Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your Flytec V802 PRO Circuit Board Set, designed for RC GPS fishing bait boats. This set includes both the boat's receiving circuit board (V802-RX) and the remote control's transmitting circuit board (V802-TX).
Components Overview
The Flytec V802 PRO Circuit Board Set consists of the following main components:
- V802-03 GPS Version Boat Circuit Board (Receiving Board): This board is installed within the bait boat and manages all boat functions, including motor control, GPS, lights, and hopper release.
- V802-01 GPS Version Remote Control Circuit Board Assembly (Transmitting Board): This board is part of the remote control unit, allowing you to wirelessly control the bait boat. It includes a display screen for real-time information.
Boat Circuit Board (V802-03)

Key components and connections on the V802-RX board:
- Front Light
- Right Rear Light
- Left Rear Light
- GPS Module
- Battery Indicator
- Switch
- Battery
- Left Motor
- Right Motor
- Right Front Silo
- Left Front Silo
- Right Rear Silo
- Left Rear Silo
- ANT (Antenna Connection)
Remote Control Circuit Board Assembly (V802-01)

This assembly includes the main circuit board and the display screen. The overall dimensions of the circuit board are 13*11*2.1cm, and the display screen measures 5.7*3.8*0.7cm.
Setup and Pairing
Before operating your bait boat, the boat's circuit board and the remote control board must be correctly paired. Follow these steps:
- Prepare the Boat: Place the bait boat on a flat, stable surface.
- Position the Remote Control: Keep the remote control at least 0.5 meters away from the boat.
- Power On the Boat: Turn on the power switch on the boat. Observe the tail light; it should be flashing.
- Power On the Remote Control: Turn on the remote control.
- Pairing Confirmation: Once the remote control emits a "beep" sound, the indicator light on the remote control will turn solid green, and the boat's light will also be solid on. This indicates a successful connection. The boat light icon will be displayed on the remote control interface, but the GPS icon will not be displayed at this stage.

