TINECO Floor ONE i5 Stretch Complete

Contents

Tineco Floor ONE i5 Stretch Complete Wet Dry Vacuum Cleaner User Manual

Model: Floor ONE i5 Stretch Complete

1. Introduction

Thank you for choosing the Tineco Floor ONE i5 Stretch Complete Wet Dry Vacuum Cleaner. This innovative appliance is designed to simplify your cleaning routine by combining powerful vacuuming and wet mopping in one step. Featuring a 180° lay-flat design, anti-tangle technology, and dual-sided edge cleaning, it ensures a thorough clean even in hard-to-reach areas. Please read this manual carefully before use to ensure safe and efficient operation.

2. Important Safety Instructions

When using an electrical appliance, basic precautions should always be followed, including the following:

  • Read all instructions before using this appliance.
  • Do not use outdoors or on wet surfaces.
  • Do not allow to be used as a toy. Close attention is necessary when used by or near children, pets, or plants.
  • Use only as described in this manual. Use only manufacturer’s recommended attachments.
  • Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
  • Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
  • Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
  • Do not handle plug or appliance with wet hands.
  • Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
  • Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
  • Turn off all controls before unplugging.
  • Use extra care when cleaning on stairs.
  • Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
  • Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
  • Do not use without filters in place.
  • Prevent unintentional starting. Ensure the switch is in the off-position before connecting to battery pack, picking up or carrying the appliance.
  • Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
  • Use appliances only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.
  • Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.
  • Do not use an appliance that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
  • Do not expose an appliance to fire or excessive temperature. Exposure to fire or temperature above 130°C (265°F) may cause explosion.
  • Follow all charging instructions and do not charge the appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.
  • Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.
  • Do not modify or attempt to repair the appliance or the battery pack (as applicable) except as indicated in the instructions for use and care.

3. Package Contents

Please check the box for the following items:

  • Tineco Floor ONE i5 Stretch Complete Wet Dry Vacuum Cleaner (Main Unit)
  • Charging Base
  • Brush Roller
  • HEPA Filter
  • Cleaning Solution (500ml)
  • Cleaning Tool
  • Power Adapter
  • User Manual

4. Product Overview

The Tineco Floor ONE i5 Stretch Complete is designed for efficient wet and dry cleaning with several key features:

  • 20kPa Powerful Suction: Effectively picks up wet and dry messes, pet fur, and stubborn stains.
  • 180° Lay-Flat Design: Allows the vacuum to lie flat (down to 5.1 inches clearance) to easily reach and clean under furniture.
  • Anti-Tangle Design: Minimizes hair and pet fur tangling around the brush roller for consistent performance.
  • Dual-Sided Edge Cleaning: Cleans right up to baseboards and into corners, leaving no dirt behind.
  • Constant Clean Brush Mopping: Ensures the brush is continuously washed with clean water during operation, and waste water/hair is scraped off and immediately suctioned.
  • One-Press Self-Cleaning: Automated cleaning cycle for the brush roller and internal pathways after use.
  • Two Cleaning Modes: Choose between Eco mode for light dirt and daily cleaning, and Max mode for stubborn stains.
  • Large-Capacity Water Tanks: Features an 800ml clean water tank and a 720ml dirty water tank for extended cleaning sessions.
  • Up to 30 Minutes Runtime: Provides sufficient battery life for whole-house cleaning on a single charge (up to 1980 sq ft).
  • Effortless and Flexible Cleaning: Repositioned clean water tank, 45° swivel design, and mini assistive wheels enhance maneuverability.
Tineco Floor ONE i5 Stretch Complete Wet Dry Vacuum Cleaner

Figure 4.1: Tineco Floor ONE i5 Stretch Complete with key features highlighted.

Dual-sided Edge Cleaning

Figure 4.2: Dual-sided edge cleaning capability, reaching baseboards and tight spots.

180 degree Lay-flat Design

Figure 4.3: The 180° lay-flat design for cleaning under low furniture.

Constant Clean Brush Mopping process

Figure 4.4: Illustration of the constant clean brush mopping system.

Anti-Tangle Design

Figure 4.5: The anti-tangle design effectively handles hair and pet fur.

Eco and Max cleaning modes

Figure 4.6: Comparison of Eco mode for light dirt and Max mode for stubborn stains.

Large Capacity Water Tanks

Figure 4.7: Overview of the 800ml clean water tank and 720ml dirty water tank.

5. Setup

5.1 Assembly

  1. Carefully unpack all components from the packaging.
  2. Insert the handle into the main body of the vacuum until it clicks securely into place.
  3. Ensure the brush roller and filter are correctly installed in their respective compartments.

5.2 Charging the Battery

  1. Place the vacuum cleaner on its charging base.
  2. Connect the power adapter to the charging base and then plug it into a wall outlet.
  3. The LCD display will indicate the charging status. A full charge typically takes several hours. Ensure the battery is fully charged before first use.

5.3 Filling the Clean Water Tank

  1. Press the tank release button and remove the clean water tank from the main unit.
  2. Open the tank cap and fill the tank with clean tap water. For enhanced cleaning, add a small amount of Tineco cleaning solution (500ml bottle included) as per the solution's instructions. Do not overfill.
  3. Close the tank cap securely and reattach the clean water tank to the main unit until it clicks.

