CNCEST NL 150

Contents

NL 150 Gasoline High-pressure Washer Instruction Manual

Model: NL 150 | Brand: CNCEST

Introduction

Thank you for choosing the NL 150 Gasoline High-pressure Washer. This manual provides essential information for the safe operation, assembly, maintenance, and troubleshooting of your new pressure washer. Please read this manual thoroughly before operating the machine to ensure proper use and to prevent injury or damage.

NL 150 Gasoline High-pressure Washer with accessories and examples of cleaning applications.
NL 150 Gasoline High-pressure Washer with accessories and examples of cleaning applications.

Safety Information

Operating a gasoline high-pressure washer requires careful attention to safety. Failure to follow these instructions could result in serious injury or property damage.

  • Always read and understand the entire user manual before operation.
  • Ensure the work area is well-ventilated when operating the gasoline engine.
  • Keep the outlet pipe away from the silencer (at least 7.87 inches) to prevent explosion due to excessive temperature.
  • The machine has heat-sink holes for good heat dissipation; do not block them.
  • The oil tank has an oil distribution alarm system to remind you to refuel in time.
  • Always wear appropriate personal protective equipment (PPE), including eye protection, hearing protection, and sturdy footwear.
  • Never point the spray gun at people, animals, or electrical equipment.
  • Do not operate the pressure washer if any parts are damaged or missing.
  • Ensure all connections are secure before starting the machine.
  • Make sure the pump does not contain water before turning off the engine.
Control panel of the pressure washer showing the five selectable nozzles and an 'Easy Start' warning: 'Before operation, pls read and understand the user manual'.
Control panel with nozzle selection and safety warning.

Package Contents

Upon unpacking, please verify that all the following items are included:

  • 1x Gasoline High-pressure Washer unit
  • 1x Spray Gun with Extension Rod
  • 1x Water Inlet Hose (2m / 6.56ft)
  • 1x Chemical Hose (1m / 3.28ft)
  • 1x High-pressure Hose (8m / 26ft)
  • 1x Sleeve for Spark Plug
  • 1x Filter
  • 1x Breather Plug
  • 1x English Manual
  • Other Accessories for Assembly & Use (e.g., wheels, handle, fasteners)
NL 150 Gasoline High-pressure Washer with all included accessories.
All components included in the package.

Specifications

FeatureDetail
ModelNL 150
ColorBlack, Red
MaterialIron, Rubber, PVC
ProcessesPainting, Anodized
Starter SystemHand Pull Start
Power SourceGasoline Powered
Engine Type4-stroke, Single Cylinder, Air-cooled
Speed3400r/min
Power7.5HP
Petrol Type92# or 95#
Engine Oil Tank Capacity700ml / 23.67 Oz / 0.18 Gal
Pump Oil Tank Capacity3.5L / 118.35 Oz / 0.9 Gal
Max. Flow Rate2.3 GPM
Wheel Diameter20.32cm / 8 inch
Chemical Hose Length1m / 3.28ft
Water Inlet Hose Length2m / 6.56ft
High-pressure Hose Length8m / 26ft
Working Pressure170-190 Bar, 2200 PSI
Nozzle Angles0° (Red), 15° (Yellow), 25° (Green), 40° (White), Bubble Nozzle (Black)
Product Size56 x 50 x 81 cm / 22 x 19.7 x 31.9 in
Gross Weight30kg / 66 lbs
Dimensions of the NL 150 Gasoline High-pressure Washer: 56cm/22in (width), 50cm/19.7in (depth), 81cm/31.9in (height).
Product dimensions for the NL 150 pressure washer.

Setup

Follow these steps to assemble your high-pressure washer before first use:

  1. **Prepare Tools**: Gather any necessary installation tools (e.g., wrenches for fasteners).
  2. **Unpack and Inspect**: Open the package and check all parts against the "Package Contents" list.
  3. **Assemble Washer**:
    • Attach the two 8-inch pneumatic wheels to the main unit's axle.
    • Secure the handle to the main unit using the provided fasteners.
    • Install the two practical hooks onto the handle for hose and spray gun storage.
  4. **Fill Fluids**:
    • Fill the engine oil tank (700ml capacity) with appropriate 4-stroke engine oil. Ensure the maximum fuel level is below the bottom 1/2-inch of the filler neck to avoid spillage. Clean the tank surface and secure the cap after filling.
    • Fill the pump oil tank (3.5L capacity) with appropriate pump oil.
    • Fill the petrol tank with 92# or 95# petrol.
Video demonstrating the assembly and initial setup of the NL 150 Gasoline High-pressure Washer, including wheel installation, handle attachment, and hose connections.

