Introduction
Thank you for choosing the Deerma X30 Steam Dual Axis Floor Scrubber. This manual provides essential information for the safe and efficient use, maintenance, and troubleshooting of your new appliance. Please read it thoroughly before first use and keep it for future reference.
Important Safety Information
Always follow basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, or injury.
- Read all instructions before using the appliance.
- Do not immerse the appliance in water or other liquids.
- Do not use the appliance if the power cord or plug is damaged.
- Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.
- Use only as described in this manual. Use only manufacturer's recommended attachments.
- Unplug from outlet when not in use and before cleaning.
- Do not use on wet surfaces unless specifically designed for wet cleaning.
- Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
- Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
- Exercise extreme care when cleaning on stairs.
- Do not use without dust bag and/or filters in place.
- This appliance is for household use only.
Package Contents
Please check the package contents upon unboxing:
- Deerma X30 Main Unit
- Handle Assembly
- Clean Water Tank
- Dirty Water Tank
- Scrubbing Rollers (pre-installed or separate)
- Power Cord
- User Manual (this document)
Setup
- Assemble the Handle: Insert the handle assembly into the main unit until it clicks securely into place. Ensure it is firmly attached.
-
Fill the Clean Water Tank:
- Remove the clean water tank from the main unit.
- Open the tank cap and fill with clean tap water. For steam cleaning, distilled or demineralized water is recommended to prevent mineral buildup. Do not exceed the MAX fill line.
- Securely close the cap and reattach the tank to the main unit.
- Check Scrubbing Rollers: Ensure the scrubbing rollers are properly installed at the base of the unit. They should rotate freely.
- Connect Power: Plug the power cord into a suitable electrical outlet. The appliance is equipped with a 5-meter line length for extended reach.
Operating Instructions
- Power On: Press the power button located on the handle to turn on the scrubber. The indicator light will illuminate.
- Select Mode (if applicable): If your model has different cleaning modes (e.g., steam, scrub, or combined), select the desired mode using the controls on the handle.
-
Begin Cleaning: Tilt the handle back to engage the scrubbing rollers. The dual-axis design allows for efficient cleaning and maneuverability. Guide the scrubber slowly over the floor surface.
Figure 2: Scrubber in action, demonstrating effective cleaning on a wooden floor. - Steam Function: If using the steam function, allow a few moments for the unit to heat up and produce steam before beginning to clean. The steam helps to sanitize and loosen stubborn dirt.
-
Dirty Water Collection: As you clean, the dirty water will be collected in the dirty water tank. Monitor the tank and empty it when it reaches the MAX fill line.
Figure 3: Diagram illustrating the clean water supply and dirty water recovery system. - Power Off: When finished cleaning, press the power button to turn off the appliance. Unplug the power cord from the outlet.
Maintenance
Regular maintenance ensures optimal performance and extends the life of your Deerma X30.
- Empty and Clean Dirty Water Tank: After each use, remove the dirty water tank, empty its contents, and rinse thoroughly with clean water. Allow it to air dry before reattaching.
-
Clean Scrubbing Rollers:
- Remove the scrubbing rollers from the base of the unit.
- Rinse them under running water to remove any debris or residue.
- For deeper cleaning, they can be washed with mild soap and water.
- Ensure rollers are completely dry before re-installing to prevent mildew.
Figure 4: Close-up of the scrubber base, showing the scrubbing rollers for maintenance. - Self-Cleaning Function (if available): Some models may feature a self-cleaning mode. Refer to the specific instructions for activating and using this feature.
- Clean the Main Unit: Wipe down the exterior of the main unit with a damp cloth. Do not use harsh chemicals or abrasive cleaners.
- Store Properly: Store the scrubber in an upright position in a dry, safe place.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Appliance does not turn on. |
|
|
| Poor cleaning performance. |
|
|
| No steam produced. |
|
|
Specifications
| Feature | Detail |
|---|---|
| Model | X30 |
| Type | Steam Dual Axis Floor Scrubber |
| Rated Frequency | 50Hz |
| Power Cord Length | 5 meters |
| Applicable Area | More than 150 square meters |
| Endurance (Continuous Operation) | 0-60 minutes |
| Attraction (Suction Power) | 1000~1499Pa |
| Liquid Crystal Display | Without |
| Fixed Type (for rollers) | Hook & Loop Fastener |
| Origin | Mainland China |
User Tips
- For best results, pre-vacuum heavily soiled areas before using the scrubber to remove loose debris.
- Always use distilled or demineralized water for the steam function to prevent mineral buildup and extend the life of the appliance.
- Regularly check and clean the scrubbing rollers to maintain optimal cleaning efficiency.
- Empty the dirty water tank immediately after use to prevent odors and bacterial growth.
- The 5-meter power cord provides ample reach, but be mindful of its placement to avoid tripping hazards during operation.
Warranty and Support
For warranty information, technical support, or service inquiries, please refer to the warranty card included with your product or contact the manufacturer's customer service directly. Keep your proof of purchase for warranty claims.
