Important Safety Information
⚠️ Warning: If you are younger than 18, do not use this. You should go to a doctor, preferably an ear-nose-throat doctor (an ENT), because your condition needs specialized care. Over-the-counter hearing aids are only for users who are age 18 or older.
A lithium-ion rechargeable battery is permanently built into your device. Incorrect use of the device can cause the lithium-ion rechargeable battery to burst. Risk of injury, fire or explosion!
- Follow the safety instructions for lithium-ion rechargeable battery in this section.
⚠️ Warning: Risk of electric shock! Connect the charger only with a USB power supply which complies with IEC 60950-1 and/or IEC 62368-1.
- Observe the operating conditions.
- Pay special attention to protect your device from extreme heat (e.g. fire, microwave oven, induction oven or other high induction fields) and sunlight.
- Charge your hearing aids only with an approved charger.
- Do not disassemble the device.
- Do not use the device in explosive atmospheres.
- Do not use devices that are deformed or obviously damaged.
- Do not use the device when its performance after charging reduces considerably. Return the device to your Hearing Care Professional.
- Do not dispose of the device in fire or water.
- Replacement and repair have to be performed by a professional. Do not repair or replace the lithium-ion rechargeable battery yourself.
- In the unlikely event of a lithium-ion rechargeable battery bursting or exploding, keep all combustible materials away.
Welcome
Thank you for choosing our hearing aids to accompany you through everyday life. Like anything new, it may take you a little time to become familiar with them.
This guide, along with support from your Hearing Care Professional, will help you understand the advantages and greater quality of life your hearing aids offer.
To receive the most benefit from your hearing aids, it is recommended that you wear them every day, all day. This will help you get adjusted to them.
⚠️ CAUTION: It is important to read this user guide and the safety manual thoroughly and completely. Follow the safety information to avoid damage or injury.
ℹ Tip: Before using your hearing aids for the first time, fully charge them. Follow the instructions in the charger's user guide.
Your Hearing Aids
Hearing Aid Type
Your hearing aids are a RIC (Receiver-in-Canal) model. The receiver is placed within the ear canal and connected to the hearing aid via a receiver cable. The hearing aids are not intended for children under the age of 3 years or persons with a developmental age of under 3 years.
A power cell (lithium-ion rechargeable battery) is permanently built into your hearing aid. This enables easy charging with our Universal Cable Charger.
The wireless functionality enables advanced audiological features and synchronization between your two hearing aids.
Getting to Know Your Hearing Aids
It is recommended to familiarize yourself with your new hearing aids. With the hearing aids in your hand try using the controls and note their location on the hearing aid. This will make it easier for you to feel and press the controls while wearing the hearing aids.
ℹ Tip: If you have problems pressing the controls of your hearing aids while wearing them, you can ask your Hearing Care Professional whether a remote control or a smartphone app to control your hearing aids is available.
Components and Names

Image: Rexton Recharge R-Li 5 hearing aid, showing its compact design.
- Ear piece
- Receiver
- Receiver cable
- Microphone openings
- Rocker switch (control, on/off switch)
- Side indicator (red = right ear, blue = left ear) and receiver connection
Ear Pieces
You can use the following standard ear pieces:
- Click Sleeve (vented or closed)
- Click Dome™ single (open or closed)
- Click Dome semi-open
- Click Dome double
Custom-made ear pieces:
- Custom shell
- Click Mold™
Setup
Charging
Place your hearing aids in the charger. Follow the instructions in the charger's user guide. You can also find useful tips for charging in the charger's user guide.

Image: Rexton Recharge R-Li 5 hearing aids in their charging case, connected to a power source, with a smartphone displaying the control app.
Low Power Indication: You will hear an alert signal to indicate the power cell is running low. The signal will be repeated every 15 to 30 minutes depending on your settings. Depending on the usage of your hearing aids, you have approximately 1.5 hours to charge your hearing aids before they stop working.
Note that the power cell runtime is reduced if too many features are used simultaneously.
Inserting and Removing the Hearing Aids
Your hearing aids have been fine-tuned for your right and left ear. Colored markers indicate the side: red marker = right ear, blue marker = left ear.
Inserting a hearing aid:
- For Click Sleeves, take care that the bend of the Click Sleeve is in line with the bend of the receiver cable.
- Hold the receiver cable at the bend closer to the ear piece.
- Carefully push the ear piece into the ear canal.
- Twist it slightly until it sits well.
- Open and close your mouth to avoid accumulation of air in the ear canal.
- Lift the hearing aid and slide it over the top of your ear.
⚠️ CAUTION: Risk of injury! Insert the ear piece carefully and not too deeply into the ear.
ℹ Tip: It may be helpful to insert the right hearing aid with the right hand and the left hearing aid with the left hand. If you have problems inserting the ear piece, use the other hand to gently pull your earlobe downwards. This opens the ear canal and eases insertion of the ear piece.
