1. Introduction
Thank you for purchasing the LDARC S100 1:64 RC Mini Vehicle and CT03 2.4Ghz 10CH Remote Controller. This manual provides essential information for the safe operation, setup, and maintenance of your new RC car. Please read it thoroughly before use to ensure optimal performance and longevity of your product.
2. Safety Information
- WARNING: Not suitable for children under 36 months due to small parts.
- Always operate the RC vehicle in open areas, away from people, pets, and obstacles.
- Avoid operating near water or in wet conditions to prevent damage to electronic components.
- Adult supervision is recommended for children operating the RC vehicle.
- Do not attempt to modify or disassemble the product, as this may void the warranty and cause damage.
- Ensure the vehicle and remote controller are fully charged before each use.
3. Package Contents
The contents of your package may vary depending on the version purchased (RTR or BNR).
Figure 3.1: Package Contents Diagram
3.1. RTR Version (Ready-to-Run)
- S100 Vehicle *1
- CT03 Transmitter *1
- RTR174 Handbag *1
- Manual *1
- Tool *1
- Accessories *3
- Sticker *1
3.2. BNR Version (Bind-and-Run)
- S100 Vehicle *1
- Manual *1
- Tool *1
- Accessories *3
- Sticker *1
Note: For the BNR version, the transmitter needs to be purchased separately.
4. Product Overview
4.1. LDARC S100 Mini Vehicle
The S100 is a 1:64 scale mini racing car featuring a realistic design, rear-wheel drive, and a comprehensive light system. It is equipped with a built-in battery and durable components for an engaging driving experience.
Figure 4.1: S100 Mini Vehicle and CT03 Remote Controller
4.2. CT03 Remote Controller
The CT03 is a 2.4Ghz 10-channel remote controller designed for precise control of the S100 vehicle. It features an LCD screen for displaying important information, ergonomic handwheel angle, and various control buttons for different functions.
Figure 4.2: CT03 Remote Controller Layout
- Steering Wheel (R): Controls forward and backward movement.
- [OK] key: Confirmation button.
- A: Light switch.
- TH: Throttle Beginner mode (Low/Middle/High).
- ST: Steering Beginner mode (Direction Small/Middle/Big).
- E: High and low beam switch.
- D: Emergency flashers/turn signal light switch.
- Power (on/off) & charge light: Indicates power status and charging.
- USB-C (5V): Charging port for the remote controller.
- Rear light: Indicator light.
5. Specifications
Figure 5.1: S100 Vehicle and CT03 Remote Controller Specifications
5.1. S100 Data
| Feature | Specification | Feature | Specification |
|---|---|---|---|
| Model | S100 | Outside tread size | 32/34mm |
| Material | Electronics, Metal, Plastic | Battery | 3.7V 95mAh |
| Weight | ~28g | Tire diameter | 11.6mm |
| Size | 75*35*21mm | Gear ratio | 1:8 |
| Wheelbase | 39mm | Min ground clearance | 1.36mm |
| Remote control distance | ~30m | Max speed | ~1m/s |
| Noise | <=65dB | Driver type | RWD |
| Scale | 1:64 | State of Assembly | Ready-to-Go |
| Flight Time | 60min | Is Batteries Included | No (Built-in battery for car) |
| Type | Car | Features | Remote Control |
| Recommend Age | 14+y | Is Electric | No Battery (Built-in) |
| High-concerned chemical | None | Design | Cars |
5.2. CT03 Data
| Feature | Specification | Feature | Specification |
|---|---|---|---|
| Model | CT03 | Screen | LCD |
| Channel | 10 | Weight | ~168g |
| RF | 2.4GHz | Size | 105*87*155mm |
| RF Protocol | O2 | Material | Electronics, Metal, Plastic |
| Throttle servo | CT03 | Remote Control | Yes |
6. Setup
6.1. Charging the S100 Vehicle
- Locate the USB-C charging port on the underside of the S100 vehicle.
- Connect the provided USB-C cable to the vehicle and a compatible 5V USB power source (e.g., computer USB port, USB wall adapter).
- The vehicle's lights may indicate charging status. A full charge typically takes approximately 60 minutes.
- Once fully charged, disconnect the USB-C cable.
Figure 6.1: USB-C Charging for S100 Vehicle
6.2. Charging the CT03 Remote Controller
The CT03 remote controller is also rechargeable via USB-C.
- Locate the USB-C (5V) port on the side of the CT03 remote controller (refer to Figure 4.2).
