ROBORE P9

Contents

ROBORE P9 Folding Treadmill User Manual

Model: P9

Introduction

This manual provides detailed instructions for the safe and efficient use of your ROBORE P9 Folding Treadmill. Please read this manual thoroughly before operating the treadmill and keep it for future reference.

The ROBORE P9 is designed for home fitness, featuring a 3.0HP brushless motor, a maximum speed of 14 KM/H, a heart rate sensor, and a 136kg weight capacity. Its foldable design and advanced shock absorption system make it a convenient and comfortable option for cardio training.

Important Safety Instructions

  • Always consult with a physician before starting any exercise program.
  • Place the treadmill on a flat, stable surface with adequate clearance around it.
  • Ensure the safety key is properly attached to your clothing before starting the treadmill.
  • Do not allow children or pets near the treadmill while it is in operation.
  • Keep hands and feet clear of moving parts, especially the running belt.
  • Wear appropriate athletic footwear and clothing.
  • If you feel faint, dizzy, or experience pain, stop exercising immediately.
  • Unplug the treadmill from the power outlet when not in use or before cleaning/maintenance.

Package Contents

Please check the package contents carefully. If any items are missing or damaged, contact customer support.

  • 1 x ROBORE P9 Treadmill
  • 1 x Safety Key
  • 1 x User Manual (this document)
  • 1 x Toolkits

Setup and Assembly

The ROBORE P9 treadmill is designed for easy setup. Most of the assembly is pre-completed. Follow these steps to prepare your treadmill for use:

  1. Unpacking: Carefully remove the treadmill from its packaging. Retain packaging materials for future storage or transport.
  2. Unfolding:
    • Locate the two detachable knobs at the bottom side of the treadmill.
    • Loosen these knobs (approximately 15 seconds) to release the folding mechanism.
    • Gently raise the console and handlebars into the upright position until they lock securely.
    • Tighten the detachable knobs to secure the treadmill in the unfolded position.
  3. Placement: Position the treadmill on a level, stable surface. Ensure there is at least 2 meters (6.5 feet) of clear space behind the treadmill and 0.5 meters (1.6 feet) on each side.
  4. Power Connection: Plug the power cord into a grounded electrical outlet.
  5. Safety Key: Attach the safety key to the designated slot on the console. The treadmill will not operate without the safety key in place.
ROBORE P9 Treadmill in unfolded position
Figure 1: ROBORE P9 Treadmill in its operational, unfolded position.

Operating the Treadmill

Console and Controls

The treadmill features an intelligent display and multi-functional console for easy control and monitoring of your workout.

Treadmill console with storage rack and intelligent display
Figure 2: Close-up of the intelligent display and convenient storage rack.
Multi-functional console with buttons for Heart Rate Monitor, Start, Stop, Speed +, Speed -, Safety Key, 12 Preset Programs
Figure 3: Multi-functional console with controls and heart rate monitor.
  • Start/Stop: Use the dedicated buttons on the console or the quick adjustment buttons on the handle to start and stop the running belt.
  • Speed Adjustment: Increase or decrease speed using the 'Speed +' and 'Speed -' buttons on the console or the quick adjustment buttons on the handle. The treadmill supports speeds up to 14 KM/H (approximately 7.5 MPH).
  • Heart Rate Monitor: Grip the heart rate sensors on the handrails to monitor your pulse rate in real-time.
  • Device Holder: A convenient storage rack is integrated into the console to hold your mobile device or other small items.
Video 1: Demonstration of treadmill features including intelligent display, speed adjustment, shock absorption, and device holder.

Workout Modes and Programs

The ROBORE P9 offers various workout options to suit your fitness goals.

  • 3-in-1 Multi-Mode: Easily switch between Walking Mode (0% Incline), Jogging Mode (10% Incline), and Running Mode (15% Incline) to vary your workout intensity.
  • 12 Preset Programs: Utilize the 12 pre-programmed workout routines for structured training sessions.
Diagram showing Walking Mode at 0% incline, Jogging Mode at 10% incline, and Running Mode at 15% incline
Figure 4: Illustration of the 3-in-1 multi-mode functionality with varying incline levels.
Image showing a person running on the treadmill with 12 preset programs indicated above
Figure 5: The treadmill offers 12 preset programs for diverse workouts.