Operating Instructions

Once assembled and filled with fluids, follow these steps to operate your pressure washer:

  1. **Connect Hoses**:
    • Connect the high-pressure hose to the spray gun and the pump outlet.
    • Connect the water inlet hose to a water source and the pump inlet.
    • If using detergent, connect the chemical hose to the soap can and the pump.
  2. **Start the Engine**:
    • Turn the throttle to the left.
    • Turn the fuel control valve to the right.
    • Set the engine switch to "ON".
    • Straighten the recoil start hose and pull the handle of the recoil start assembly firmly until the engine starts.
    • After the engine starts, turn the throttle to the right.
  3. **Prepare for Spraying**:
    • Place the water input hose into the water source.
    • Turn on the spray gun (without a nozzle attached) until water comes out steadily, purging any air from the system.
  4. **Select and Attach Nozzle**:

    Choose the appropriate nozzle for your cleaning task and connect it to the spray gun. To change nozzles, slide the buckle at the end of the spray gun backward, insert the desired nozzle, and release the buckle to secure it.

    • **0° (Red) Nozzle**: Provides the strongest, most direct pressure for tough, concentrated cleaning.
    • **15° (Yellow) Nozzle**: Offers a narrow spray for intensive cleaning and paint removal.
    • **25° (Green) Nozzle**: Delivers a wide spray for moderate cleaning, suitable for general tasks and auto washing.
    • **40° (White) Nozzle**: Provides low pressure for delicate surfaces or rinsing.
    • **Bubble Nozzle (Black)**: Used for applying soap or detergent for deep cleaning projects. You can pour up to 32oz of detergent into the soap can on the machine.
  5. **Begin Cleaning**: Point the spray gun at the surface to be cleaned, maintaining a safe distance, and press the trigger.
  6. **Shut Down**: When finished, release the trigger, turn off the engine, and ensure the pump does not contain water before storage.
High-pressure washer in action, cleaning a deck and a car.
Demonstration of the pressure washer cleaning a deck and a car.

Maintenance

Regular maintenance ensures the longevity and optimal performance of your pressure washer.

  • **Fluid Changes**:
    • Change the engine oil and pump oil after the first 10 hours of operation.
    • Subsequently, change the engine oil and pump oil every 100 hours of operation.
  • **Fuel Management**:
    • If the machine has been stored for a long time, change the petrol before use.
    • Maintain the maximum fuel level below the bottom 1/2-inch of the filler neck to avoid spillage.
  • **General Inspection**: Regularly inspect and maintain the engine to keep it in good condition.
  • **Post-Use Care**: After absorbing water, all accessories need to be dried in sunlight before the next use to prevent mold or damage.
  • **Cleaning**: The smooth painted surface and filter device make it easy to clean with a towel or water.
Detailed view of the 7.5HP engine and air filter assembly.
Engine and air filter for maintenance reference.

Troubleshooting

Here are some common issues and their solutions:

  • **Engine Fails to Start**: Check if the engine is lacking engine oil. Ensure the fuel tank has sufficient and fresh petrol. Verify the engine switch is in the "ON" position and the throttle and fuel valve are correctly set.
  • **Low Pressure**: Check for kinks in hoses, clogged nozzles, or insufficient water supply.
  • **Water Leakage**: Inspect all hose connections and O-rings for proper seating and damage.

User Tips

While no specific user reviews or Q&A were provided, here are some general tips for using your pressure washer effectively:

  • **Nozzle Selection**: Always start with a wider spray angle (e.g., 40° or 25°) on a test area to avoid damaging surfaces, especially delicate ones. Adjust to narrower angles (15° or 0°) for tougher stains.
  • **Detergent Use**: For best results with the bubble nozzle, pre-soak the area with detergent, allow it to sit for a few minutes (without drying), then rinse thoroughly with a high-pressure nozzle.
  • **Storage**: Store the pressure washer in a dry, protected area. If storing for an extended period, drain all fuel and water from the system to prevent corrosion and freezing.
  • **Safety First**: Always maintain a firm grip on the spray gun, as the recoil can be strong.

Warranty and Support

For any questions regarding warranty, service, or technical support, please refer to the contact information provided by your retailer or the manufacturer. Keep your purchase receipt as proof of purchase.

Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.