Introduction
This manual provides essential information for the safe and effective use of your Panasonic CLB937 rechargeable battery. The CLB937 is a 3.7V lithium-ion battery designed for specific Seiko watch calibers and models, including 8X82, 8X53, 8X82-0AF0, 8X82-0AS0-1, 8X53-0AB0, SSE022J, and SSE075J.
Please read this manual thoroughly before installation and use, and keep it for future reference.
Safety Information
WARNING: THIS PRODUCT CONTAINS A BUTTON BATTERY.
- If swallowed, a lithium button battery can cause severe or fatal injuries within 2 hours.
- Keep batteries out of reach of children.
- If you suspect a battery has been swallowed or placed inside any part of the body, seek immediate medical attention.
- Swallowing can lead to chemical burns, perforation of soft tissue, and death. Severe burns can occur within 2 hours of ingestion.
General Battery Safety Precautions:
- Do not heat the battery or place it in fire; there is a risk of explosion.
- Do not allow the battery to get wet or immerse it in water.
- Do not allow metal objects such as keys, coins, or necklaces to contact the battery terminals to prevent short circuits.
- Store the battery in a dry, low-temperature area. Avoid storing or using it in high-temperature environments.
- Do not store the battery in environments above 60°C (140°F) or below -20°C (-4°F).
- Do not apply external force to the battery or drop it from a height.
- Do not use inferior chargers, as this can lead to undercharging or damage to the battery.
- Do not store the battery for a long time after it is fully charged.
Specifications
| Attribute | Value |
|---|---|
| Model Number | CLB937 |
| Brand Name | Panasonic |
| Nominal Voltage | 3.7V |
| Nominal Capacity | 18mAh |
| Size | 9.5mm x 3.9mm |
| Origin | Japan (Jp) |
| High-concerned chemical | none |
Note: This battery is designed to meet the safety requirements of BS EN IEC 60086-4 for lithium batteries.
Setup and Installation
Installing the CLB937 battery requires careful handling to avoid damage to the battery or the watch. If you lack experience in battery installation, it is highly recommended to seek assistance from a qualified repair technician to prevent potential losses or damage.
Installation Steps:
- Open Package: Carefully open the battery packaging.
- Take Out Battery: Gently remove the battery from its packaging.
- Avoid Short Circuit: Due to the human body's conductivity, when installing the new battery, avoid your fingers simultaneously touching both the positive and negative terminals. This can cause discharge, leading to power loss and affecting the battery's service life.
- Correct Method: Handle the battery by its edges to prevent accidental short-circuiting.
Operating Instructions
First Use of a New Battery:
All light kinetic energy batteries are new and are initially drained when they leave the factory. For the first use of a new battery:
- Do not completely drain any remaining factory-provided charge.
- Charge the battery for 6-8 hours immediately after installation.
- Be careful not to overcharge, as this can damage the lithium-ion cell and affect its service life.
- After 2-3 charge-discharge cycles, the cell will be fully activated and enter its optimal state.
- Thereafter, simply charge it fully each time.
- The light kinetic energy battery can be charged by placing the watch near a light source.
Maintenance
Proper care and maintenance will extend the life of your CLB937 battery:
- Use only original or reliable chargers. Inferior chargers can affect standby time and shorten battery life, and in extreme cases, an improper charge can destroy the battery.
- Avoid charging the battery for excessively long periods. Generally, charging for about 1 hour after it's full will yield the best results.
- Keep the battery clean and dry.
- Store the battery in a cool, dry place when not in use for extended periods.
Troubleshooting
If you encounter issues with your CLB937 battery, consider the following:
- Watch not powering on: Ensure the battery is correctly installed with proper polarity. If it's a new battery, ensure it has been charged for the recommended 6-8 hours.
- Short battery life: This could be due to improper initial charging (not following the 2-3 cycle activation), using an inferior charger, or storing the battery in extreme temperatures. Ensure you are using a reliable charger and storing the battery correctly.
- Battery not charging: Verify the watch's charging mechanism (e.g., light source for kinetic energy watches) is functioning correctly. Ensure the battery terminals are clean and making good contact.
- Physical damage: If the battery appears swollen, leaking, or damaged, discontinue use immediately and dispose of it safely according to local regulations. Do not attempt to charge or use a damaged battery.
For persistent issues, consult a professional watch repair technician.
User Tips
- Always handle the battery with clean, dry hands or non-conductive tools to prevent accidental short circuits.
- When replacing the battery, take a photo of the original battery's orientation before removal to ensure correct installation of the new one.
- For kinetic watches, regular exposure to light is crucial for maintaining the battery's charge and overall health. Avoid leaving the watch in darkness for extended periods.
- If storing the watch for a long time, ensure the battery has a partial charge (around 50%) rather than being fully charged or completely drained.
Warranty and Support
For information regarding warranty coverage or technical support for your Panasonic CLB937 battery, please refer to the seller's policies or contact Panasonic customer service directly. Keep your purchase receipt as proof of purchase.
For additional documentation, you may refer to the official PDF document: User manual (PDF).