Introduction
Thank you for choosing the Homcom Rotating Massage Chair. This chair is designed to provide ultimate relaxation with its 8-point vibration massage, lumbar heating, reclining, rocking, and 360-degree swivel functions. Crafted with comfortable PU leather upholstery, it also features integrated cup holders and a convenient side pocket for your remote control. Please read this manual carefully before assembly and use to ensure safe and optimal operation.


Setup and Assembly
This massage chair requires assembly. While specific step-by-step instructions are not provided in this document, please follow the detailed assembly guide included in your product packaging. Ensure all components are present and undamaged before beginning assembly.
General Assembly Guidelines:
- Unpack all parts and lay them out on a clean, soft surface to prevent scratches.
- Identify all hardware (screws, bolts, washers) and tools required.
- Attach the base to the chair body, ensuring it is stable and secure.
- Connect any electrical components for massage and heating functions as per the included wiring diagram.
- Ensure all connections are tight and secure before use.
Operating Instructions
Your Homcom Rotating Massage Chair offers several features for personalized comfort.
1. Reclining Function
To recline the chair, locate the pull-tab usually found on the side of the chair (often on the right side). Pull the tab to release the locking mechanism, then lean back to your desired angle (up to 145 degrees). The footrest will extend automatically. To return to the upright position, push back with your legs and body, and the footrest will retract.

2. Massage and Heating Functions
The chair features 8 vibration massage points located on the back, waist, thighs, and calves, along with a lumbar heating function. These functions are controlled via the included remote control.

- Power On/Off: Press the power button on the remote to activate or deactivate the massage and heating functions.
- Massage Modes: Use the 'MODE' button to cycle through the available massage modes.
- Intensity Levels: Adjust the massage intensity using the 'INTENSITY' buttons.
- Massage Points: Select specific massage areas (back, waist, thighs, calves) using the corresponding buttons on the remote.
- Lumbar Heating: Activate the heating function for the lumbar area by pressing the 'HEAT' button.
- Timer: Some models may include a timer function (e.g., 15, 30, 60 minutes). Refer to your remote for specific timer options.
3. Swivel and Rocking Functions
The chair is designed to rotate 360 degrees on its base, allowing for easy movement and positioning. It also features a gentle rocking motion for added relaxation.
Care and Maintenance
Proper care will extend the life and appearance of your massage chair.
- Cleaning: For the PU leather upholstery, wipe regularly with a soft, damp cloth. For stubborn stains, use a mild soap solution and wipe dry immediately. Avoid harsh chemicals or abrasive cleaners.
- Spills: Blot spills immediately with a clean, dry cloth. Do not rub.
- Sunlight: Avoid prolonged exposure to direct sunlight to prevent fading and material degradation.
- Moving the Chair: When moving the chair, lift it rather than dragging it to prevent damage to the base and flooring.
- Electrical Components: Ensure the power cord is not pinched or damaged. Unplug the chair when not in use or during cleaning.

Troubleshooting
If you encounter any issues with your massage chair, please refer to the following common solutions.
| Problem | Possible Cause | Solution |
|---|---|---|
| Chair does not recline | Recline mechanism locked or obstructed. | Ensure the pull-tab is fully engaged. Check for any obstructions under the chair or footrest. |
| Massage/Heating not working | Power cord unplugged, remote batteries dead, or connection issue. | Check if the chair is properly plugged into a working outlet. Replace remote control batteries. Ensure all electrical connections are secure. |
| Unusual noises during operation | Loose components or friction in moving parts. | Inspect the chair for any loose screws or bolts and tighten them. If the noise persists, contact customer support. |
Specifications
Below are the key specifications for the Homcom Rotating Massage Chair.
| Feature | Detail |
|---|---|
| Color Options | Black, White |
| Material | PU Leather, Steel, Foam |
| Overall Dimensions (Upright) | 82 cm (L) x 99 cm (W) x 103 cm (H) |
| Reclined Dimensions | 82 cm (L) x 165 cm (W) x 78 cm (H) |
| Seat Dimensions | 54 cm (L) x 57 cm (W) |
| Seat to Floor Height | 49 cm |
| Maximum Tilt Angle | 145° (from the back) |
| Input Voltage | 100-240V, 50-60Hz |
| Cable Length | 1.8 m |
| Maximum Load Capacity | 135 kg |
| Installation Method | Assembly |
| Sofa Width | <2000mm |
| Specific Use | Living Room Sofa |
| Type | Living Room Furniture |
| Combination | SINGLE |
| Appearance | Modern Style |


Warranty and Support
For warranty information, please refer to the documentation provided with your purchase or contact the seller directly.
If you require technical assistance, have questions about assembly, or need to report a missing/damaged part, please contact the Aosom Spain (EU) Store customer service.
User Tips
No specific user tips were available from reviews or Q&A for this product. However, here are some general tips for maximizing your experience:
- Experiment with different massage modes and intensity levels to find what works best for you.
- Utilize the lumbar heating function for enhanced relaxation, especially after a long day.
- Keep the remote control in the side pocket when not in use to prevent misplacement.
- Place the chair in a location that allows for full recline and swivel motion without obstruction.