1. Safety Information
Please mind potential fire risk and strictly follow the instruction manual for charging and storage. While using the product, please wear protective equipment and fully comply with the applicable law and regulations.
General Safety Warnings:
- The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
- Children being supervised not to play with the appliance.
- Always wear appropriate safety gear, including a helmet, when riding the scooter, especially at higher speeds.
2. Product Overview
The IScooter W12 is an 11-inch off-road dual-drive electric scooter designed for powerful performance and versatile riding. Below is a diagram illustrating its main components.

Component List:
- Display
- Brake Levers
- Control Pad
- Throttle
- Hook
- Folding Mechanism
- Headlight with Horn
- Fenders
- Suspensions
- Spot Lights (2 Sides)
- Kickstand
- Charging Port
- Footrest
- Taillight & Brake Light
- Deck Lights (2 Sides)
3. Package Contents
Ensure all the following items are included in your package:

- Scooter (1)
- Rear Fender (1)
- Tool (6 Y-Shaped Square Wrench)
- Charger (1)
- User Manual + Safety Instructions (1)
4. Quick Setup
The IScooter W12 is designed for one-click assembly. Follow these steps to get your scooter ready for use.

Assembly Steps:
- Unfold the Scooter: Carefully lift the handlebar stem until it locks into place.
- Attach the Handlebar: Secure the handlebar to the stem using the provided clamp and screws. Ensure all cables are properly connected and not pinched.
- Install the Rear Fender: Attach the rear fender to the scooter frame using the designated screws.
- Final Checks: Ensure all connections are secure and the scooter is stable before first use.
5. Operating Instructions
5.1. Power On/Off
- To Power On: Press and hold the Power button on the control pad.
- To Power Off: Press and hold the Power button again.
- P (Park) Mode: The scooter defaults to P mode when turned on. It will also automatically enter P Mode after being stationary for about 1 minute without controls activated.
- Exit P Mode: Gently squeeze either brake lever, press the "+" or "-" button, or push the scooter to about 2 km/h.
5.2. Display Functions

The display provides real-time information about your ride:
- Turn Signals
- Brake Applied
- Scooter Locked
- Headlight on
- App Connected
- Cruise Control Mode
- Riding Modes
- Dual: Dual-Motor Mode / Single: Single-Motor Mode
- ODO: Total Distance / TRIP: Trip Distance
- Battery Level & Voltage
- Real-time Speed
- MAX: Maximum Speed / AVG: Average Speed / Error: Error Prompt
Note: The display will alternately show ODO/Trip and Max/AVG readings.
5.3. Control Pad Functions

- Horn Switch: Activates the horn.
- Light Switch: Turns the headlight, taillight, all four spot lights, and deck lights (LED strip lights) on/off simultaneously.
- Power Button: Turns the scooter on/off.
- "M" Button: Selects between Dual (Dual-Motor mode) or Single (Single-Motor mode).
- "+" / "-" Buttons: Switches riding modes (speed levels).
- Turn Signal Switch: Activates the turn signals.
5.4. Riding Modes and Speed Levels

The scooter offers multiple speed levels to suit different riding needs. Use the "+" or "-" buttons to switch between them.
| Drive Mode | Initial Speed | Single Transmission Shift Speed | Dual Transmission Shift Speed |
|---|---|---|---|
| Eco mode | 10 km/h | 25 km/h | 40 km/h |
| S mode | 15 km/h | 40 km/h | 50 km/h |
| T mode | 25 km/h | 50 km/h | 70 km/h |
Cruise Control: When cruise control is on, its icon will flash on the screen. If the scooter moves at a certain constant speed for about 6 seconds, it will maintain this speed without pulling the throttle trigger, and the icon will become solid.
5.5. Lighting System

The scooter is equipped with a high-brightness intelligent lighting system for visibility and safety. Use the Light button on the control pad to operate all lights simultaneously.
5.6. App Connection (Voltix App)

Download the "Voltix" App to connect to your scooter for advanced controls and real-time status monitoring. The app allows you to change speed modes, view battery level, mileage, speed, and receive fault alerts.
Scan the QR code to download the Voltix App:

