iScooter W9Air Electric Scooter User Manual

Important Information

Please read this user manual carefully before operating the iScooter W9Air Electric Scooter and keep it for future reference. Illustrations of the product, accessories, and user interface are for reference purposes only. Actual product and functions may vary due to product enhancements.

Safety Disclaimer

Please be aware of potential fire risks and strictly follow the instruction manual for charging and storage. When using the product, always wear protective equipment and fully comply with applicable local laws and regulations regarding electric scooter usage.

The structure of this scooter is designed to support a maximum load of 120 kg (264 lbs). For the best riding experience, 70% of the maximum load is recommended.

Product Overview

The iScooter W9Air is an electric scooter designed for adults, featuring 10-inch off-road tires, a 10Ah battery, and APP connectivity. It offers a range of 30-40km and a maximum speed of 40km/h (unlocked).

Figure 1: Key Features of the iScooter W9Air

Parts Diagram

Figure 2: Labeled Parts of the iScooter W9Air

Refer to the diagram above for the location of the following components:

1. Control Pad
2. Handlebar Folding Sleeves
3. Display
4. Brake Levers
5. Throttle
6. Height Adjustment Clamp
7. Headlight with Horn
8. Disc Brake Rotor
9. Charging Port
10. Deck Lights (2 Sides)
11. Folding Mechanism
12. Footrest
13. 2-in-1 Taillight & Brake Light

Package Contents

Ensure all items are present in the package:

Figure 3: Package Contents

• iScooter W9Air Electric Scooter
• Charger
• Open-End Wrench
• T-Shaped Key
• L-Shaped Hex Key
• User Manual (this document)

Setup Instructions

Unfolding the Scooter

Figure 4: Unfolding Steps

1. Press down the folding latch and lift the stem to the riding position until you hear a click.
2. Pull the safety pin, close the S-shaped lever to the end, and release the safety pin until it locks the S-shaped lever in place.

Note:

• If you find it hard to press the folding latch, lift the stem a little.

Adjusting the Handlebar

Figure 5: Handlebar Adjustment

1. Lift the two ends of the handlebar to the horizontal positions until you hear clicks from the folding sleeves, indicating the two ends are locked in place.
2. Adjust the handlebar to your desired height and fully tighten the height adjustment clamp.

Warning:

• The folding sleeves must be in their locking positions (i.e., no gaps between them and the handlebar). If not, lift the ends a little.

Operating Instructions

Basic Operations

Figure 6: Control Pad Layout

• Power ON/OFF: Press and hold the Power button for 2 seconds.
• Headlight ON/OFF: Press the Headlight button to turn on/off the headlight, taillight, and deck lights simultaneously.
• Select Riding Mode: Press the "S" button to cycle through modes.
• Select TRIP/ODO: Press the "S" button twice to switch between trip distance and total odometer.
• Imperial/Metric Units: Press the "M" button to toggle between imperial and metric units.

Note:

• The scooter will automatically power off after 10 minutes of inactivity.

Display Information

Figure 7: Display Screen Indicators

The display screen shows key cycling data:

1. Left turn signal
2. Real-time speed
3. Headlights on
4. Brakes applied
5. Vehicle locked
6. Right turn signal
7. Engine overheat warning
8. Connected app
9. Driving mode
10. Trip mileage / Total mileage
11. Cruise control
12. Battery level

Riding Modes and Max Speed

After starting, hold the brake lever down and press the power button 5 times to deactivate the speed limiter. Press the S button to change gears.

Settings (P1, P2, P4)

To access advanced settings:

1. To enter the settings, press and hold the Power and Horn buttons simultaneously.
2. Press the Horn button to cycle through P1, P2, and P4.
• P1 (Start Mode): When selecting P1, press the "M" button for P10 (zero start) or the "S" button for P11 (non-zero start).
• P2 (Cruise Control): When selecting P2, press the "M" button for P20 (off) or the "S" button for P21 (on).
• P4 (Odometer Reset): When selecting P4, press and hold the "M" button to reset the odometer (total distance).
3. Press the Horn button to switch to the next setting item (changed settings will be saved).
4. Press the Power and Horn buttons simultaneously or wait 5 seconds to save all changes and return to the home screen.

