Introduction
This manual provides essential information for the installation, maintenance, and safe use of your new HAIBOXING RC Car Body Shell, designed specifically for the HBX 16889 and 16889A models. This body shell is a direct replacement part, offering enhanced durability and a fresh look for your remote control vehicle.

Safety Information
⚠ Important Safety Notice:
- This product is intended for recreational use only.
- Illegal modification of remote control vehicles is prohibited.
- Always be aware of and comply with relevant laws and regulations regarding the use of RC vehicles in your country or area to ensure legal and safe operation.
Installation Instructions
The HAIBOXING RC Car Body Shell is designed for easy replacement. Follow these steps to install your new body shell:
- Prepare the Vehicle: Ensure your HBX 16889 or 16889A RC car is powered off and the battery is disconnected.
- Remove Old Body Shell (if applicable): Carefully unclip or unscrew any fasteners holding the existing body shell to the chassis. Gently lift and remove the old body shell.
- Inspect New Body Shell: Before installation, inspect the new body shell for any manufacturing defects or damage.
- Remove Protective Film: The body shell may come with a transparent protective film. Please peel off this film before use to reveal the finished surface and prevent damage during handling.
- Position New Body Shell: Align the new body shell with the mounting posts or clips on the RC car chassis.
- Secure Body Shell: Gently press down or re-attach the clips/screws to secure the new body shell firmly in place. Ensure all mounting points are properly engaged.
- Final Check: Verify that the body shell is securely attached and does not interfere with any moving parts of the RC car.


Operation
Once installed, the body shell serves as the protective outer casing for your RC car's internal components. It helps shield the electronics and chassis from impacts, dirt, and debris during operation. Ensure it is always securely fastened before operating your RC vehicle.
Maintenance
- Cleaning: After each use, especially in dusty or muddy conditions, clean the body shell with a soft cloth to remove dirt and debris. For stubborn grime, a mild soap solution and water can be used, followed by thorough drying.
- Inspection: Regularly inspect the body shell for cracks, dents, or other damage. Pay attention to mounting points and edges.
- Storage: Store the body shell in a cool, dry place away from direct sunlight and extreme temperatures to prevent material degradation.
Troubleshooting
- Ensure you have the correct body shell for your specific HBX 16889 or 16889A model.
- Check for any obstructions on the chassis or inside the body shell that might prevent proper seating.
- Verify that all mounting posts are aligned with the holes in the body shell.
- Ensure all body clips or screws are securely fastened.
- Inspect mounting posts and clips for wear or damage; replace if necessary.
Specifications
| Feature | Detail |
|---|---|
| Compatibility | HAIBOXING HBX 16889, HBX 16889A 1/16 RC Car |
| Material | Plastic |
| Color | As shown (multi-color graphic design) |
| Dimensions (Approx.) | Length: 20 cm, Width: 15 cm, Height: 9 cm |
| Weight (Approx.) | 0.13 kg |
| Origin | Mainland China |
| Package Contents | 1 x RC Car Body Shell |

User Tips
- Always ensure the body shell is clean before storage to prevent dirt from hardening and becoming difficult to remove.
- Consider purchasing spare body clips, as these small parts can be easily lost during maintenance or crashes.
- For a custom look, the protective film can be used as a template for painting the inside of the shell before removal, if desired (though this specific shell comes pre-painted).
Warranty and Support
This product is designed for durability and ease of use. For any issues or questions regarding the product, please contact the seller or manufacturer directly. Keep your purchase receipt as proof of purchase for any potential warranty claims.