5.7. Folding Operations

To fold the scooter for storage or transport:
- Loosen the folding mechanism knob.
- Pull the lever to release the stem.
- Fold the handlebar stem down towards the deck until it locks into place.
- Ensure the folding latch is securely engaged.
6. Charging Operation

- The scooter is fully charged when the charger indicator changes from red to green.
- With charging protection, the scooter will cut off charging automatically after a full charge. We still don't recommend overcharging it.
- Keep the charging port cover closed when not charging.
- During charging, the scooter cannot be turned on.
- Charging Time: 8-9 hours.
7. Maintenance
7.1. Disc Brake Adjustment

To adjust the brake cable:
- You need a hex wrench to loosen the bolt on the cable clamp (Red Head in diagram).
- If the disc brake is dragging, slide the arm of the clamp backward along the cable while holding the cable in one hand. Then, retighten the bolt on the brake clamp.
- If the disc brake does not work efficiently, the cable is slack. You need to slide the arm of the clamp forward along the cable while holding the cable in one hand. Then, retighten the bolt on the brake cable clamp.
To eliminate brake noise:
- Loosen the two brake caliper mounting bolts (Blue Heads in diagram, not the bolt on the cable clamp).
- Reposition the brake caliper to ensure the brake rotor is centered between the brake pads.
- Retighten the mounting bolts.
8. Troubleshooting (Error Codes)
If you see any error code listed on the display, please contact our support team to remove it.
| Code | Definition |
|---|---|
| E10 | Communication Fault |
| E14 | Throttle Fault |
| E15 | Brake Lever Fault |
| E16 | Motor Hall Sensor Fault |
| E50 | Over-voltage |
9. Specifications
| Feature | Specification |
|---|---|
| Model | W12 |
| Unfolded Size | 131.5 x 63 x 140 cm (51.8 x 24.8 x 55.1 in) |
| Folded Size | 131.5 x 63 x 65 cm (51.8 x 24.8 x 25.6 in) |
| Weight | 37.8 kg (83.3 lbs) |
| Battery Capacity | DC 52 V, 25 Ah |
| Motor Power | 2 x 1500W |
| Wheel Diameter | 11 in. |
| Range | 100 km (62 miles) |
| Max Load Capacity | 150 kg (330 lbs) |
| Recommended Age | 14+ |
| Operating Temperature | -2°C-35°C (28.4°F-95°F) |
| Charger Input & Output | AC 100-240 V, 50/60 Hz; DC 58.8 V, 3 A |
| Charging Time | 8-9 h |
| Waterproof Rating | IPX4 |
Note on Range: Measured in a laboratory under 100% battery level condition. The range will differ depending on different factors, such as load, humidity, wind speed, and operation habits.
Note on Max Load Capacity: The structure of this scooter is designed to support a maximum load of 150 kg. For the best riding experience, 70% of the maximum load is recommended.
10. User Tips
- Ensure all components are securely fastened after assembly for a safe ride.
- Always wear appropriate safety gear, including a helmet, when riding the scooter, especially at higher speeds.
- Utilize the Voltix app to easily switch between different speed modes and monitor your scooter's status.
11. Warranty & Support
Manufacturer Information:
Manufacturer: Dongguan Yicheng Shengda Information Technology Co., Ltd.
Address: Room 301, No. 28, Houshan Road, Nanchongkou, Humen Town, Dongguan City, Guangdong Province, China
E-mail: support@e-scootworld.com
EU Representative:
EC REP: GAVIMOSA CONSULTORIA, SOCIEDAD LIMITADA
Address: CASTELLANA 9144, 28046 Madrid
E-mail: compliance.gavimosa@outlook.com
Contact: Jorge Wilson
Tel: +34 688185858
Waste Electrical and Electronic Equipment (WEEE)
The crossed-out garbage can symbol indicates that you are legally obliged to dispose of these devices separately from unsorted municipal waste. Disposal via the residual waste bin or the yellow bin is prohibited. If the products contain batteries or rechargeable batteries that are not permanently installed, they must be removed before disposal and disposed of separately as a battery.
Declaration of Conformity
To obtain the full text of the EU Declaration of Conformity, please contact our support team at support@e-scootworld.com.
A comprehensive user manual is available in PDF format for detailed instructions: View User Manual (PDF).