The optional retention strand helps to securely retain the ear piece in your ear. Bend the retention strand and position it carefully into the bottom of the bowl of your ear.

Image: A Rexton Recharge R-Li 5 hearing aid worn behind the ear, with the receiver cable and ear piece visible.
Removing a hearing aid:
- Lift the hearing aid and slide it over the top of your ear.
- If your hearing aid is equipped with a custom shell or a Click Mold, remove it by pulling the small removal cord toward the back of your head.
- For all other ear pieces: Grip the receiver in the ear canal with two fingers and pull it carefully out. Do not pull the receiver cable.
⚠️ CAUTION: Risk of injury! In very rare cases the ear piece could remain in your ear when removing the hearing aid. If this happens, have the ear piece removed by a medical professional.
Operation
Controls (Rocker Switch Functions)
| Rocker switch function | Left (L) | Right (R) |
|---|---|---|
| Press briefly: | ||
| Program up/down | □ | □ |
| Volume up/down | □ | □ |
| Tinnitus Function: level up/down | □ | □ |
| Press for about 2 seconds: | ||
| Program up/down | □ | □ |
| Volume up/down | □ | □ |
| Tinnitus Function: level up/down | □ | □ |
| Press for more than 3 seconds: | ||
| Turn on/off | □ | □ |
ℹ Tip: You can also use a remote control to change hearing programs and adjust the volume of your hearing aids. With our smartphone app you have even more control options.
Turning On and Off
You have the following options to turn your hearing aids on or off:
Via charger:
- Turning on: Take the hearing aids out of the charger. The startup melody is played in your hearing aids. The default volume and hearing program are set.
- Turning off: Place the hearing aids in the charger. Note that the charger must be connected to the power supply. For details refer to the charger's user guide.
Via rocker switch:
- Turning on: Press and hold the lower part of the rocker switch until the startup melody starts to play. Release the rocker switch while the melody is playing. The default volume and hearing program are set.
- Turning off: Press and hold the lower part of the rocker switch for several seconds, until the hearing aid turns off.
Switching to Standby Mode
Via remote control, you can switch your hearing aids to standby mode. This mutes the hearing aids. When you leave standby mode, the previously used volume and hearing program are set.
Note:
- In standby mode, the hearing aids are not turned off completely. They draw some power. Therefore we recommend to use standby mode only for a short period of time.
- If you want to leave standby mode, but the remote control is not at hand: Turn your hearing aids off and on again (via rocker switch or by shortly placing them in the charger until one or more LEDs light up). In this case, the default volume and hearing program are set.
Adjusting the Volume
Your hearing aids automatically adjust the volume to the listening situation.
- If you prefer manual volume adjustment, press the upper part of the rocker switch to increase the volume or press the lower part to decrease the volume.
An optional signal can indicate the volume change. Once the maximum or minimum volume has been reached, you may hear an optional signal tone.
Changing the Hearing Program
Depending on the listening situation, your hearing aids automatically adjust their sound.
Your hearing aids may also have several hearing programs which allow you to change the sound, if needed. An optional signal tone can indicate the program change.
- To change the hearing program, press the rocker switch briefly. The default volume is applied.
Features
The Tinnitus Function generates a sound to distract you from your tinnitus.
Special Listening Situations: On the Phone
When you are on the phone, hold the telephone receiver slightly above your ear. The hearing aid and telephone receiver have to be aligned. Turn the receiver slightly so that the ear is not completely covered.
You may prefer a certain volume when using the phone. Ask your Hearing Care Professional to configure a telephone program. Switch to the telephone program whenever you are on the phone.
Maintenance and Care
To prevent damage it is important that you take care of your hearing aids and follow a few basic rules, which will soon become a part of your daily routine.
Hearing Aids Cleaning
Your hearing aids have a protective coating. However, if not cleaned regularly, you may damage the hearing aids or cause personal injury.
- Clean your hearing aids daily with a soft, dry tissue.
- Never use running water or immerse the devices in water.
- Never apply pressure while cleaning.
- Do not use alcoholic solvent on the charging contacts.
- To avoid corrosion, use a soft and dry tissue to wipe off sweat or liquid from the charging contacts or hearing aids before inserting them in the charger.
- Ask your Hearing Care Professional for recommended cleaning products, special care sets, or more information on how to keep your hearing aids in good condition.
Drying
Ask your Hearing Care Professional for recommended drying products and for individual instructions on when to dry your hearing aids.
Storage
Short-term storage (up to several days): Turn off your hearing aids via the rocker switch or place them in the powered charger. The charger must be connected to the power supply. If the charger is not connected to power supply and you place your hearing aids in the charger, the hearing aids are not turned off. Note that when you turn off the hearing aids via a remote control or smartphone app, the hearing aids are not turned off completely. They are in standby-mode and still draw some power.
