| The usage time is less than 60 minutes after being fully charged | The load on the motor is increased if the shaving head hasn't been cleaned for a long time | Thoroughly clean the shaving head |
| Shaver battery error | Return the shaver to after-sales service for repair | |
| Clean/error indicator blinks for 5 seconds after turning on the shaver | The load on the motor is increased if the shaving head hasn't been cleaned for a long time | Thoroughly clean the shaving head |
| Shaving head is not properly installed | Reinstall the shaving head or contact after-sales service |
7. Specifications
Key technical specifications for the XIAOMI MIJIA S500 Electric Shaver.
| Attribute | Value |
|---|---|
| Name | Mi Electric Shaver |
| Model | S500 |
| Rated Voltage | 3.7 V |
| Charging Port | Type-C |
| Rated Power | 3 W |
| Rated Input | 5 V ⎓ 1 A |
| IP Rating | IPX7 |
| Charging Time | Approx. 90 min |
| Usage Time | 65 Mins |
| Blade Material | Stainless Steel |
| Washing Mode | Whole body washing |
| Origin | Mainland China |
8. Environmental Protection & Battery Removal
When the shaver reaches the end of its service life, please remove, dispose of, or recycle the built-in battery in accordance with local laws and regulations.
Warning:
Do not expose this shaver or its battery to fire to prevent the battery from exploding or releasing toxic and hazardous substances.
Removing Battery:
Note: Make sure the battery is completely depleted before attempting removal. The following steps involve disassembling the shaver, and these parts cannot be restored once disassembled.
- Use a standard screwdriver to pry open the bottom and top covers, and remove the on/off button of the shaver.
- Use a Phillips-head screwdriver to remove the screws on the bottom and release the inner compartment.
- Use a Phillips-head screwdriver to remove the screws from the inner compartment, then use a standard screwdriver to pry open the inner compartment from the bottom. Cut off the contact plate on the battery and be careful not to short circuit the contact plate. Remove the battery and handle it appropriately.

Figure 8.1: Prying Bottom Cover

Figure 8.2: Prying Top Cover

Figure 8.3: Removing On/Off Button

Figure 8.4: Unscrewing Inner Compartment

Figure 8.5: Prying Inner Compartment

Figure 8.6: Cutting Contact Plate
9. Warranty & Support
As a Xiaomi consumer, you benefit from specific consumer warranty benefits in addition to any legal warranties provided by your national consumer law. For more information about warranty benefits, please refer to Xiaomi's official website: https://www.mi.com/en/service/warranty/.
The after-sales services are generally limited to the country or region of original purchase. For any service inquiries, please contact the relevant person as Xiaomi may identify, which could be a person in Xiaomi's authorized service network, authorized distributors, or the final vendor.
A detailed user manual in PDF format is also available for download: Download User Manual (PDF).
10. User Tips
- For a more comfortable shave and to reduce irritation, especially in sensitive areas like the neck, consider using shaving foam or gel.
- Allow your skin an adaptation period of 2-3 weeks when first using the electric shaver. Initial irritation is common but typically subsides with regular use.
- To maintain optimal shaving performance, it is recommended to replace the shaving heads approximately every two years.
- The shaver's battery life is efficient, often lasting for several shaves on a single charge.
- A travel case can be a useful accessory for protecting your shaver when on the go.
11. Frequently Asked Questions (FAQ)
- Q: What type of cleaning does the shaver support?
- A: It supports both wet and dry shaving.
- Q: What are some distinctive features of the XIAOMI MIJIA S500 Electric Shaver?
- A: Some distinctive features include a trimmer for men, fast charging, and a floating head design.
- Q: How many heads does it have?
- A: It has triple blade heads.
- Q: What is the power mode of this shaver?
- A: It is a rechargeable electric shaver.
- Q: Under which category terms does it fall?
- A: It falls under the category of electric shavers and razors for men.