1. Product Overview
This kit provides essential replacement accessories for maintaining the optimal performance of your compatible robotic vacuum cleaner. It includes main brushes, filters, and side brushes, designed to effectively capture dust, debris, and allergens from your home environment.
Image: A complete set of replacement parts, including one main brush, several filters, and several three-armed side brushes.
2. Compatibility
This accessory kit is compatible with the following robotic vacuum cleaner models:
- R3500
- R550
- R650
- R600
- R700
- D380
- DK600
Please ensure your vacuum cleaner model is listed above before installation.
3. Installation Guide
Before installing any replacement parts, ensure your robotic vacuum cleaner is powered off and unplugged from its charging base.
3.1. Replacing the Main Brush
- Turn the robot vacuum cleaner upside down.
- Locate the main brush cover, usually secured by latches or screws.
- Open or unscrew the cover to access the main brush.
- Remove the old main brush by lifting it out of its compartment.
- Insert the new main brush, ensuring it is properly seated in its designated slots.
- Close the main brush cover and secure it.
3.2. Replacing the Side Brushes
- Turn the robot vacuum cleaner upside down.
- Locate the side brushes, typically held in place by a single screw.
- Use a screwdriver to remove the screw holding the old side brush.
- Gently pull off the old side brush.
- Align the new side brush with the post and push it down.
- Secure the new side brush with the screw. Repeat for all side brushes.
Image: Two three-armed side brushes, commonly found on robotic vacuum cleaners.
3.3. Replacing the Filters
- Open the dustbin compartment of your robot vacuum cleaner.
- Remove the dustbin.
- Locate the filter assembly within the dustbin.
- Remove the old filter(s) by pulling them out. Note the orientation.
- Insert the new filter(s) into the dustbin, ensuring a snug fit.
- Close the dustbin and reinsert it into the vacuum cleaner.
Image: Two filters, showing the white pleated filter and the black foam filter, ready for replacement.
4. Operating with New Accessories
Once the replacement parts are installed, your robotic vacuum cleaner is ready for operation. The new main brush, side brushes, and filters will restore optimal cleaning performance, ensuring efficient dirt and debris collection and improved air filtration.
5. Maintenance
Regular maintenance of your vacuum cleaner accessories is crucial for sustained performance and longevity of your robot. While these are replacement parts, some interim cleaning can extend their effective life.
- Filters: Tap filters gently over a trash can to remove loose dust and debris. Do not wash filters unless explicitly stated by your vacuum cleaner's manufacturer, as this can damage the filter material.
- Side Brushes: Periodically check side brushes for tangled hair or debris. Carefully cut and remove any tangles to ensure they can rotate freely.
- Main Brush: Remove the main brush and use the cleaning tool (often provided with the vacuum) to cut and remove tangled hair and fibers.
Replacement Schedule:
To maintain the best cleaning and filtration effect, it is recommended that cleaning accessories be replaced every 2-3 months, depending on the frequency of use and the amount of debris collected.
6. Troubleshooting
If your robotic vacuum cleaner exhibits reduced performance after installing new accessories, consider the following:
| Problem | Possible Cause | Solution |
|---|---|---|
| Reduced Suction Power | Filter not seated correctly or dustbin full. | Ensure filter is properly installed. Empty dustbin. |
| Poor Edge Cleaning | Side brushes tangled or not rotating. | Check side brushes for tangles and ensure they are securely attached. |
| Unusual Noise | Main brush tangled or not installed correctly. | Remove and re-install main brush, checking for obstructions or tangles. |
7. Specifications
| Feature | Detail |
|---|---|
| Product Type | Replacement Vacuum Cleaner Accessories (Main Brush, Filter, Side Brush) |
| Material | Plastic |
| Color | Light Grey (Side Brushes), White/Black (Filters), Black (Main Brush) |
| Compatibility | R3500, R550, R650, R600, R700, D380, DK600 Robotic Vacuum Cleaners |
| Package Contents | 1 x Main brush, 3 x Filter, 6 x Side brushes |
| Package Dimensions | 18 cm (Length) x 11 cm (Width) x 5 cm (Height) |
| Package Weight | 0.096 kg |
8. User Tips
- Always power off your vacuum cleaner before attempting to replace or clean any parts.
- Keep spare filters and brushes on hand to ensure timely replacements and uninterrupted cleaning performance.
- Regularly check brushes for hair tangles, especially if you have pets, to prevent motor strain and maintain cleaning efficiency.
- For optimal air quality, adhere strictly to the recommended filter replacement schedule.
9. Warranty and Support
For specific warranty information regarding these replacement accessories, please refer to the original purchase documentation or contact the seller directly. Support for the robotic vacuum cleaner itself should be directed to its manufacturer.