Note: If pairing is unsuccessful or the remote control disconnects from the boat, turn off the power of both the boat and the remote control, then repeat the pairing operation.
Operating Instructions
The Flytec V802 PRO bait boat offers advanced features for efficient fishing. Familiarize yourself with the remote control and boat functions.
Remote Control Layout and Functions
The multi-function remote control with a screen provides comprehensive control and real-time feedback. Key controls include:
- Antenna: For stable signal transmission.
- Lighting Button: Controls the boat's lights.
- Power Indicator: Shows remote control power status.
- Left Joystick: Controls boat movement (forward/backward, left/right).
- Right Joystick: Typically controls additional functions or fine-tuning.
- Front Left Silo / Front Right Silo / Back Left Silo / Back Right Silo: Buttons for independently releasing bait from the four hoppers.
- Switch: Power on/off for the remote control.
- Calibration: For calibrating the boat's positioning system.
- Cruise Button: Activates cruise control for constant speed navigation.
- Original Point Button: Sets or returns to the origin point.
- Delete Button: Used to delete saved anchor points or fishing grounds.
- OK Button: Confirms selections on the display.
- Directional Buttons (Up, Left, Right, Down): For navigating menus on the display.
- Fishing Ground Button: Accesses fishing ground settings.
Navigation and Control
- Stable Navigation: The boat features a built-in high-precision gyroscope for automatic correction of yaw, ensuring stable navigation even in varying water conditions.
- Cruise Control Function: Easily sail in a straight line at a constant speed, saving time and effort.
- Anchor Point Cruising: The boat can automatically cruise between preset fishing points, improving fishing efficiency. You can set up to 4 fishing grounds and 160 anchor points to meet diverse fishing needs.
- Real-time Sailing Distance: The remote control's screen provides real-time transmission of sailing distance, which can be used for water distance measurement.
- GPS One-Click Return: With a single button press, the boat can easily return to its origin point, ensuring safe navigation.
- Electronic Fence Function: After setting the origin, the boat will activate an electronic fence function, preventing it from sailing out of a safe distance of 500m.
Bait Delivery and Hook Placement
- Bait Loading Capacity: The boat has a bait loading capacity of 3kg.
- Independent Hoppers: Four hoppers are independently controlled for precise feeding.
- Hook Attachment: Support for attaching a hook and fishing line allows you to accurately place hooks and improve the success rate of fishing. The boat features a hook attached design at the tail.
Night Operation and Fish Finding
- Night Lights: Bright night lights at the bow and turn signal lights at the tail ensure safer night navigation. Two light modes (constant on and flashing) adapt to different environmental requirements.
- Fish Finder (Optional Upgrade): The boat can be upgraded to a fish finder version. This allows you to detect the location of fish in real-time, aiding efficient fishing. The fish finder typically features a sonar beam angle of 90 degrees, wireless operation up to 100m/328ft, and a depth range of 2-120ft.
Maintenance
- Cleaning: After each use, especially in saltwater, rinse the boat with fresh water and wipe it dry. Ensure no water enters the sealed compartments.
- Battery Care: Always fully charge batteries before storage. If storing for extended periods, charge them every 3 months to maintain battery health. Disconnect batteries when not in use.
- Storage: Store the circuit boards and remote control in a dry, cool place away from direct sunlight and extreme temperatures.
- Inspection: Regularly inspect all connections, wires, and moving parts for any signs of wear, damage, or corrosion.
- Waterproofing: The boat features a fully sealed cabin and battery compartment for super waterproof performance. Ensure all seals are intact and properly closed before placing the boat in water.
Troubleshooting
- Pairing Issues: If the boat and remote control fail to pair (no "beep" sound, indicator light not solid green, boat light not solid on), turn off both devices and repeat the pairing process as described in the Setup section. Ensure they are within 0.5 meters during initial pairing.
- Loss of Signal/Control: Check the remote control's battery level. Ensure the boat's battery is adequately charged. Verify that the antennas on both the boat and remote control are securely attached and undamaged. Avoid operating beyond the 500m remote control distance.
- Boat Not Moving/Motors Not Responding: Check battery connections and ensure batteries are charged. Inspect motor connections on the V802-RX board. Ensure no debris is obstructing the propellers.
- GPS Malfunction/Inaccurate Positioning: Perform a calibration of the GPS system using the remote control. Ensure clear line of sight to the sky for optimal GPS signal reception.
- Low Power Reminder: The remote control will provide a low power automatic reminder. When this occurs, return the boat to shore immediately to avoid insufficient power during operation.
Specifications
| Feature | Specification |
|---|---|
| Brand Name | Flytec |
| Model Numbers | V802-03 (Boat Circuit Board), V802-01 (Remote Control Circuit Board Assembly) |
| Material | Composite Material |
| Use | Vehicles & Remote Control Toys (Boats) |
| Recommended Age | 14+y |
| Certification | CE |
| Boat Circuit Board (V802-03) Size | 5.6*6.8*1.2cm |
| Boat Circuit Board (V802-03) Weight | 27.9g |
| Remote Control Circuit Board (V802-01) Size | 13*11*2.1cm (Circuit Board), 5.7*3.8*0.7cm (Display Screen) |
| Remote Control Circuit Board (V802-01) Weight | 72.7g |
| Battery Compatibility (Boat) | 7.4V 5200mAh or 7.4V 12000mAh (supports dual batteries for uninterrupted power supply) |
| Estimated Usage Time | 2-6 hours (depending on battery capacity) |
| Remote Control Distance | Up to 500m |
| Bait Loading Capacity | 3kg |
| Hoppers | 4 independently controlled hoppers |
| GPS Features | Built-in Beidou positioning system, intelligent calibration, supports 4 fishing grounds and 160 anchor points. |
| Fish Finder (Optional) | Sonar beam angle: 90 degrees, Wireless operation: 100m/328ft, Depth: 2-120ft |
| Waterproofing | Fully sealed cabin and battery compartment |
User Tips
- Always perform a pre-operation check of all components, especially battery levels and antenna connections, before launching the boat.
- When using the GPS features, ensure the boat has a clear view of the sky for accurate positioning.
- Practice operating the boat in an open area without obstacles to become familiar with its controls before using it for fishing.
- For optimal battery life, avoid completely draining the batteries. Recharge them promptly after use.
- Consider using the electronic fence feature to prevent the boat from going out of range, especially in large bodies of water.
Warranty and Support
For any issues, technical support, or warranty claims, please contact the seller or manufacturer directly. Keep your purchase receipt as proof of purchase.