Philips TAR2808

Contents

Philips TAR2808 Portable Radio

User Manual

1. Introduction

Thank you for choosing the Philips TAR2808 Portable Radio. This device is a versatile FM/MW dual-band radio featuring MP3 playback from TF cards, an emergency alarm, and a built-in flashlight. Designed for ease of use, it includes humanized digital buttons for direct access to radio stations and tracks, a clear LCD display, and a 3.5mm headphone jack for private listening. This manual provides essential information for safe and effective use of your radio.

2. Important Safety Information

Please read and understand all instructions before using this product. Damage caused by failure to follow instructions is not covered by warranty.

2.1. Caution for Injury or Product Damage

  • Never expose this product and its accessories to rain or water. Do not place liquid containers (e.g., vases) near the product. If liquid spills onto or into the product, immediately remove the battery or disconnect the power. Contact customer service for inspection before further use.
  • Never place this product and its accessories near open flames or other heat sources, including direct sunlight.
  • Unplug the power adapter before a lightning storm.
  • Do not strike the frequency indicator window with hard objects to avoid damage.
  • Do not insert objects into the ventilation slots or other openings of this product.
  • Batteries (installed battery pack or separate batteries) must not be exposed to excessive heat such as sunlight or fire.
  • Do not place this product or any objects on top of other electronic devices.
  • If this product has been transported at temperatures below 5°C, unpack it and wait for it to reach room temperature before inserting the battery or connecting power.

2.2. Caution for Overheating

  • Refer to the model plate on the back or bottom of the product for identification and power information.
  • Do not install this product in an enclosed space. Always leave at least 10cm/4 inches of space around the product for ventilation. Ensure that curtains or other objects do not block the ventilation slots on the product.

2.3. Caution for Pollution and Battery Disposal

  • Do not mix batteries (e.g., old batteries with new batteries, or carbon batteries with alkaline batteries).
  • Incorrect battery installation carries a risk of explosion; replace only with the same or equivalent type.
  • Batteries contain chemicals and should be disposed of properly.

2.4. Danger of Swallowing Batteries

  • Never swallow batteries, as this may cause chemical burns!
  • If you accidentally swallow a battery or if a battery enters your body in any other way, seek immediate medical attention.
  • New and used batteries should be kept away from children. If the battery compartment cannot be closed securely, stop using the product. Always keep it out of reach of children and contact the manufacturer.

3. Package Contents

Please check that the following items are included in your package:

  • Philips TAR2808 Portable Radio x1
  • User Manual x1
  • Lanyard x1
  • Type-C Charging Cable x1
  • Warranty Card x1

4. Product Overview

Familiarize yourself with the various parts and controls of your Philips TAR2808 radio.

Front view of the Philips TAR2808 Portable Radio

Figure 1: Front view of the Philips TAR2808 Portable Radio

4.1. Controls and Features

  1. Flashlight: Integrated light source.
  2. Telescopic Antenna: Extend for optimal radio reception.
  3. Headphone Jack (3.5mm): Connect headphones for private listening.
  4. Volume Knob: Rotate to adjust the audio volume.
  5. Play/Pause Button (►II): Short press to pause playback, press again to resume.
  6. Tune Down / Previous Track Button (◀◀): In FM mode, short press for previous station, long press for automatic station search downwards. In TF mode, short press for previous track, long press for fast rewind.
  7. Tune Up / Next Track Button (►►): In FM mode, short press for next station, long press for automatic station search upwards. In TF mode, short press for next track, long press for fast forward.
  8. 0-9 Number Buttons: Used for direct input of radio frequencies or track numbers.
  9. Function Switch Button (▯/M): Long press to power the device on or off. Short press to switch between functions (e.g., FM radio, TF card playback).
  10. Flashlight / SOS Alarm Button (TORCH / SOS): Short press to turn the flashlight on or off. Long press to activate the emergency alarm mode (SOS).
  11. LCD Display Window: Shows frequency, track information, battery level, and other status indicators.
  12. Hand Strap Buckle: Attachment point for the included lanyard.
  13. Support Stand: Foldable stand at the back for desktop placement.
  14. TF Card Slot: Insert a TF (MicroSD) card for MP3/WMA audio playback.
  15. DC5V Power Jack: Connect the Type-C charging cable for power and charging.