Long-term storage (weeks, months, ...): First, fully charge your hearing aids. Turn them off via the rocker switch before storing them. We recommend using drying products while storing the hearing aids. At 6-month intervals you will have to charge the hearing aids to avoid an unrecoverable deep-discharge of the power cell. Deep-discharged power cells cannot be charged anymore and they have to be replaced. We recommend recharging more frequently than 6-month intervals.
Ear Pieces
Cerumen (ear wax) may accumulate on the ear pieces. This may affect sound quality. Clean the ear pieces daily.
Cleaning: For all types of ear pieces, clean the ear piece right after removal with a soft and dry tissue. This prevents that cerumen becomes dry and hard. For Click Domes or Click Sleeves, squeeze the tip of the ear piece to remove cerumen.
Exchanging: Exchange standard ear pieces approximately every three months. Replace them sooner if you notice cracks or other changes. The procedure for exchanging standard ear pieces depends on the type of ear piece.
- Exchanging Click Domes: To remove the old Click Dome, follow the instructions on the packaging of the Click Domes. Be careful not to pull the receiver cable. Take particular care that the new Click Dome clicks noticeable in place. Check the firm fit of the new Click Dome.
- Exchanging Click Sleeves: Turn the Click Sleeve inside out. Grasp the Click Sleeve and the receiver (not the receiver cable) with your fingers and pull the Click Sleeve off. Take particular care that the new Click Sleeve clicks noticeably in place.
Professional Maintenance
Your Hearing Care Professional can perform a thorough professional cleaning and maintenance. Custom-made ear pieces and wax filters should be exchanged as needed by your Hearing Care Professional. Ask your Hearing Care Professional for your individual recommendation of maintenance intervals and for support.
Troubleshooting
| Problem | Possible solutions |
|---|---|
| Sound is weak. | Increase the volume. Charge the hearing instrument. Clean or exchange the ear piece. |
| Hearing instrument emits whistling sounds. | Reinsert the ear piece until it fits securely. Decrease the volume. Clean or exchange the ear piece. |
| Sound is distorted. | Decrease the volume. Charge the hearing instrument. Clean or exchange the ear piece. |
| Hearing instrument emits signal tones. | Charge the hearing instrument. |
| Hearing instrument does not work. | Turn the hearing instrument on. Charge the hearing instrument. Observe also the status LEDs on the charger. |
Consult your Hearing Care Professional if you encounter further problems.
Specifications
Key Features
- Up to 35 hours of runtime
- 4-hour standard charge time or 30-minute fast charge
- Extended Dynamic Range
- Omni Sound Locator
- Lifeproof to withstand everyday challenges
Performance Levels

Image: Detailed table outlining features and performance levels (30, 20, 10, 5) for Rexton Recharge R-Li hearing aids, including channels, Bluetooth, Tinnitus functions, IP68 rating, First Fit, Voice Ranger, Adaptive compression, Extended Dynamic Range, Motion sensor, Directionality, Noise Reduction, Sound Quality & Control, and TeleCare options.
Operating, Transport, and Storage Conditions
| Condition | Storage (Recommended) | Storage (Maximum Range) | Transport |
|---|---|---|---|
| Temperature | 10 to 25 ℃ (50 to 77 ℉) | 0 to 40 ℃ (32 to 104 ℉) | -20 to 60 ℃ (-4 to 140 ℉) |
| Relative humidity | 20 to 80% | 10 to 80% | 5 to 90% |
| Atmospheric pressure | 700 to 1060 hPa | 700 to 1060 hPa | 700 to 1060 hPa |
Note that you have to charge the hearing instruments at least every 6 months. We recommend to charge the hearing instruments every 3 months.
⚠️ WARNING: Risk of injury, fire or explosion during shipment. Ship power cells and hearing instruments according to local regulations.
Country-Specific Information (USA and Canada)
Certification information for hearing aids with wireless functionality:
ReCharge R-Li 5:
- HVIN: RFM011
- Contains FCC ID: 2AXDT-RFM011
- Contains IC: 26428-RFM011
User Tips
- The Rexton Recharge R-Li 5 hearing aids can be connected to a mobile phone for app control, allowing for easy adjustments and personalization.
- Even if you purchase only one hearing aid, a charger is included in the package.
Warranty and Support
For detailed warranty information, including date of purchase and warranty period, please refer to the full user guide PDF or contact your Hearing Care Professional.
A comprehensive user manual (PDF) is available for download: Rexton Recharge R-Li User Guide (PDF).
Product Video
Video: A short demonstration of the Rexton Recharge R-Li 5 hearing aids, showcasing their features and ease of use, including charging and app connectivity.