- Connect a USB-C cable to the remote and a compatible 5V USB power source.
- The 'charge light' will indicate the charging status.
- Once fully charged, disconnect the cable.
6.3. Binding (Pairing)
The S100 vehicle and CT03 remote controller are typically pre-bound from the factory. If they do not connect automatically, follow these general binding steps:
- Ensure both the vehicle and remote controller are fully charged and powered off.
- Turn on the remote controller.
- Turn on the S100 vehicle.
- Observe the indicator lights on both devices. They should stop flashing and become solid, indicating a successful connection.
- If binding fails, refer to the specific binding instructions in the included manual (if different from these general steps).
7. Operating Instructions
7.1. Basic Driving
- Place the S100 vehicle on a flat, clear surface.
- Ensure the remote controller is powered on and successfully bound to the vehicle.
- Use the steering wheel (R) to control the vehicle's direction (forward/backward) and speed. The S100 features full proportional control for precise handling.
- The vehicle is rear-wheel drive (RWD).
7.2. Using Beginner Modes
The CT03 remote controller offers beginner modes for throttle (TH) and steering (ST) to help new users get accustomed to driving.
- TH (Throttle Beginner mode): Press the TH button to cycle through Low, Middle, and High settings to adjust the maximum throttle output.
- ST (Steering Beginner mode): Press the ST button to cycle through Small, Middle, and Big settings to adjust the steering sensitivity and turning radius.
7.3. Light System Operation
The S100 vehicle is equipped with a comprehensive light system.
Figure 7.1: S100 Features - Working Time, Light System, Smaller Turning
- A (Light switch): Use this button on the remote to turn the vehicle's lights on or off.
- E (High and low beam): Toggle between high and low beam headlights.
- D (Emergency flashers/turn signal light switch): Activate emergency flashers or turn signals.
- The light system includes headlights, tail lights, turn signals, brake lights, and reverse lights for a realistic experience.
7.4. Battery Protection System
The S100 vehicle features a battery protection system. When the battery voltage is low, the front and rear lights will flash quickly, and the vehicle will not be able to drive. This indicates it's time to recharge the vehicle.
Figure 7.2: Battery Protection and Signal Display
The CT03 remote controller's LCD screen displays real-time voltage and signal strength, allowing you to monitor the vehicle's status and anticipate when a recharge is needed.
Video 7.1: Product demonstration video showing the LDARC S100 RC Mini Vehicle and CT03 Remote Controller in action.
8. Maintenance
8.1. General Care
- Keep the vehicle and remote controller clean and free from dust and debris. Use a soft, dry cloth for cleaning.
- Store the product in a cool, dry place away from direct sunlight and extreme temperatures.
- Always turn off both the vehicle and remote controller when not in use.
8.2. Performance Structure
The S100 is designed with robust components for reliable performance:
Figure 8.1: RC Performance Structure
- Independent servo: Ensures precise steering and easy maintenance.
- Spur gear transmission: Provides smoother sliding with loose oil.
- Rear suspension ball joint structure: Enhances simulated posture.
- 4 bearings: Installed for smoother rotation.
- Front independent suspension: Keeps tires close to the ground.
- Rear integral bridge: Features a large twisting stroke.
9. Troubleshooting
- Vehicle not responding: Ensure both the vehicle and remote controller are powered on and fully charged. Check if they are properly bound.
- Vehicle lights flashing and not driving: This indicates a low battery. Recharge the S100 vehicle immediately.
- Poor control range: Ensure there are no obstructions or strong interference sources (e.g., Wi-Fi routers, other RC devices) in the operating area. Check the signal strength display on the CT03 remote.
- Vehicle not moving straight: Adjust the steering trim on the remote controller if available, or recalibrate the steering.
10. User Tips
- Play Anywhere: The compact size of the S100 makes it suitable for 'desktop decompression' and playing in various indoor environments.
- Display & Collect: The detailed design of the S100 also makes it a great item for display and collection.
- Educational Fun: This RC car can be a tool for parent-child interaction and provides educational value in understanding basic mechanics and remote control principles.
- Customization: The vehicle supports DIY painted covers, allowing for personalized customization.
Figure 10.1: User Tips and Applications
11. Compliance
This product complies with relevant safety standards. Please note the following disclaimer:
- Disclaimer: ⚠️ Not suitable for children under 36 months.
12. Warranty and Support
For any questions, technical support, or warranty claims, please contact the seller or manufacturer directly. Keep your proof of purchase for warranty purposes.
