Eachine EC35

Contents

Eachine EC35 Flameline RC Drift Car Instruction Manual

Model: EC35 | Brand: Eachine

1. Introduction

Thank you for purchasing the Eachine EC35 Flameline 1/14 2.4G 4WD High-Speed Drift RC Car. This manual provides essential information for the safe operation, setup, and maintenance of your new RC vehicle. Please read it thoroughly before use to ensure optimal performance and longevity of your product.

Package Contents

The package typically includes the following items:

  • 1x Eachine EC35 RC Car
  • 2x 7.4V 1500mAh Li-ion Batteries (quantity may vary based on purchase option)
  • 1x 2.4G Remote Controller
  • 1x USB Charging Cable
  • 1x Operating Instructions Manual
  • 1x Sticker Sheet (for customization)
Package contents including the RC car, remote controller, batteries, USB charging cable, and manual.
Figure 1: Typical Package Contents

2. Safety Information

⚠ WARNING: Not suitable for children under 14 years. Adult supervision is recommended for younger users.

To prevent injury or damage to the product, please observe the following safety precautions:

  • Always operate the RC car in open areas, away from people, pets, and obstacles.
  • Do not operate near roads, water, or high-voltage power lines.
  • Keep hands, hair, and loose clothing away from moving parts.
  • Ensure batteries are charged correctly and handled with care.
  • Do not expose the car or remote to moisture or extreme temperatures.
  • Turn off the RC car and remote controller when not in use.
  • Do not attempt to modify or disassemble the product, as this may void the warranty and cause malfunction.

3. Setup Guide

3.1 Battery Charging

The EC35 uses a 7.4V 1500mAh Li-ion battery. Use the provided USB charging cable to charge the car battery.

  1. Connect the USB charging cable to a suitable USB power source (e.g., computer USB port, USB wall adapter).
  2. Connect the battery to the charging cable.
  3. The charging time is approximately 3.5-4 hours. Do not overcharge the battery.

3.2 Car Battery Installation

Install the charged 7.4V 1500mAh Li-ion battery into the RC car's battery compartment.

Internal view of the RC car chassis showing the battery, motor, and electronic components.
Figure 2: Car Chassis with Battery Installed

3.3 Remote Controller Setup

The remote controller requires 2x 1.5V AA batteries (not included).

  1. Open the battery compartment on the back of the remote controller.
  2. Insert 2x AA batteries, ensuring correct polarity (+/-).
  3. Close the battery compartment.
  4. Turn on the remote controller using the Power switch.
Diagram of the remote controller with labeled functions: Steering fine tuning, Throttle trim, Power indicator light, Power switch, Steering control, Backward, Forward.
Figure 3: Remote Controller Functions

3.4 Applying Stickers

The included sticker sheet allows for customization of your RC car. Apply the stickers to the car body as desired. Note that the stickers are not pre-applied.

4. Operating Instructions

4.1 Powering On and Pairing

  1. Ensure the car battery is fully charged and installed.
  2. Turn on the RC car's power switch.
  3. Turn on the remote controller's power switch.
  4. The car and remote should automatically pair. The power indicator light on the remote will confirm connection.

4.2 Basic Controls

Refer to Figure 3 for the remote controller layout.

  • Forward/Backward: Use the throttle trigger. Pull to move forward, push to move backward.
  • Turn Left/Right: Use the steering wheel to control direction.
  • Steering Fine Tuning: Adjust the steering trim dial to ensure the car drives straight when the steering wheel is centered.
  • Throttle Trim: Adjust the throttle trim dial to ensure the car remains stationary when the throttle trigger is released.

4.3 Special Features

  • 4WD System: The car features a four-wheel drive system for enhanced traction and control, especially during drifts.
  • Independent Suspension: The four-wheel independent suspension design provides better handling and shock absorption over various terrains.
  • Electronic Stability Program (ESP) with Gyro: The integrated ESC receiver includes a gyroscope function (ESP). This system helps to timely and effectively correct the car's attitude and direction when high-speed driving results in side slip or loss of control, improving stability.
Illustration explaining the Electronic Stability Program (ESP) with gyroscope, showing how it corrects car attitude and direction during high-speed side slip.
Figure 4: Electronic Stability Program (ESP) in Action
  • Side LED Lighting: The car is equipped with red LED lights on both sides. These lights illuminate automatically when the car is powered on and turn off when the car is powered off. There is no independent control button for the LEDs.
Demonstration of the side LED lighting feature, showing red lights on both sides of the car.
Figure 5: Side LED Lighting

5. Maintenance

5.1 Cleaning

  • After each use, gently clean the car body and chassis to remove dirt, dust, and debris.
  • Use a soft, dry cloth or a small brush. Avoid using water or chemical cleaners directly on electronic components.

5.2 Battery Care

  • Always disconnect the battery from the car when not in use.
  • Store batteries in a cool, dry place, away from direct sunlight and heat.
  • Do not store fully charged or completely depleted batteries for extended periods. Charge them to about 50% for long-term storage.

5.3 General Care

  • Regularly check all screws and connections to ensure they are secure.
  • Inspect the tires for wear and tear.
  • Avoid operating the car in wet conditions due to the splashproof (not waterproof) nature of the ESC.

6. Troubleshooting

ProblemPossible CauseSolution
Car does not respond to remote.Low car battery, low remote battery, not paired, power switch off.Charge car battery, replace remote batteries, ensure both are powered on and paired.
Car drives erratically or not straight.Steering trim needs adjustment, damaged steering components.Adjust steering fine tuning on the remote. Inspect for damage.
Reduced range or intermittent control.Interference, low remote battery.Move to an area with less interference. Replace remote batteries.
LED lights not working.Car not powered on, damaged LEDs.Ensure car is powered on. LEDs are not independently controlled.

7. Specifications

FeatureDetail
BrandEachine
Model NumberEC35
Scale1:14
Max Speed30km/h
Frequency2.4G
Control Channels4 channels
Remote DistanceApprox. 70m
Playing TimeApprox. 9-10 minutes (full speed continuous running)
Charging Voltage7.4V
Car Battery7.4V 1500mAh Li-ion
Charging Time3.5-4 hours
Remote ControlYes
Controller ModeMODE1, MODE2
Required Remote Battery2x 1.5V AA battery (not included)
MaterialPlastic, PA+metal+electronic parts
Car WeightApprox. 720g (without battery)
Remote Controller WeightApprox. 186g (without battery)
Dimensions (Car)34.2 x 14.7 x 10.6 cm
Wheelbase19 cm
Tire Diameter5.3 cm
State of AssemblyReady-to-Go
Recommend Age14+ years
OriginMainland China
Product size diagram with measurements: Front width 14.7cm, height 10.6cm, side length 34.2cm, wheelbase 19cm.
Figure 6: Product Dimensions

8. User Tips

  • Performance: Users have noted the EC35 provides great fun and good performance, especially for drifting.
  • Package Contents Verification: Upon receiving your product, carefully verify all package contents, especially if multiple batteries were expected, to ensure everything is included.
  • Customization: If you plan to customize your RC car, such as changing wheels, ensure you research and purchase compatible parts.

9. Warranty and Support

For warranty information and technical support, please refer to the seller's policies or contact the retailer directly. Keep your proof of purchase for any warranty claims.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.