Introduction
This manual provides essential information for the setup, operation, maintenance, and troubleshooting of your FMS FCX24M 1/24 Land Rover Discovery Camel Trophy Ready-to-Run (RTR) RC car. Please read this manual thoroughly before operating your vehicle to ensure safe and optimal performance. This highly detailed 1/24 scale model is designed for enthusiasts seeking a realistic off-road experience with its hard body, functional lights, and extensive decor kit.
What's in the Box
Your FMS FCX24M package includes the following components:
- FMS 1:24 Land Rover Discovery Camel Trophy RC Car (Fully Assembled)
- Remote Control Transmitter
- 3 × Roof Luggage Bags (color may vary)
- 2 × Flat Tow Ropes (color may vary)
- 2 × Tool Ropes (color may vary)
- 1 × Winch Rope (color may vary)
- 1 × Suede Blanket Roll (color may vary)
- 4 × Fuel Cans (color may vary)
- 1 × Fire Extinguisher (color may vary)
- Full Set of Stickers
Note: Battery and Charger are NOT included and must be purchased separately.

Setup Instructions
As an RTR (Ready-to-Run) model, your FMS FCX24M requires minimal setup before its first use.
- Install Vehicle Battery: Open the battery compartment on the RC car. Carefully connect your compatible 2S LiPo battery (not included) to the ESC/receiver unit. Secure the battery in the compartment.
- Install Transmitter Batteries: Insert the required batteries (typically AA, refer to transmitter manual) into your remote control transmitter.
- Power On: First, turn on the remote control transmitter. Then, turn on the RC car. The car and transmitter should automatically bind. If not, refer to the transmitter's specific binding instructions.
- Attach Accessories: Your model comes with a detailed decor kit. You can attach the roof luggage bags, fuel cans, fire extinguisher, and apply the included stickers to customize your Land Rover Discovery. The roof rack, lights, and ladder are pre-installed.
- Initial Check: Before driving, gently test the steering and throttle response. Ensure all functions operate correctly.

Operating Instructions
Familiarize yourself with the remote control functions before operating the vehicle.
- Throttle Control: Use the trigger on the transmitter to control forward and reverse movement. Pull the trigger to accelerate forward, push it away from you to brake or reverse.
- Steering Control: Use the steering wheel on the transmitter to turn the vehicle left or right.
- Lights: The model features functional lights. Consult your transmitter's manual for specific controls to turn the headlights, taillights, or auxiliary lights on/off, if applicable.
- Driving Environment: Operate your RC car in open areas free from obstacles, people, and pets. Avoid wet conditions or extreme temperatures.
- Battery Life: Monitor your battery life. When the vehicle's speed or responsiveness decreases significantly, it's time to recharge the battery.

Maintenance
Regular maintenance will extend the life and performance of your RC car.
- Cleaning: After each use, especially after off-road driving, clean the vehicle to remove dirt, dust, and debris. Use a soft brush or compressed air. Avoid using water directly on electronics.
- Inspections: Periodically check all screws, nuts, and bolts for tightness. Inspect tires for wear and tear. Ensure all electrical connections are secure.
- Lubrication: Apply appropriate RC-specific lubricant to moving parts like gears and bearings as needed.
- Battery Care: Always disconnect the battery from the vehicle when not in use. Store batteries in a cool, dry place. Follow the manufacturer's instructions for charging and discharging LiPo batteries.
- Storage: Store the RC car in a dry, cool environment away from direct sunlight and extreme temperatures.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Vehicle does not respond | Low battery in car or transmitter; Not bound; Power switch off | Charge/replace batteries; Re-bind transmitter and receiver; Ensure power switches are ON |
| Poor steering response | Damaged servo; Loose steering linkage; Low battery | Inspect/replace servo; Check and tighten linkages; Charge car battery |
| Motor not running | Loose motor wires; Damaged motor/ESC; Overheat protection | Check motor connections; Allow components to cool; Consult for replacement if damaged |
| Short run time | Battery not fully charged; Old/damaged battery | Ensure battery is fully charged; Consider replacing the battery |
Specifications
| Feature | Detail |
|---|---|
| Model | FCX24M |
| Scale | 1/24 |
| Vehicle Type | RC Car (Crawler) |
| Length | 25 cm |
| Width | 15 cm |
| Height | 15 cm |
| Weight | 1.5 kg |
| Recommended Age | 14+ years |
| Origin | Mainland China |
| Power Source | 2S LiPo (Not Included) |
User Tips
- Battery Safety: Always use a LiPo-compatible charger and follow all safety guidelines when charging and handling LiPo batteries. Never leave charging batteries unattended.
- Customization: The included stickers and accessories allow for personal customization. Take your time to apply them for the best aesthetic result.
- Off-Road Capability: While designed for off-road, avoid excessively deep water or mud to protect the electronics.
- Spare Parts: Keep a few common spare parts on hand, such as extra batteries, small screws, and perhaps a spare servo, especially if you plan on frequent or aggressive use.
Warranty and Support
For any issues or questions regarding your FMS FCX24M RC car, please contact the seller or manufacturer's customer support. Keep your purchase receipt as proof of purchase for any warranty claims. Specific warranty terms and conditions may apply.