Voltix App Connection

The iScooter W9Air supports smart connection with the Voltix app. You can monitor your ride, adjust settings, and track performance seamlessly through the dedicated app.

Figure 8: Real-time Data Tracking via Voltix App

Scan the QR code below to download the Voltix App:

Figure 9: Voltix App QR Code

Charging Instructions

• The scooter is fully charged when the charger indicator changes from red to green.
• With charging protection, the scooter will automatically stop charging after a full charge. However, it is still not recommended to overcharge.
• Keep the charging port cover closed when not charging to protect it from dust and moisture.
• The scooter cannot be turned on or operated while charging.
• Charging time is approximately 6-8 hours.

Figure 10: Scooter Charging

Maintenance

Disc Brake Adjustment

Figure 11: Disc Brake Adjustment Points

To adjust the brake cable:

• You need a hex wrench to loosen the bolt on the cable clamp.
• If the disc brake is dragging, slide the arm of the clamp backward along the cable while holding the cable in one hand. Then, retighten the bolt on the brake clamp.
• If the disc brake does not work efficiently (cable is slack), slide the arm of the clamp forward along the cable while holding the cable in one hand. Then, retighten the bolt on the brake cable clamp.

To eliminate brake noise:

1. Loosen the two brake caliper mounting bolts (not the bolt on the cable clamp).
2. Reposition the brake caliper to ensure the brake rotor is centered between the brake pads.
3. Retighten the mounting bolts.

General Care

• Regularly check tire pressure and ensure tires are in good condition for optimal performance and safety.
• Keep the scooter clean. Wipe down surfaces with a damp cloth. Avoid using harsh chemicals.
• Store the scooter in a dry, cool place away from direct sunlight and extreme temperatures.

Troubleshooting

If you encounter any issues, refer to the table below for common error codes. If the problem persists, contact customer support.

Note:

• If you see any error code listed on the display, please contact our support team to resolve it.

Specifications

Figure 12: Detailed Product Specifications

*Range and maximum load are measured in a laboratory under 100% battery level condition. Actual range may vary depending on factors such as load, humidity, wind speed, and operation habits.

User Tips

• The scooter features a strong motor and effective brakes, providing a smooth and safe ride even on slightly uneven paths.
• The scooter folds up quickly, making it convenient for transport and storage.
• The front shock absorber is primarily for aesthetic purposes and does not provide significant suspension travel.
• This model does not include integrated turn signals. Always use hand signals when turning to ensure safety.
• The Voltix app allows for adjustments and tracking of your ride data, enhancing your overall experience.
• Always check local regulations regarding electric scooter usage, as legality and registration requirements may vary by region.

Warranty and Support

For any issues, questions, or to obtain the full text of the EU Declaration of Conformity, please contact our support team at support@e-scootworld.com.

Manufacturer: Dongguan Yicheng Shengda Information Technology Co., Ltd.

Address: Room 301, No. 28, Houshan Road, Nanchongkou, Humen Town, Dongguan City, Guangdong Province, China

EC Representative: GAVIMOSA CONSULTORIA, SOCIEDAD LIMITADA

EC Address: CASTELLANA 9144, 28046 Madrid

EC Contact: Jorge Wilson

EC Tel: +34 688185858

FCC ID: 2BM88-W9AIR

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CE Warning: The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. Children should be supervised not to play with the appliance.

Disposal of Electrical and Electronic Equipment: The crossed-out garbage can symbol indicates that you are legally obliged to dispose of these devices separately from unsorted municipal waste. If the products contain batteries or rechargeable batteries that are not permanently installed, they must be removed before disposal and disposed of separately as a battery.