4.2. LCD Display Indicators

LCD display showing frequency and battery indicator

Figure 2: LCD display showing frequency and battery indicator

  1. FM Radio Display: Indicates when FM radio mode is active.
  2. TF Card Playback Display: Indicates when TF card playback mode is active.
  3. Battery Level Display: Shows the current battery charge level.
  4. Play/Pause Display: Indicates playback status (playing or paused).
  5. 8888 Playback Track & Time Display:
    • Displays track number for 3 seconds when switching tracks.
    • Displays playback time during track playback.
    • Displays the current frequency when receiving a radio station.
  6. MHz Frequency Unit Display: Indicates the unit for radio frequency.

5. Setup and Charging

5.1. Power On/Off

To power on the radio, long press the Function Switch Button (▯/M) (9). The LCD display will light up. To power off, long press the same button again. The LCD display will turn off.

If the device will not be used for an extended period, ensure it is powered off.

5.2. Charging the Battery

Radio charging with battery indicator

Figure 3: Radio charging with battery indicator

When the battery level is low, the battery symbol on the LCD display will show an empty icon. Please charge the device promptly.

  1. Connect the included Type-C charging cable to the DC5V Power Jack (15) on the radio and to a compatible USB power source (e.g., a USB wall adapter, computer USB port).
  2. Charging will start automatically. The battery symbol on the LCD display will flash.
  3. Once fully charged, the battery symbol will become solid.

The radio can be charged even when it is powered off.

Important Notes on Power:

  • To completely disconnect power from the device, unplug the power cable from the wall outlet.
  • Always hold the plug, not the cable, when disconnecting the power cord.
  • Never touch the power plug with wet hands to avoid fire or electric shock.
  • Ensure the power cord is securely placed and avoid bending, twisting, or stepping on it, especially the part from the power outlet to the device.
  • Do not overload power sockets by plugging in too many devices simultaneously. Do not arbitrarily extend the power cord. Overloading sockets can lead to fire or electric shock.
  • If using a power adapter, ensure it is CCC certified and meets standard requirements.

6. Operation

6.1. Using the Radio (FM/MW)

Radio with extended antenna showing FM dual antenna reception

Figure 4: Radio with extended antenna showing FM dual antenna reception

  1. Switching to Radio Mode: Short press the Function Switch Button (▯/M) (9) until the LCD display shows the FM frequency.
  2. Antenna Usage: Extend the Telescopic Antenna (2) for the best reception. Adjust the radio's orientation if needed.
  3. Station Selection (Manual): Short press the Tune Down (6) or Tune Up (7) buttons to select the previous or next station.
  4. Automatic Station Search: In radio mode, long press the Play/Pause Button (►II) (5) to initiate a full automatic search. The LCD will display frequencies (e.g., from 87.5 to 108MHz). When a station is found, the system will automatically store it for 1 second before continuing the search. After the search is complete, the first found station will play. Use the Tune Down (6) or Tune Up (7) buttons to select stored stations. Alternatively, long press the Tune Down (6) or Tune Up (7) buttons to automatically search forward or backward, and the radio will play the first station it finds.
  5. Digital Station Search: In radio mode, use the 0-9 Number Buttons (8) to directly input a station frequency. For example, to listen to 97.8MHz, press "9", "7", "8", then press the Play/Pause Button (►II) (5) to confirm. If no operation is performed for 3 seconds, the system will automatically play the entered frequency.
  6. Adjusting Volume: Rotate the Volume Knob (4) to adjust the sound level.
  7. Mute Function: Short press the Play/Pause Button (►II) (5) to mute the sound. Press it again to resume playback.

6.2. TF Card Playback

Radio showing TF card slot and MP3 playback

Figure 5: Radio showing TF card slot and MP3 playback

  1. Inserting TF Card: Insert a TF (MicroSD) card containing MP3/WMA audio files into the TF Card Slot (14).
  2. Switching to TF Mode: Short press the Function Switch Button (▯/M) (9) to switch to TF card playback mode. The LCD screen will display the track number (for 3 seconds), then the playback time.
  3. Track Selection: Use the Tune Down (6) or Tune Up (7) buttons for the previous or next track. Long press these buttons for fast rewind or fast forward.
  4. Direct Track Selection: Use the 0-9 Number Buttons (8) to select a specific track number. For example, to play track 25, press "2", "5", then press the Play/Pause Button (►II) (5) to confirm. If no operation is performed for 2 seconds, the system will automatically play the selected track.
  5. Pause/Resume: Press the Play/Pause Button (►II) (5) to pause the current playback. Press it again to resume.
  6. Adjusting Volume: Rotate the Volume Knob (4) to adjust the sound level.

