Introduction
The Wofea WG-088 Smart Garage Door Controller allows you to remotely control and monitor your garage door using your smartphone, voice commands via Amazon Alexa or Google Assistant, and set up automated schedules. This manual provides detailed instructions for installation, operation, and troubleshooting to ensure optimal performance of your device.
Figure 1: Wofea Smart Garage Controller overview with app and voice assistant compatibility.
1. Setup and Installation
1.1 Compatibility Test
Before proceeding with installation, it is crucial to test if your garage door opener is compatible with the Wofea WG-088 controller.
- Take a wire with both ends stripped or a straightened-out paper clip.
- Short-circuit the wall button terminal on your garage door opener. These terminals are typically where your existing wall button wires connect.
- If the garage door opens or closes when short-circuited, your opener is compatible with the smart controller.
Figure 2: Compatibility test for garage door opener.
1.2 Package Contents
Please check that all items are present in your package:
- Wofea WG-088 Smart Garage Door Controller
- Wired Door Sensor (with cable)
- Red & Black Signal Wires
- Mounting Screws, Brackets, or 3M Adhesive Gums (may vary)
- Power Adapter (EU, AU, US, or UK plug type depending on selection)
Figure 3: Example of EU plug version of the controller and sensor.
1.3 Pre-installation Checklist
- Your smartphone or tablet must be connected to a 2.4GHz Wi-Fi network with internet access.
- The device only supports 2.4GHz Wi-Fi. If your router broadcasts both 2.4GHz and 5GHz, ensure your smartphone is connected to the 2.4GHz network during setup.
- Download the