Introduction
Before using the iScooter W3 Electric Scooter, please read this manual carefully. Keep it for future reference. Illustrations of the product, accessories, and user interface in this manual are for reference purposes only. Actual product and functions may vary due to product enhancements.
Disclaimer: Please mind potential fire risk and strictly follow the instruction manual for charging and storage. While using the product, please wear protective equipment and fully comply with the applicable law and regulations.
Video: Overview of the W3 Electric Scooter's features, folding mechanism, and riding experience.
Package Contents
Ensure all items are present and in good condition upon unboxing:
- W3 Electric Scooter
- Charger
- Stem Bolts (6, including 2 spare bolts)
- Hex Wrench
- User Manual & Safety Instructions
- Inner Tube
- Extension Tube

Image: All components included in the W3 Electric Scooter package.
Product Overview
Familiarize yourself with the different parts of your W3 Electric Scooter:

Image: Labeled diagram of the W3 Electric Scooter components.
- Fender Clip
- Bell
- Brake Lever
- Headlight
- Display
- Throttle
- Folding Mechanism
- Charging Port
- Kickstand
- Fender Hook
- Brake Light
Setup
Assembly
To assemble your scooter:
- Raise the stem to the riding position and close the folding latch until you hear a click.
- Install the handlebar assembly onto the stem. Pre-tighten all four bolts, then fully tighten them using the supplied tool (Hex Wrench).

Image: Step-by-step assembly instructions for the W3 Electric Scooter.
Folding and Unfolding
Folding:
- Turn the scooter off.
- Open the folding latch.
- Fold down the stem so that the folding buckle on the handlebar catches the hook on the rear fender.

Image: Folding mechanism of the W3 Electric Scooter.
Unfolding:
- Press the folding buckle to release it from the rear fender.
- Lift the stem to the riding position.
- Close the folding latch until you hear a click.

Image: Unfolding mechanism of the W3 Electric Scooter.
Operating Instructions
Display Overview

Image: Smart LED display showing various indicators.
- Real-time Speed / Error Code: Displays current speed or error codes.
- Speed Unit: Indicates km/h or mph.
- Riding Mode: Shows current driving mode (ECO, D, S).
- Headlight: Indicates if headlights are on.
- App Connected: Shows connection status to the Voltix app.
- Motor Overheating: Warning indicator for motor temperature.
- Battery Level: Displays remaining battery charge.
- Cruise Control: Indicates if cruise control is active.
- Error Prompt: General error indicator.
Basic Operations
- Power ON/OFF: Press and hold the Power button for 2 seconds.
- Headlight ON/OFF: While the scooter is powered on, press the Power button once to turn on/off the headlight and taillight.
- Switch Riding Mode: Press the Power button twice to cycle through modes.
- Switch Speed Unit: Press the Power button 3 times to switch between km/h and mph.
- Switch Start Mode: Press the Power button 4 times to switch between zero-start and non-zero start.
- Cruise Control ON/OFF: Press the Power button 5 times.
Driving Modes

Image: Driving modes and their speed limits.
| Riding Mode | Max Speed (European) | Max Speed (North American) |
|---|---|---|
| Initial | 6 km/h | / |
| ECO | 15 km/h | 6 mph (10 km/h) |
| D | 25 km/h | 12 mph (20 km/h) |
| S | / | 18 mph (29 km/h) |
Unlocking Speed Limit (W3)
To unlock the speed limit for the W3 model:
- Press the brake lever.
- While holding the brake lever, press the power button 5 times in a row.
- Release the brake lever. You can now switch modes freely, accessing higher speeds if available for your region.
To restore the speed limit when necessary, repeat the same operation.
Charging