Note for PC Connection:

To read TF card data on a computer, power on the radio, insert the TF card into the slot, and connect the radio to your computer using a USB data cable. The system will restart and enter TF card data reading mode.

6.3. Other Functions

  1. Flashlight Usage: Short press the Flashlight / SOS Alarm Button (10) to turn the flashlight on. Short press it again to turn it off.
  2. Emergency Alarm Function (SOS): Long press the Flashlight / SOS Alarm Button (10) to activate the alarm sound and make the flashlight flash. Short press the button again to turn off the alarm sound.
  3. Headphone Usage: To avoid disturbing others, you can use headphones. Plug your headphones into the Headphone Jack (3) (3.5mm). The radio's built-in speaker will automatically mute, and audio will be routed to the headphones.

7. Care and Maintenance

  • Cleaning: When performing maintenance, clean this product with a microfiber cleaning cloth. Do not use any lubricants, alcohol, or other volatile liquids.
  • Mechanical Parts: The mechanical parts of this unit are adequately lubricated at the factory.
  • General Care: Do not drop the device. Keep it moisture-proof. Turn off the device when not in use. Charge regularly to maintain battery health.

8. Troubleshooting

If you encounter any issues with your Philips TAR2808 radio, please refer to the following common problems and solutions:

  • Unable to receive stations: Extend the antenna fully, try changing the frequency band (if applicable), and slowly turn the tuning knob to find a clear signal.
  • High noise during reception: Keep the radio away from potential sources of electromagnetic interference such as mobile phones, Wi-Fi routers, or chargers.
  • Low volume: Increase the volume using the Volume Knob (4). Check the battery level and charge the device if necessary. If using headphones, test with a different pair to rule out headphone issues.
  • Device not turning on: Ensure the battery is charged. Long press the Function Switch Button (▯/M) (9) to power on.

9. Specifications

Design and specifications are subject to change without prior notice.

Table of product parameters

Figure 6: Product parameters table

FeatureSpecification
Brand NamePhilips
ModelTAR2808
Body MaterialPlastic
StylePortable
TypeFM, MW
FunctionBuilt-In Speaker, Emergency Alarm, Flashlight, MP3 Playback
ScreenYes (LCD Display)
Power Supply / SourceRechargeable Battery Pack (Built-in lithium battery 3.7V)
Battery IncludedYes
Charging Input5V-1.5A (Type-C)
Rated Power3W
Output PowerSpeaker: 2W, Earphones: 12mW
HornInternal magnet 3W
Frequency Range (FM)87.5-108MHz
Noise-limited Sensitivity (FM)S/N=30dB better than 6uV
Selective Frequency Modulation (FM)>60dB
Supported Audio FormatsMP3/WMA
Headphone Jack3.5mm
Dimensions (WxHxD)Approx. 145*58*41mm
WeightApprox. 197g
CertificationCE
OriginMainland China

Warning: This device contains a built-in lithium battery. Do not attempt to disassemble it yourself.

10. User Tips

  • For optimal FM reception, always extend the telescopic antenna and try adjusting the radio's position.
  • If you experience static or poor signal, move away from electronic devices that might cause interference.
  • Remember to turn off the radio when not in use to conserve battery life.
  • Regular charging helps maintain the longevity of the built-in lithium battery.

11. Warranty and Support

For more online support, including downloading the user manual, quick start guides, video tutorials (for selected models), and FAQs, please visit the official Philips support website:

www.philips.com/support

Follow the instructions on the website to select your language and enter your product model. If you have any questions, please contact your local after-sales service center. Before contacting, please note down your product model and serial number, which can be found on the back or bottom of the product.

A detailed user manual in PDF format is also available for download: Philips TAR2808 User Manual (PDF)

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.