1. Introduction
This manual provides essential information for the safe and efficient use of your 500x100cm Round Inflatable Pool. Please read all instructions carefully before setting up and using the pool. Proper setup, operation, and maintenance will ensure a long lifespan for your product and a safe, enjoyable experience for all users.
2. Safety Information
- Adult Supervision Required: Always supervise children and non-swimmers when the pool is in use.
- Level Surface: Ensure the pool is set up on a completely flat and level surface to prevent structural damage and water spillage.
- Clear Area: Keep the area around the pool clear of obstacles and sharp objects.
- Electrical Safety: If using an external pump or filter system, ensure all electrical connections are waterproof and comply with local safety standards. Never operate electrical devices near the pool with wet hands.
- Chemicals: Handle pool chemicals (if used) according to manufacturer instructions. Keep them out of reach of children.
- No Diving: This is an inflatable pool; never dive or jump into it.
- Empty When Not in Use: For safety, especially with young children, consider emptying the pool when not in use for extended periods.
3. Package Contents
Upon unpacking, please ensure all components are present and undamaged:
- 1 x Round Inflatable Pool (500x100cm)
- Repair patch kit (may be included)
- Instruction Manual
Note: External pump/filter systems are typically sold separately.
4. Setup Instructions
- Choose a Location: Select a flat, level, and stable surface for your pool. Ensure there are no sharp objects, rocks, or debris that could puncture the pool. The area should be large enough to accommodate the 500x100cm pool and provide adequate space around it for safe entry and exit.
- Unfold the Pool: Carefully remove the pool from its packaging and unfold it in your chosen location. Spread it out completely, ensuring the bottom is flat and wrinkle-free.
- Inflate the Pool: Locate the inflation valves. Using an air pump (not included), inflate the pool sections one by one until they are firm to the touch but not overinflated. Do not use a high-pressure air compressor. Close all valves securely after inflation.

Figure 4.1: Fully inflated round inflatable pool, ready for water.
- Connect Pump/Filter (Optional): If you are using an external pump and filter system, connect it to the designated inlet and outlet ports on the pool wall according to the pump manufacturer's instructions. Ensure all connections are tight to prevent leaks.

Figure 4.2: Inflatable pool set up outdoors with an external pump/filter system connected.
- Fill with Water: Begin filling the pool with water. As the water level rises, smooth out any remaining wrinkles on the bottom of the pool. Fill to the recommended water line, typically indicated on the pool wall or in the pump manual. Do not overfill.

Figure 4.3: The inflatable pool filled with water in an outdoor setting.
- Final Check: Inspect the entire pool for any leaks or signs of damage. Ensure all valves are closed and any pump connections are secure.
5. Operating the Pool
- Entry and Exit: Use the reinforced handles on the side of the pool for assistance when entering or exiting, if available.

Figure 5.1: Detail of a reinforced handle on the pool's exterior for stability.
- Water Depth: The pool has a depth of 100cm. Be aware of the water depth, especially for children and non-swimmers.

Figure 5.2: A person standing inside the pool, illustrating its considerable depth and size.
- Pump/Filter Operation: If using a pump/filter, operate it according to its specific instructions to maintain water clarity and hygiene.
- Water Temperature: Monitor water temperature, especially during hot weather, to prevent overheating.
6. Maintenance
- Cleaning: Regularly clean the pool walls and bottom using a soft brush or cloth and mild soap. Rinse thoroughly.
- Water Treatment: Use appropriate pool chemicals (e.g., chlorine, algaecide) as needed to maintain water quality. Test water regularly with a pool test kit.
- Filter Cleaning/Replacement: If using a filter pump, clean or replace the filter cartridge as recommended by the pump manufacturer.
- Patching Leaks: In case of a small puncture, use the provided repair patch kit. Clean and dry the area around the leak, apply the patch firmly, and allow it to cure completely before refilling the pool.
- Draining: To drain the pool, locate the drain plug (if present) or use a submersible pump. Ensure the water drains to an appropriate area, away from electrical outlets or sensitive landscaping.
- Storage: After draining, thoroughly clean and dry the pool. Deflate it completely and fold it neatly. Store in a cool, dry place away from direct sunlight and pests.
7. Troubleshooting
- Pool losing air: Check all inflation valves to ensure they are securely closed. Inspect the pool surface for punctures. Use soapy water to identify small leaks by looking for bubbles. Patch any identified leaks.
- Water not clear: Ensure your pump/filter system is running for adequate periods daily. Clean or replace the filter cartridge. Test water chemistry and adjust chemicals (e.g., chlorine, pH) as needed. Shock treatment may be required.
- Pool leaning to one side: This indicates the ground is not perfectly level. Drain the pool, relocate it to a truly flat surface, or level the existing surface before refilling.
- Pump not working: Check power connections. Ensure the pump is primed (if applicable) and the filter is not clogged. Refer to your pump's specific manual for troubleshooting.
8. Specifications
| Feature | Detail |
|---|---|
| Model | Round Inflatable Pool 500x100cm |
| Type | Pool |
| Material | PVC |
| Color | White (exterior), Blue (interior) |
| Size (Diameter x Height) | 500cm x 100cm |
| Applicable Age | Above 13 years |
| Applicable People | Universal, Adults, Man |
| Application | Outdoors, at home, at the gym, indoors and outdoors |
| High-concerned chemical | none |
| Origin | Mainland China, Guangdong, China |
| Package Dimensions (L x W x H) | 69cm x 69cm x 69cm |
| Package Weight | 41.0 kg |
9. User Tips
- Ground Cover: Place a ground cloth or tarp under the pool before inflation to protect the bottom from punctures and provide extra insulation.
- Inflation: For easier inflation, use an electric air pump. Avoid over-inflating, especially on hot days, as the air inside will expand.
- Water Quality: Invest in a good quality pump and filter system, and regularly test your water. This will significantly reduce the need for frequent water changes and keep your pool hygienic.
- Covering the Pool: Use a pool cover when the pool is not in use to keep out debris, reduce water evaporation, and maintain water temperature.
- Winter Storage: If storing for winter, ensure the pool is completely dry to prevent mold and mildew. Store it in a rodent-free area.
10. Warranty and Support
For any product-related inquiries, technical support, or warranty claims, please contact the seller or retailer from whom you purchased this product. Keep your proof of purchase for warranty validation.