1. Introduction
This manual provides instructions for the proper installation and use of the TOOLTOP ET15S Thermal Imager Macro Lens. This accessory is specifically designed to enhance the close-up thermal imaging capabilities of your ET15S Thermal Imaging Multimeter, allowing for detailed inspection of small components and circuits.
Important Note: This macro lens is only compatible with the TOOLTOP ET15S thermal imaging multimeter. It is not designed for use with ET14S, ET13S, or other models.
2. Specifications
| Feature | Description |
|---|---|
| Product Name | Macro Lens |
| Compatibility | TOOLTOP ET15S Thermal Imaging Multimeter ONLY |
| Working Distance | Approximately 5 cm (2 inches) |
| Package Dimensions (L x W x H) | 23 cm x 17 cm x 7 cm |
| Package Weight | 0.077 kg |
Note: For optimal image clarity, ensure the object being inspected is within the specified working distance. If the distance exceeds 5cm, the thermal image may become blurred.
3. Package Contents
- 1 x Macro Lens
4. Installation
Follow these steps to correctly install the macro lens onto your TOOLTOP ET15S thermal imager:
- Tilt the macro lens: Hold the macro lens at a slight angle.
- Insert front corners: Carefully insert the front two corners of the macro lens into the designated card slots on the thermal imager.
- Secure the lens: Press down on the back of the macro lens until the entire lens is securely seated and inserted into the card slot.
5. Operation
Once installed, the macro lens allows for enhanced close-up thermal imaging. To achieve the best results:
- Maintain working distance: Ensure the object you are inspecting is approximately 5 cm (2 inches) from the lens for clear focus.
- Adjust position: You may need to slightly move the macro lens left and right during use to fine-tune the focus and achieve the sharpest thermal image.
6. Troubleshooting
- Blurred Image: If your thermal image appears blurred, verify that the object being inspected is within the optimal working distance of approximately 5 cm from the macro lens.
- Lens Not Fitting: Ensure you have the correct macro lens model (ET15S Dedicated Macro Lens) for your TOOLTOP ET15S thermal imager. This lens is not compatible with other models.
- Lens Falling Out: Re-check the installation steps to ensure the lens is fully inserted and securely seated in the card slot.
7. User Tips
- Keep Lens Clean: Regularly clean the macro lens with a soft, lint-free cloth to ensure clear thermal images. Avoid abrasive materials that could scratch the lens surface.
- Stable Positioning: For the most precise readings on small components, try to keep both the thermal imager and the target object as stable as possible during inspection.
8. Warranty and Support
For any warranty claims, technical support, or further inquiries regarding your TOOLTOP ET15S Thermal Imager Macro Lens, please contact the seller or manufacturer directly. Keep your purchase receipt as proof of purchase.
