Introduction
This manual provides essential information for the safe operation, maintenance, and troubleshooting of your SAMEBIKE RS-A01 Pro-T Electric Bicycle. Please read this manual thoroughly before your first ride and keep it for future reference.
The SAMEBIKE RS-A01 Pro-T is a 26-inch electric city/mountain bike designed for adults, featuring a 250W motor and a 36V 15Ah removable lithium-ion battery.
Safety Warnings
Always prioritize safety when operating your electric bicycle. Failure to follow these instructions could result in serious injury or property damage.
- Always wear a helmet and appropriate safety gear.
- Obey all local traffic laws and regulations.
- Perform a pre-ride inspection before each use.
- Do not ride under the influence of alcohol or drugs.
- Be aware of your surroundings and other road users.
- Do not exceed the maximum speed limit for electric bicycles in your region.
- Ensure the battery is securely locked in place before riding.
- Avoid riding in extreme weather conditions.
Setup and Assembly
Your SAMEBIKE RS-A01 Pro-T electric bicycle may require some assembly upon arrival. Follow these general steps:
- Unpacking: Carefully remove all components from the packaging. Retain packaging for potential future transport or returns.
- Handlebar Installation: Attach the handlebar to the stem, ensuring it is centered and tightened securely.
- Front Wheel Installation: Install the front wheel, making sure the quick-release skewer or axle nuts are properly tightened. Verify the brake rotor is correctly seated in the caliper.
- Pedal Installation: Identify the left (L) and right (R) pedals. Thread the left pedal counter-clockwise and the right pedal clockwise into the crank arms. Tighten firmly with a wrench.
- Seat Post and Saddle: Insert the seat post into the frame and adjust the saddle height for comfortable riding. Secure with the quick-release lever or bolt.
- Battery Installation: Insert the 36V 15Ah lithium-ion battery into its compartment and lock it securely with the provided key.
- Initial Charge: Fully charge the battery before the first use. Refer to the "Charging the Battery" section for details.
- Brake Adjustment: Check and adjust front and rear disc brakes for proper function and stopping power.
- Tire Inflation: Inflate tires to the recommended pressure indicated on the tire sidewall.
Operating Instructions
Intelligent LCD Display and Controls
The intelligent LCD display provides real-time information and allows control over various functions. Familiarize yourself with the controls before riding.
- Battery Indicator: Shows current battery charge level.
- Speed: Displays current riding speed.
- Boost Mode: Indicates active power assist mode.
- PAS Level: Pedal Assist System level (adjusts motor assistance).
- Mileage: Tracks total or trip distance.
- Headlight Indicator: Shows if the headlight is on.
- Controller Button: Used to navigate display menus and adjust settings.
- USB Charging: Port for charging external devices.
- Throttle: Provides power on demand without pedaling.
- Shimano 7 Speed: Gear shifter for mechanical pedaling.
Riding Modes
Your e-bike offers three distinct riding modes:
- Electric Mode: Turn on the power and rotate the throttle for full speed driving without pedaling.
- Assist Mode (PAS): Turn on the power, and the motor will automatically provide assistance when you pedal. Adjust the PAS level via the display.
- Cycling Mode: Turn off the power and ride the bicycle using pedal power only, like a traditional bike.
Charging the Battery
The 36V 15Ah lithium-ion battery is removable for convenient charging. Charging duration is typically 4-6 hours.
- Connect the charger to the battery charging port.
- Plug the charger into a standard wall outlet.
- The charger indicator light will typically show red during charging and turn green when fully charged.
- Do not overcharge the battery. Disconnect the charger once charging is complete.
- Charge the battery in a well-ventilated area, away from flammable materials.
Maintenance
Regular maintenance ensures the longevity and safe operation of your e-bike.
General Care
- Keep the bicycle clean. Wipe down the frame and components with a damp cloth.
- Avoid using high-pressure washers directly on electrical components.
- Store the bicycle in a dry place, away from direct sunlight and extreme temperatures.
Battery Care
- Charge the battery regularly, even if not in use, to maintain its health.
- Avoid completely draining the battery.
- If storing for an extended period, charge the battery to 50-70% and check it monthly.
Brakes
The e-bike is equipped with front and rear disc brakes for reliable stopping power.
- Regularly check brake pads for wear and replace them when necessary.
- Ensure brake levers are firm and responsive. Adjust cable tension if needed.
- Keep brake rotors clean and free from oil or grease.
Tires
- Check tire pressure before each ride. Maintain recommended PSI for optimal performance and safety.
- Inspect tires for cuts, punctures, or excessive wear.
Lighting System
The upgraded 360 lighting system includes a brake light, tail light, reflective sheets (F&R), and reflective strips for enhanced night visibility.
- Ensure all lights are functioning correctly before riding, especially at night.
- Clean reflective surfaces to maintain their effectiveness.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Motor not assisting / No power | Battery low or not connected; Power switch off; Controller issue; Loose wiring. | Check battery charge and connection; Ensure power is on; Inspect all electrical connections. |
| Short battery range | Under-inflated tires; Riding in high assist mode; Frequent stops/starts; Cold weather; Battery degradation. | Inflate tires to correct pressure; Use lower assist modes; Ride smoothly; Charge battery fully. |
| Brakes feel weak | Worn brake pads; Loose brake cables; Contaminated rotors. | Inspect and replace brake pads; Adjust brake cable tension; Clean rotors with disc brake cleaner. |
| Gears not shifting smoothly | Derailleur out of adjustment; Dirty or rusty chain; Damaged shifter cable. | Adjust derailleur; Clean and lubricate chain; Consult a bike mechanic if cable is damaged. |
| LCD display not working | Loose connection; Water damage; Faulty display unit. | Check display cable connection; Ensure display is dry; Contact support if issue persists. |
Specifications
| Feature | Detail |
|---|---|
| Model Number | RS-A01 Pro-T |
| Brand Name | SAMEBIKE |
| Motor Power | 250W |
| Max Speed | <25km/h |
| Battery | 36V 15Ah Lithium Battery (Removable) |
| Range per Power | 31 - 60 km |
| Charging Duration | 4-6 hours |
| Wheel Size | 26 inches |
| Tires | 26" x 2.1 Slim City Tires |
| Brakes | Front and Rear Disc Brakes |
| Suspension | Front Fork Suspension with Lockout, Center Shock Absorber |
| Gears | Shimano 7 Speed Shifting System |
| Display | Smart Color LCD Display (3.5 inch) |
| Lighting System | Upgraded 360 Lighting System (Headlight, Tail light, Brake light, Reflective sheets F&R, Reflective strips) |
User Tips
Based on common user experiences, here are some tips for getting the most out of your e-bike:
- Battery Longevity: To maximize battery life, avoid storing the bike in extremely hot or cold conditions. Charge it regularly, even if you haven't used it for a while.
- Smooth Riding: For better range and a smoother experience, try to pedal consistently in assist mode rather than relying solely on the throttle.
- Gear Shifting: Shift gears proactively, especially when approaching hills, to reduce strain on the motor and battery.
- Pre-Ride Check: Always do a quick check of tire pressure, brakes, and battery security before each ride.
- Visibility: Even with the integrated lighting system, consider adding extra reflective gear or lights for night riding, especially in areas with heavy traffic.
Warranty and Support
SAMEBIKE offers a 1-year warranty for the battery, frame, motor, controller, and other accessories. For warranty claims or technical support, please contact the seller or SAMEBIKE customer service directly.
Ensure you retain your proof of purchase for warranty validation.
