1. Introduction
Thank you for choosing the LEHX 7-inch Android Car Media Player. This manual provides detailed instructions for installation, operation, and troubleshooting to ensure you get the best experience from your device. Please read this manual carefully before installation and use.
2. Safety Information
- Ensure the vehicle's engine is off and the parking brake is engaged before installation.
- Disconnect the vehicle's battery to prevent electrical shorts or damage.
- Always use appropriate tools and follow safety guidelines.
- If you are unsure about any part of the installation, seek professional assistance.
- Do not operate the device in a way that distracts you from driving.
3. Package Contents
Verify that all items are present in your package:
- 1x Car Android GPS Media Player
- 2x USB cables (L6/L7Plus models) or 3x USB cables (L6Pro model)
- 1x GPS antenna
- 1x RCA cables (L6/L7Plus models) or 2x RCA cables (L6Pro model)
- 1x Camera cable
- 1x Cable adapter
- Mounting brackets (optional, 7" frame)

4. Setup and Installation
Before permanent installation, it is recommended to test the device to ensure proper functionality after transit.
4.1 Rear Interface Description
The following diagram illustrates the rear connections of the media player:

Wiring Notes:
- When the yellow B+ line and the red ACC line both receive a 12V positive power supply, the unit will power on normally.
- The yellow B+ line maintains power to the unit, enabling memory function.
- Ensure speaker cables are not grounded, shared, or touching other lines to prevent sound distortion, overheating, or no sound output.
4.2 CANBUS Connection
For vehicles equipped with CANBUS, connect the CANBUS box as shown. If the CANBUS box and black buckle are connected simultaneously, it may cause the radio to fail to shut down after the car is turned off.

4.3 Reversing Camera Installation
Follow these steps to install the reversing camera:
- Identify the reversing video input socket (yellow cable ①) on the navigation unit.
- Connect the red cable ② to the reverse detection line (BACK or REVERSE) of the navigation adapter.
- Connect cables ③ and ④ together, then connect them to the positive pole of the reverse light power supply.
- Connect the black cable ⑤ to the body screw for ground or the negative pole of the reverse light power supply.

Important: If the reversing camera is not installed, do not connect the REVERSE/BACK cable to any place. Leave the cable unconnected to prevent display issues or the unit from entering reverse mode automatically.
5. Operation
5.1 User Interface (UI)
The device features a QLED touch screen with various customizable interfaces. You can navigate through apps, settings, and media playback with ease.

The UI supports multiple color displays for buttons, allowing for personalization.

5.2 CarPlay and Android Auto
The device supports both wired and wireless CarPlay and Android Auto for seamless smartphone integration.

Wired Connection: Simply connect your smartphone via a USB data cable to automatically enter the CarPlay or Android Auto interface.
Wireless Connection: First, enable Bluetooth and Wi-Fi on your smartphone, then connect via Bluetooth. The system will automatically enter the CarPlay or Android Auto interface. Note that the signal is transmitted via Wi-Fi, so it will function normally even if Bluetooth is turned off. Disconnecting Wi-Fi will disconnect CarPlay/Android Auto.
5.3 Steering Wheel Controls
The device supports learning steering wheel controls. To configure:
- Press and hold a button on your original car's steering wheel.
- Find the corresponding button icon on the device's screen.
- Click the icon to change its color, indicating successful learning.

5.4 GPS Navigation
The unit supports offline and online GPS navigation. It comes with pre-installed offline maps and can be permanently updated for free. Supports popular navigation apps like Waze, Navitel, Yandex, and iGO.

5.5 Multimedia Playback
The device supports various digital media formats including CD, DVD-R/RW, DVD-RAM, VIDEO CD, Mp3, MP4, WMA, JPEG. You can play music and videos from USB drives or other sources.
The device also supports DAB+ radio with an optional receiver stick for high-quality digital audio broadcasting.

5.6 Advanced Features
- DSP (Digital Sound Processor): Provides high-quality audio processing with various sound settings and equalizer options. L6 Pro models feature 5.1 channel DSP with DTS HiFi digital audio authorization for surround sound.
- ADAS DVR: Supports 1080P video recording with clear night vision. Provides reminders for collision avoidance and lane departure.
- Automatic Reverse Parking View: Automatically switches to the backup camera view with parking lines when the car is in reverse.
- OBD2 Support: Compatible with Vgate Icar2 Bluetooth and ELM327 V1.5 for vehicle diagnostics.
- Video Output: Supports video output for headrest connections (L6 models). For other models (LQ/L6X/L6 Plus/L5 Pro/L6 Pro), an additional USB adapter may be required.
- Bluetooth 5.1: Built-in smart Bluetooth system for mobile phone pairing, music streaming, hands-free calling, and clear calls.
- Dual SIM Socket: L6 Pro models support the installation of two SIM cards (integrated and external cable).