Image: Charging port location and charger connection.
- The scooter is fully charged when the charger indicator changes from red to green.
- Do not overcharge the scooter.
- Keep the charging port cover closed when not charging.
- During charging, the scooter cannot be turned on.
- For safety, never charge the scooter in the rain.
Maintenance
Regular maintenance ensures the longevity and safe operation of your scooter.
- Cleaning: Wipe down the scooter with a damp cloth. Do not use high-pressure water or immerse the scooter in water.
- Tires: The 8.5-inch honeycomb tires are puncture-proof and low-maintenance. Regularly check for wear and tear.
- Brakes: Periodically check the electronic and disc brakes for proper function and adjust if necessary.
- Fasteners: Ensure all bolts and screws are securely tightened before each ride.
- Storage: Store the scooter in a dry, cool place away from direct sunlight and extreme temperatures.
Troubleshooting: Error Codes
The display may show error codes if a fault occurs. Refer to the table below for common error codes and their definitions. If you encounter any of these or other error codes, contact support for assistance.
| Code | Definition |
|---|---|
| E10 | Communication Fault |
| E14 | Throttle Fault |
| E15 | Brake Lever Fault |
| E16 | Motor Hall Sensor Fault |
| E50 | Over-voltage |
Specifications

Image: Detailed specifications table for the W3 Electric Scooter.
| Feature | Specification |
|---|---|
| Model | W3 |
| Unfolded Size | 105 x 45 x 110 cm (41.3 x 17.7 x 43.3 in) |
| Folded Size | 105 x 45 x 49 cm (41.3 x 17.7 x 19.3 in) |
| Net Weight | 10.4 kg (22.9 lbs) |
| Battery Capacity | DC 36V, 7.8Ah |
| Motor Power | 350W |
| Wheel Diameter | 8.5 Inches (21.6 cm) |
| Range Per Charge | 24-34 km (15-21 miles) |
| Maximum Load Capacity | 100 kg (220 lbs) |
| Working Temperature | -2°C to 35°C (28.4°F to 95°F) |
| Charger Input | AC 100-240V, 50/60Hz |
| Charger Output | DC 42V, 1A |
| Charging Time | 5-6 hours |
| Waterproof Rating | IPX4 |
| Recommended Age | 14+ |
Safety Notes
Always prioritize safety when operating your electric scooter.
- Wear protective equipment, including a helmet, at all times.
- Comply with all local laws and regulations regarding electric scooter use.
- Avoid sudden braking.
- Cruise Control Warning: To disengage cruise control, briefly squeeze the brake lever (do not hold it) or quickly press the thumb throttle and release it immediately.
- The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
- Children should be supervised to not play with the appliance.
User Tips
- Assembly: While the manual provides instructions, some users find video tutorials helpful for initial setup.
- App Connectivity: The scooter supports smart connectivity via the "Voltix" app. Download and install the app to monitor your ride and customize settings.
- Speed Limits: Be aware that speed limits may vary by region (e.g., European vs. North American markets). The scooter may have an unlockable speed boost, but always adhere to local regulations.
- Battery Life: Actual range per charge can vary based on factors like rider weight, terrain, wind speed, and riding habits.
- Packaging: Always inspect the packaging and contents upon arrival for any damage.
Compliance and Support
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not explicitly approved by the manufacturer could void your authority to operate this equipment.
FCC ID: 2BM88-W3
CE Warning
The W3 Electric Scooter is CE certified, indicating compliance with European safety standards.
Disposal of Electrical and Electronic Equipment
The crossed-out garbage can symbol indicates that you are legally obliged to dispose of these devices separately from unsorted municipal waste. Disposal via the residual waste bin or the yellow bin is prohibited. If the products contain batteries or rechargeable batteries that are not permanently installed, they must be removed before disposal and disposed of separately as a battery.
Manufacturer Information
Manufacturer: Dongguan Yicheng Shengda Information Technology Co., Ltd.
Address: Room 301, No. 28, Houshan Road, Nanchongkou, Humen Town, Dongguan City, Guangdong Province, China
E-mail: support@e-scootworld.com
For the full text of the EU Declaration of Conformity, please contact our support team at support@e-scootworld.com.
User Manual PDF: A detailed user manual in PDF format is available for download. Please refer to the official product page or contact support for the link: View User Manual (PDF)