1. Introduction
Thank you for choosing the CENGCEN Cordless Cat Water Fountain. This innovative pet drinking fountain is designed to provide your feline companions with a continuous supply of fresh, filtered water, promoting hydration and health. Its cordless design offers unparalleled placement flexibility, while dual operating modes and a long-lasting battery ensure convenience and energy efficiency. Please read this manual thoroughly before use to ensure proper setup and operation.
2. Important Safety Instructions
- Always place the fountain on a stable, level surface.
- Do not immerse the main unit (pump/battery housing) in water.
- Ensure the charging port is dry before connecting the charging cable.
- Keep out of reach of children and pets when not in use or during maintenance.
- Use only the provided charging cable and adapter (if included) to charge the device.
- Do not operate the fountain if any part is damaged or malfunctioning.
- For indoor use only.
3. Package Contents
Please check the package to ensure all items are present and in good condition:
- Cordless Cat Water Fountain (Main Unit & Water Reservoir)
- Water Spout attachment
- Splash Ring attachment
- Filter Cartridges (2 included)
- Charging Cable
- User Manual

4. Setup Guide
Follow these steps to set up your cat water fountain:
- Charge the Fountain: Before first use, fully charge the fountain's internal 5000mAh battery. Connect the charging cable to the fountain's charging port and a suitable power source. The precise power display on the top panel will indicate the charging status. A full charge takes approximately 5 hours.
- Install Filters: Open the water reservoir and locate the filter housing. Insert the two filter cartridges into their designated slots. These dual filters are designed to last 4-5 weeks.
- Assemble Water Flow:
- For a natural, gentle flow, attach the curved water spout to the pump outlet.
- To create bubbling sounds and attract curious cats, swap the curved spout for the splash ring.
- To return to quiet operation, remove the splash ring and re-attach the curved spout.
- Fill Water Reservoir: Fill the water reservoir with fresh water up to the 'MAX' line, ensuring not to overfill. The fountain has a capacity of 108oz (3.2L).
- Place the Fountain: Position the assembled fountain on a flat, stable surface in your desired location. Its cordless design allows for placement anywhere without needing an electrical outlet nearby.

5. Operating Instructions
The fountain features a one-touch control button and offers two operating modes:

5.1. Sensor Mode (Wireless Operation)
- This mode is ideal for saving energy and encouraging pets to drink.
- When a cat is detected within 6 feet of the fountain, the water flow will automatically activate for 30 seconds.
- The fountain will then return to standby until motion is detected again.
- This mode is powered by the internal battery, offering up to 30 days of runtime on a single charge.

5.2. Continuous Flow Mode (Wired Operation)
- To activate continuous flow, double-tap the one-touch control button.
- In this mode, the water will flow continuously.
- This mode is typically used when the fountain is plugged in and charging, ensuring uninterrupted operation.

5.3. Power Display
- The LED display on the top panel shows the exact remaining battery percentage, eliminating guesswork.
- Recharge the fountain when the battery level is low to ensure continuous operation.

6. Maintenance
6.1. Cleaning the Fountain
- It is recommended to clean the fountain at least once a week to maintain hygiene and optimal performance.
- Unplug the fountain (if wired) and remove the main unit from the water reservoir.
- Discard any remaining water.
- Wash the water reservoir, spout, and splash ring with mild soap and water. Rinse thoroughly.
- Wipe the main unit (pump/battery housing) with a damp cloth. Do NOT immerse the main unit in water.
- Ensure all parts are dry before reassembling.
6.2. Filter Replacement
- The dual filter cartridges should be replaced every 4-5 weeks to ensure optimal water quality.
- To replace, remove the old filters from the housing and insert new ones.
- Replacement filters can be found by searching for "B0DBZG6V4Z".
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Fountain not dispensing water. | Low battery, water level too low, pump clogged, or not in continuous mode when wired. | Charge the battery, refill water to MAX line, clean the pump, or double-tap for continuous flow. |
| Water flow is weak. | Clogged filter, low water level, or dirty pump. | Replace filters, refill water, or clean the pump. |
| Fountain is noisy. | Low water level, dirty pump, or improper assembly. | Refill water, clean the pump, or reassemble components correctly. |
| Sensor mode not activating. | Obstruction in sensor path, sensor malfunction, or low battery. | Ensure clear path to sensor, charge battery. If problem persists, contact support. |
8. Specifications
| Feature | Detail |
|---|---|
| Model Number | WF230D2F |
| Brand | CENGCEN |
| Capacity | 108 oz (3.2 Liters) |
| Power Source | Battery (1 x 12V included) |
| Battery Type | 5000mAh |
| Battery Runtime | Up to 30 days (720 hours) |
| Charging Time | Approx. 5 hours |
| Material | Plastic |
| Water Dispenser | Yes |
| Max Water Output | 100g |
| Min Water Output | 50g |
| LCD Display | No (Features LED power percentage display) |
| Smart Device | No |
| Dimensions (Package) | 12.05 x 6.3 x 5.08 inches |
| Weight (Package) | 2.2 Pounds |
9. Warranty and Support
The CENGCEN Cordless Cat Water Fountain comes with a 12-month stress-free warranty, which includes one free pump replacement. For any questions, issues, or support needs, please contact CENGCEN customer service. Lifetime support is provided for this product.