5.7 UI Demo Video
6. Maintenance
- Keep the screen clean using a soft, dry cloth.
- Avoid exposing the device to extreme temperatures or direct sunlight for prolonged periods.
- Ensure all connections are secure to prevent intermittent issues.
- Regularly check for software updates to improve performance and add new features.
7. Troubleshooting
7.1 Common Problems and Simple Troubleshooting
If you encounter issues with your device, refer to the following common problems and solutions:
1. Cannot boot normally
- Wiring Check: Ensure the yellow wire (positive), red wire (key control), and black wire (negative) are all correctly connected. Incorrect or loose connections can prevent booting.
- Fuse Check: If the 3 wires are correctly connected but the unit doesn't boot, check the fuse on the yellow wire. If the fuse is blown, replace it. If the fuse is fine, twist the yellow and red wires together, turn on the key, and press the power button to test.
- Unit Damage: If the unit still doesn't boot after checking wiring and fuse, the unit may be faulty.
2. Automatic shut-down
- Cable Error: If the blue cable (automatic antenna power supply) is connected to the unit's power cable, it may cause automatic shutdown. Ensure correct wiring.
- Unstable Voltage: Check the power supply (12V-5A). If the voltage is unstable, replace the power supply.
3. Noise Issues
- Speaker Power: If the original speaker power is too low, increasing the volume may cause noise. Avoid excessively high volumes.
- Grounded Speaker Cable: Ensure speaker cables are not grounded.
4. Remote control not working
Test the remote by pointing it at your phone camera and pressing a button. If the phone screen lights up, the remote is working. If not, replace the battery.
5. Settings not saved (no memory)
- Wiring Check: Ensure the yellow wire (positive) and red wire (key control) are correctly connected and not reversed.
6. Bluetooth not working
Turn on the unit, search for its Bluetooth name on your phone, and connect. If connected, you should be able to make calls and play music. If not, check Bluetooth settings on both devices.
7. Product emits smoke
Immediately replace the FUSE. If the problem persists, the internal circuit may be burned. Professional service is required.
8. Sound cannot be adjusted
- Reset: Reset the unit or unplug and replug the power cord.
- Volume Knob: If the volume knob is broken, it can be replaced.
9. Reversing camera does not display
- Wiring Check: Ensure the camera is correctly wired and all cables are connected.
- Camera Fault: If the camera is properly wired but the lamp does not light up, the camera may be faulty and needs replacement.
10. USB devices cannot be played
Format the USB flash drive to FAT32. Re-download songs and try again. If it still doesn't work, replace the USB flash drive.
11. FM does not receive radio stations
- Antenna Connection: Ensure the antenna plug is fully inserted. Check if the antenna is disconnected or the line is faulty.
- Station Search: Use the 'AS' button for automatic search or manually search using the 'before' or 'after' buttons.
- If the above doesn't resolve the issue, unplug the antenna plug and try inserting a screwdriver or metal strip in its place to test.
12. No sound right after installation
If there is no sound immediately after installation, it is usually a wiring error or the original car speaker wire is short-circuited with iron. Check the speaker cables for shorts and reconnect. Verify the number of speaker cables matches the original car's wiring (e.g., 2 speakers need 4 cables).
13. No sound after a while
Disconnect all speaker cables from the unit (do not remove them). Connect an external speaker to the gray and purple wires of the tail line. Test if there is sound. If there is sound, the car's speaker line is short-circuited or the speaker is damaged. If there is no sound, the unit is broken.
8. Specifications
| Feature | Specification |
|---|---|
| Display Size | 7 inches |
| Resolution | QLED (1280*720) |
| Operating System | Android 16 |
| RAM | 8G (various configurations available, e.g., 4GB) |
| ROM | 256G (various configurations available, e.g., 64GB) |
| CPU | L6 Pro: 7862 64BIT 8 Core; L7 Plus/L5 Pro: UIS8581 64BIT 8 Core; L6X/LQ: UIS8141 4 Core; L6: MTK8227L 4 Core |
| Out Power | 50x4 |
| Voltage | 12 V |
| Item Weight | 1.3kg |
| Max External Memory | 256G |
| Material | ABS+ |
| Din Type | Double Din |
| Built-in Features | WIFI, GPS, Built-in Screen, Touch Screen |
| Special Features | Wifi function, Support steering wheel control, Built-in GPS, Mobile Phone, MP3 players, Voice Control, DSP, CarPlay, Android Auto, Reversing Input, Split Screen |
| Digital Media Format | CD, DVD-R/RW, DVD-RAM, VIDEO CD, Mp3, MP4, WMA, JPEG |
| OSD Language | Multi-language support including English, Spanish, French, German, Italian, Russian, etc. |
| Certification | CE |
| Package Dimensions | 28cm (Length) x 14cm (Width) x 17cm (Height) |
9. User Tips
- Wireless CarPlay/Android Auto: Ensure both Bluetooth and Wi-Fi are enabled on your phone for seamless wireless connection. The system primarily uses Wi-Fi for data transmission.
- Boot Logo Customization: You can change the boot logo via Configuration -> Car Information -> General -> Boot Logo. Use password 8888 for L6/L6Plus models and 3368 for L6Pro models.
- Professional Installation: It is highly recommended to have the device installed by professionals to avoid any damage to your car's dashboard or the device itself.
10. Warranty and Support
This product comes with a 1-year warranty.
For any technical assistance or further inquiries, please contact our customer service. You can reach us through the following channels:
- WhatsApp: Scan the QR code for direct support.
- YouTube: Scan the QR code for video tutorials and demonstrations.
- TikTok: Scan the QR code for short guides and tips.
- Instagram: Scan the QR code for updates and community interaction.

You can also refer to the official user manual in PDF format for more detailed information: View User Manual (PDF)