Maintenance

Regular maintenance ensures the longevity and optimal performance of your treadmill.

  • Cleaning: Wipe down the console and other surfaces with a damp cloth after each use. Avoid using abrasive cleaners or solvents.
  • Running Belt Lubrication: The running belt requires periodic lubrication to reduce friction and wear.
    • It is recommended to lubricate the belt every 3 months or after 100 hours of use, whichever comes first.
    • Lift the edge of the running belt and apply a small amount of 100% silicone lubricant to the center of the deck.
    • Run the treadmill at a slow speed (e.g., 3 KM/H) for a few minutes to distribute the lubricant evenly.
    • Note: Silicone lubricant is not included in the package and must be purchased separately.
  • Belt Adjustment: If the running belt becomes off-center or slips, refer to the detailed instructions in the full user manual (if available) or contact customer support for guidance on adjustment.

Folding and Storage

The ROBORE P9 treadmill can be easily folded for compact storage.

  1. Power Off: Ensure the treadmill is turned off and unplugged from the power outlet.
  2. Loosen Knobs: Locate and loosen the two detachable knobs at the bottom side of the treadmill (the same ones used during unfolding).
  3. Fold Down: Gently lower the console and handlebars towards the running deck until the treadmill is in its folded position.
  4. Secure: Tighten the detachable knobs to secure the treadmill in the folded position.
  5. Move and Store: The integrated bottom wheels allow for easy movement. Roll the folded treadmill to your desired storage location.
Treadmill in folded position, showing compact storage
Figure 6: The ROBORE P9 treadmill in its folded state for compact storage.

Troubleshooting

If you encounter any issues with your treadmill, please refer to the following common problems and solutions:

Problem Possible Cause Solution
Treadmill does not start Power cord not plugged in; Safety key not in place; Power switch off. Ensure power cord is securely plugged in; Insert safety key correctly; Turn on the power switch.
Running belt slips or hesitates Belt too loose; Belt requires lubrication. Adjust belt tension (refer to full manual or support); Lubricate the running belt as per maintenance instructions.
Unusual noise during operation Loose components; Lack of lubrication; Foreign object. Check all bolts and nuts for tightness; Lubricate the belt; Inspect for any foreign objects under the belt.

If the problem persists, please contact customer support for further assistance.

Specifications

Feature Detail
Brand ROBORE
Model P9
Type Treadmill
Color Black
Motor 3.0HP Brushless Motor
Max Speed 14 KM/H (approx. 7.5 MPH)
Noise Level < 45 dB
Weight Capacity 136 kg
Product Weight 25 kg
Package Weight 29.5 kg
Product Dimensions (L x W x H) 128 x 61 x 105 cm
Package Dimensions (L x W x H) 130 x 64 x 18 cm
Running Belt Length 80-120 cm (approx. 40.2 inches)
Running Belt Width 30-50 cm (approx. 15.4 inches)
Adjustable Slope Yes (0%, 10%, 15% incline)
Foldable Yes
Training Site Legs, Muscle Relex Apparatus, Foot
Type of Sports Cardio Training
Shock Absorption Dual Shock Absorption (5-layer anti-slip belt, 6 silicone shock absorbers, 2 soft rubber pads)
Motor Lifetime >3500 hours
Treadmill dimensions and maximum weight capacity of 140KG
Figure 7: Key dimensions and weight capacity of the treadmill (image shows 140KG capacity).
Running belt features: 7-layer and non-slip, with 40cm width indicated
Figure 8: Details of the 7-layer non-slip running belt.
Diagram showing double shock absorption system with honeycomb cushion
Figure 9: The dual shock absorption system for comfortable workouts.
Illustration of the UMAY 3.0 HP Brushless Motor with over 3500 hours lifetime and less than 45dB noise
Figure 10: Features of the 3.0 HP Brushless Motor.

User Tips

  • Lubrication: Remember to acquire 100% silicone lubricant separately for regular belt maintenance, as it is not included in the package.
  • Assembly Ease: Users have noted the treadmill is easy to assemble with clear English instructions.
  • Running Surface: While sufficient for home use, some users find the running platform to be of average length and width. Consider your stride and comfort preferences.

Warranty and Support

For warranty information, technical support, or service inquiries, please refer to the contact details provided by your retailer or the official ROBORE website. Keep your purchase receipt as proof of purchase.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.