Pickle Power 6F22

Contents

Pickle Power 9V 1300mAh 6F22 Rechargeable Li-ion Battery User Manual

Model: 6F22

Introduction

This manual provides essential information for the safe and efficient use of your Pickle Power 9V 1300mAh 6F22 Rechargeable Li-ion Battery. Please read these instructions carefully before use and retain them for future reference.

Product Specifications

AttributeValue
Model Number6F22
Voltage9V
Capacity1300mAh
Battery TypeRechargeable Li-ion Battery
Charger PortType-C Charger Port
RechargeableYes
CertificationsCE, FCC, RoHS
OriginMainland China

Safety Information and Warnings

WARNING!

  • Opening and/or disassembly of the product may only be performed by trained service personnel.
  • Fire hazard due to overload! Pay attention to the maximum output currents of the product. In case of disturbances such as deformation, discoloration, or leakage of fluids, disconnect the device immediately. If possible, transport outdoors for best possible ventilation. Liquid spillages can ignite.
  • Risk of short circuit! Never bridge any contacts.
  • Avoid contact with liquids, fire, dust, and temperatures above 60°C.
  • Upon contact with fluids emerging from the battery, immediately rinse with clear water or, in case of eye contact, rinse thoroughly and consult a doctor immediately. There is a risk of injury or blindness.

NOTE:

  • Use equipment only in dry areas.
  • Do not operate unattended or entrust to children.

Setup and Usage

Initial Setup:

  1. Completely charge the battery before its first usage.
  2. For the first 3 charging cycles, discharge the battery to approximately 5-7% of its capacity, then fully charge it again. This helps to optimize battery performance.

General Usage:

  • Only use the battery with compatible devices that require a 9V 6F22 battery.
  • Common applications include Digital Multimeters, Toys, Microphones, Remote controls, RC Helicopters, and other power-consuming equipment.
  • Ensure correct polarity (positive / negative) when inserting the battery into a device.
Diagram showing the 9V battery terminals (positive and negative) and the Type-C charger port with indicator light.
Figure 1: Battery Terminals and Type-C Charging Port

Charging Instructions

  • Use only a compatible Type-C charger.
  • Connect the Type-C charging cable to the battery's charging port.
  • Ensure the correct polarity when connecting the charging cable.
  • The battery features a red indicator light which typically illuminates during charging and may change color or turn off when fully charged (refer to specific product behavior).
  • Do not charge the battery unattended or leave it with children.
Pickle Power 9V battery being charged via Type-C cable, with red indicator light.
Figure 2: Charging the 9V Li-ion Battery
Two Pickle Power 9V batteries with Type-C charging cables.
Figure 3: Multiple Batteries with Charging Cables

Maintenance and Storage

  • For optimal lifespan, it is recommended to store the battery with approximately 60% of its nominal capacity.
  • A battery naturally discharges over time. Deep discharge can irreversibly damage the battery.
  • Check the battery charge periodically, especially if stored for long periods.
  • If storing the battery for longer periods or not using it, remove it from the device.
  • Store in a cool, dry place, away from direct sunlight, heat sources, and moisture.

Troubleshooting

  • Battery not charging: Ensure the Type-C cable is properly connected and the charger is functional. Verify the charging port on the battery is clean and free of debris.
  • Battery not holding charge: This could indicate a deeply discharged battery or an aging battery. Follow initial charging cycles recommendations. If the issue persists, consider replacing the battery.
  • Device not powering on: Check if the battery is fully charged and correctly inserted with the right polarity. Ensure the device itself is functional.

User Tips

  • Always keep a spare charged battery for critical applications like multimeters.
  • When using multiple batteries, label them to keep track of their usage and charging cycles.
  • Avoid extreme temperatures, as they can negatively impact battery performance and lifespan.

Warranty and Support

The manufacturer is not liable for damage to persons and/or property caused by improper installation, maintenance, usage, or operation of the product.

The warranty covers the product itself. The manufacturer does not have influence over the installation or specific application of the product.

Do not change or modify the product or its accessories, as this will void the warranty.

For technical support or warranty claims, please contact your retailer or the manufacturer directly.

Disposal Information

Rechargeable batteries are considered hazardous waste and should not be disposed of with household waste.

At the end of its service life, please dispose of the product in accordance with applicable statutory provisions and local regulations for battery recycling.

Product Media

Product Overview Video:

Video 1: A short demonstration of the Pickle Power 9V Li-ion battery, showing its features and charging process.

Additional Images:

Pickle Power 9V 1300mAh Li-ion Battery, front view.
Figure 4: Front view of the Pickle Power 9V Li-ion Battery.
Two Pickle Power 9V batteries, showing the Type-C charging port and indicator light.
Figure 5: Two 9V batteries highlighting the Type-C charging port.
Pickle Power 9V battery showing the Type-C charging port and red indicator light.
Figure 6: Close-up of the Type-C charging port with indicator light.
Pickle Power 9V battery, side view, showing the terminals.
Figure 7: Side view of the 9V battery showing its terminals.

Manufacturer: Shenzhen Oulitai Electronic Technology Co., Ltd.

Address: 402, Building 3, No.23 Songshanzai Road, Xinhe Community, Fucheng Street, Longhua District, Shenzhen City, Guangdong Province, China, 518110

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.