1. Product Overview
The MCHOSE A7 Ultra RE is a high-performance wireless esports gaming mouse designed for competitive gaming. It features a right-handed ergonomic design, a PAW3950 flagship optical sensor, and supports both wireless (2.4G and Bluetooth) and wired connections.
2. Setup Guide
2.1. Connection Modes
The MCHOSE A7 Ultra RE mouse supports three connection modes: Wired, 2.4G Wireless, and Bluetooth Wireless. Use the toggle switch on the bottom of the mouse to select your desired mode.
2.1.1. Wired Connection
- Connect the provided Type-C cable to the Type-C port on the front of the mouse.
- Connect the other end of the cable to a USB port on your computer.
- The mouse will automatically switch to wired mode and begin charging if in wireless mode.
2.1.2. 2.4G Wireless Connection
- Switch the toggle on the bottom of the mouse to the [2.4G] position.
- Locate the USB dongle stored inside the mouse (refer to the image below).
- Insert the USB dongle into an available USB port on your computer.
- The mouse is now ready for use.
Manual Pairing (if needed):
- Press the Left, Middle (scroll wheel), and Right buttons of the mouse simultaneously for approximately 3 seconds. The indicator light will flash, indicating pairing mode.
- Insert the USB dongle into a USB port on your computer.
- Place the mouse close to the USB dongle (within 20cm). The indicator light will turn off upon successful connection.
2.1.3. Bluetooth Wireless Connection
- Switch the toggle on the bottom of the mouse to the [B] position.
- Press the Left, Middle (scroll wheel), and Right buttons of the mouse simultaneously for approximately 3 seconds. The indicator light will flash, indicating search mode.
- On your computer, search for Bluetooth devices.
- Select the mouse from the list (pairing name will be [MCHOSEA7], [MCHOSEA7PTO], or [MCHOSEA7Max]).
- The indicator light will turn off after the connection is successful.
3. Operating Instructions
3.1. DPI Switching
The mouse features a DPI switch button on the bottom to cycle through six preset DPI levels. DPI settings can also be adjusted via the driver software.
The indicator light on the mouse will change color to reflect the current DPI level:
- Level 1: Red Light (400 DPI)
- Level 2: Blue Light (800 DPI)
- Level 3: Green Light (1600 DPI)
- Level 4: Yellow Light (3200 DPI)
- Level 5: Cyan Light (6400 DPI)
- Level 6: Purple Light (26000 DPI)
Note: The A7 Ultra model with the 3950 sensor supports up to 42000 DPI, configurable via software.
3.2. Battery Status Indicator
- Red indicator light flashing: Please charge the mouse promptly.
- Red indicator light on: Charging in progress.
- Green indicator light on: Charging completed.
4. Maintenance and Care
4.1. Charging Instructions
- It is recommended to charge the mouse only via a computer USB port.
- Avoid using substandard or non-compliant power adapters to charge the mouse.
- Avoid using over-voltage or over-current power adapters for charging.
- Keep the mouse away from high-temperature devices while charging.
- Please turn off the power switch if the device will not be used for an extended period.
4.2. Cleaning
To clean your mouse, use a soft, dry cloth. For stubborn dirt, a slightly damp cloth can be used, ensuring no moisture enters the mouse's internal components. Avoid harsh chemicals or abrasive materials.
4.3. Software and Drivers (M HUB)
The MCHOSE A7 Ultra RE mouse can be customized using the M HUB software, which allows for advanced settings such as DPI adjustment, button remapping, and polling rate configuration.
- M HUB web version driver: https://www.mchose.com.cn
- M HUB client driver: https://www.maicong.cn/support/hub
5. Troubleshooting
5.1. Common Issues
- Mouse not connecting: Ensure the mode switch is in the correct position (2.4G or Bluetooth). For 2.4G, check if the USB dongle is properly inserted. For Bluetooth, ensure your computer's Bluetooth is enabled and try manual pairing.
- DPI not changing: Ensure the mouse is powered on and try clicking the DPI switch button. If using custom settings, verify them in the M HUB software.
- Lag or erratic movement: Ensure the mouse is fully charged. For wireless modes, ensure the dongle is close to the mouse and there are no strong interferences. Update drivers via M HUB.
- Battery draining quickly: Ensure the mouse is fully charged. Reduce polling rate or turn off unnecessary features if configured via software.
5.2. FCC Compliance Statement
This device has been tested and complies with the limits for Class B digital devices under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this device does cause harmful interference to radio or television reception (which can be determined by turning the device off and on), the user is encouraged to try one or more of the following measures to correct the interference:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the responsible party could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
6. Specifications
| Feature | Specification |
|---|---|
| Brand Name | MCHOSE |
| Model | A7 Ultra RE |
| Sensor | PAW3950 Optical Sensor |
| DPI | Up to 42000 (Customizable) |
| Polling Rate | Native Dual 8K |
| Interface Type | Bluetooth, 2.4G Wireless, Wired (Type-C) |
| Power Type | Rechargeable |
| Battery Capacity | 500mAh |
| Number of Buttons | 4 |
| Operation Mode | Opto-electronic |
| Switches | Omron Mechanical Micro Motion (100 million clicks) |
| LOD Height | 0.7~2.0mm |
| Frame Rate (Ultra Competitive Mode) | ≥ 20000 fps |
| Coating | SuperGlide Glass Coating |
| Ergonomics | Right-handed ergonomic design |
| Weight | Approx. 56g (0.33 kg packaged) |
| Dimensions (Packaged) | 26cm (L) x 17cm (W) x 4cm (H) |
7. User Tips
- The ergonomic design is noted for providing comfort and an extra grip, especially for palm grip users with larger hands. Allow a couple of days to adjust to the shape if it feels unfamiliar initially.
- The mouse is very lightweight and feels premium.
- The mechanical clicks are responsive and not overly heavy.
- The M HUB software is user-friendly and offers extensive customization options for DPI, button functions, and other performance settings.
- Some users have noted that the stock skates might feel a bit rough or make a scratching sound on certain mousepads. Consider using a smoother mousepad or replacing the skates if this affects your experience.
8. Warranty and Support
Thank you for purchasing our product. If there are any quality issues within the warranty period, please contact us. Please provide your warranty card for comprehensive after-sales service.
For a detailed user manual, you may also refer to the official PDF document: MCHOSE A7 Wireless Mouse User Manual (PDF).
Warranty Card Information:
Please retain your purchase details for warranty claims. The warranty card typically includes fields for:
- Product Items
- Customer Name
- Serial No.
- Contact Address
- Purchase Date
- TEL/E-mail
- Purchase Channel
- Postcode