6. Operating Instructions

6.1 Powering On/Off and Mode Selection

  1. To power on, press the Power button located on the handle. The vacuum will start in Eco mode by default.
  2. To switch to Max mode for tougher messes, press the Mode button. The LCD display will indicate the current mode.
  3. To power off, press the Power button again.

6.2 Cleaning Your Floors

  • Hold the vacuum at a comfortable angle and begin moving it forward and backward over the desired cleaning area.
  • For cleaning under furniture, gently lower the handle to utilize the 180° lay-flat design.
  • For edge cleaning, position the vacuum head close to baseboards or corners. The dual-sided edge cleaning feature will ensure thorough coverage.
  • The vacuum will dispense clean water and cleaning solution, scrub with the brush roller, and then suction up the dirty water and debris.
  • Floors will dry quickly due to efficient water suction.
Vacuum in use for whole-house cleaning

Figure 6.1: The vacuum in action, demonstrating its runtime capability.

One step for various cleaning needs

Figure 6.2: Versatile cleaning for different types of messes.

Floors dry in seconds

Figure 6.3: Demonstrating the quick-drying feature after cleaning.

6.3 Emptying the Dirty Water Tank

When the dirty water tank is full, the vacuum will alert you. It is recommended to empty the tank after each use.

  1. Press the tank release button and remove the dirty water tank.
  2. Carefully open the tank and dispose of the dirty water and debris.
  3. Rinse the tank thoroughly with clean water and allow it to air dry before reattaching.

6.4 One-Press Self-Cleaning Function

After cleaning, place the vacuum back on its charging base and ensure there is sufficient clean water in the clean water tank.

  1. Press the Self-Cleaning button (usually indicated by a circular arrow icon).
  2. The vacuum will initiate an automatic cleaning cycle for the brush roller and internal tubes.
  3. Once the cycle is complete, empty and clean the dirty water tank as described above.
One-Press Self-Cleaning button

Figure 6.4: Location of the one-press self-cleaning button.

7. Maintenance

Regular maintenance ensures optimal performance and extends the lifespan of your Tineco Floor ONE i5 Stretch Complete.

7.1 Cleaning the Brush Roller

  1. After the self-cleaning cycle, remove the brush roller cover and then the brush roller.
  2. Use the provided cleaning tool to remove any remaining hair or debris from the brush roller.
  3. Rinse the brush roller under running water until clean.
  4. Allow the brush roller to air dry completely before reinstalling.

7.2 Cleaning the HEPA Filter

  1. Remove the HEPA filter from its compartment (usually located near the dirty water tank).
  2. Tap the filter gently over a trash can to remove loose dust and debris.
  3. Rinse the filter under running water. Ensure all dirt is removed.
  4. Allow the HEPA filter to air dry completely for at least 24 hours before reinstalling. Do not use the vacuum without a dry filter.

7.3 General Cleaning

  • Wipe down the exterior of the vacuum with a damp cloth.
  • Clean the charging contacts on both the vacuum and the charging base.
  • Ensure all water tanks and components are clean and dry before storing the vacuum.

8. Troubleshooting

If you encounter any issues with your Tineco Floor ONE i5 Stretch Complete, please refer to the following table:

Problem Possible Cause Solution
Vacuum does not turn on Battery is depleted; Power button not pressed correctly. Charge the battery fully; Ensure the power button is pressed firmly.
Poor suction Dirty water tank full; Clean water tank empty; Clogged brush roller or air path; Filter is dirty. Empty dirty water tank; Refill clean water tank; Clean brush roller and check for blockages; Clean or replace filter.
Brush roller not rotating Hair or debris tangled in brush; Brush roller not installed correctly. Remove brush roller and clean thoroughly; Reinstall brush roller correctly.
Water leakage Water tanks not installed correctly; Tank caps not sealed; Damaged tank. Ensure tanks are securely clicked into place; Check tank caps for proper seal; Contact support if tanks are damaged.
Self-cleaning not working Insufficient clean water; Dirty water tank full; Vacuum not on charging base. Ensure clean water tank is filled; Empty dirty water tank; Place vacuum correctly on charging base.

9. Specifications

Feature Specification
Brand Name TINECO
Model Floor ONE i5 Stretch Complete
Type Wet and Dry Vacuum Cleaner
Power (W) 180W
Voltage 220 V
Battery Type Li-ion
Battery Life 30-59 min (Up to 30 minutes runtime)
Clean Water Tank Volume 800ml
Dirty Water Tank Volume 720ml
Dust Box Capacity (L) 0.6-1 L
Weight 6-10 kg (Package weight: 8.69 kg)
LCD Display Yes
Wireless Yes
Installation Hand Held
Package Dimensions (L x W x H) 71cm x 32cm x 28cm

10. User Tips

  • No Heated Water: The Tineco Floor ONE i5 Stretch Complete does not heat water for cleaning. Use room temperature or cold water in the clean water tank.
  • Regular Filter Cleaning: To maintain strong suction and prevent odors, clean the HEPA filter regularly and ensure it is completely dry before reinstallation.
  • Empty Dirty Tank Promptly: Always empty the dirty water tank immediately after use to prevent odors and bacterial growth.
  • Use Tineco Solution: For best results and to protect your appliance, use Tineco brand cleaning solution.

11. Warranty and Support

For warranty information, product registration, or technical support, please refer to the warranty card included in your package or visit the official Tineco website. Keep your purchase receipt as proof of purchase.

If you require further assistance, please contact Tineco customer service.

© 2023 Tineco. All rights reserved.

Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.