Instruction Manual

1. Product Overview

This product is a replacement mushroom head gear and/or shock-absorbing rubber pad designed for specific Midea blender models. It is crucial for the proper functioning of your blender, connecting the motor to the blade assembly. Ensure compatibility with your blender model before installation.

2. Compatibility and Identification

This replacement part is compatible with Midea blender models MJ-BL1036A, BL1037A, and PB12Easy219. Always verify the dimensions and appearance of your existing part against the specifications provided to ensure correct fitment.

3. Setup and Installation

Safety First: Always unplug your blender from the power outlet before attempting any installation or maintenance.

1. Access the Old Part: Depending on your blender model, you may need to invert the blender base to access the mushroom head gear or rubber pad. Some models may require removing the bottom cover.
2. Remove the Old Part: The mushroom head gear is typically threaded onto the motor shaft. Turn it counter-clockwise to unscrew and remove it. The rubber pad may simply lift off or be held in place by friction. Note the orientation of the old part before removal.
3. Clean the Area: Wipe down the motor shaft and surrounding area to remove any debris or residue.
4. Install the New Part:
   • If installing a new mushroom head gear, align it with the motor shaft and turn it clockwise to screw it on. Tighten it securely but do not overtighten.
   • If installing a new rubber pad, place it onto the designated area, ensuring it sits flush and correctly oriented.
5. Verify Installation: Once the new part is installed, gently try to rotate it by hand to ensure it is securely attached and moves freely without obstruction.
6. Test the Blender: Reassemble any removed covers, plug in the blender, and perform a brief test run (e.g., with water) to ensure proper operation and no unusual noises.

4. Operating Instructions

This product is a replacement component for your Midea blender. Operating instructions for the blender itself can be found in your blender's original user manual. Ensure the mushroom head gear and shock-absorbing pad are correctly installed before operating the blender.

5. Maintenance

• Regular Inspection: Periodically inspect the mushroom head gear and rubber pad for signs of wear, cracks, or damage. Replace immediately if any damage is observed to prevent further issues with your blender.
• Cleaning: After each use, ensure the area around the mushroom head gear and rubber pad is clean and free of food debris. Use a damp cloth to wipe it down. Do not immerse the blender base in water.
• Avoid Overloading: Do not overload your blender, as excessive strain can accelerate wear on the gear and pad.

6. Troubleshooting

Blender not engaging / Blades not spinning:

Check if the mushroom head gear is securely attached to the motor shaft and if it is properly engaging with the blade assembly. Inspect for excessive wear on the gear teeth.

Unusual noise or vibration during operation:

This could indicate a worn or damaged mushroom head gear or rubber pad. Inspect both components for any visible damage or improper seating.

Leakage from the blender base:

Ensure the rubber pad (gasket) is correctly installed and not damaged. A worn or improperly seated rubber pad can lead to leaks.

7. Specifications

8. User Tips

No specific user tips or frequently asked questions were available for this product. Always refer to your blender's original manual for general usage guidelines.

9. Warranty and Support

For warranty information or technical support regarding this replacement part, please contact the seller or the manufacturer directly. Keep your purchase records for reference.