1. Introduction
Welcome to the ARWIBON GT08 Electric Scooter user manual. This document provides essential information for the safe assembly, operation, maintenance, and troubleshooting of your new electric scooter. Please read this manual thoroughly before using the scooter to ensure optimal performance and safety.

2. Important Safety Warnings
WARNING: Please mind potential fire risk and strictly follow the instruction manual for charging and storage. While using the product, please wear protective equipment and fully comply with the applicable law and regulations.
- Always wear a helmet and other protective gear (knee pads, elbow pads) when riding.
- Ensure all components are securely fastened before each ride.
- Do not ride in heavy rain or through puddles deeper than 1 inch.
- Avoid riding on slippery surfaces, steep inclines, or uneven terrain at high speeds.
- Familiarize yourself with local laws and regulations regarding electric scooter use.
- Keep hands and feet away from moving parts.
- Do not allow children under the recommended age to operate the scooter.
3. Product Overview
The ARWIBON GT08 features a robust design with powerful motors and an efficient battery system, equipped with 11-inch off-road tires and a high-performance braking system for safer control.
3.1. Control Panel and Buttons

| No. | Component | Function |
|---|---|---|
| 1 | Large Meter | Displays information about the scooter's battery level, speed, and faults. |
| 2 | Small Gauge | Starts the scooter and checks vehicle parameters. Used to modify vehicle parameters. |
| 3 | Acceleration Switch | Controls vehicle acceleration and deceleration. |
| 4 | Right Brake | Controls the front motor brake. |
| 5 | Left Brake | Controls the rear motor brake. |
| 6 | Light Switch | Headlight switch control and mode change. |
| 7 | High Beam (Headlights) | High and low beam switching. |
| 8 | Horn Switch | Controls the horn. |
| 9 | Turn Signal Switch | Controls the turn signals. |
| 11 | Key Lock | Used for starting the vehicle. |
| 12 | Single and Dual Drive Conversion | Switches between single-wheel and two-wheel drive, and high/low speed conversion. |

4. Assembly & Initial Setup
Your ARWIBON GT08 Electric Scooter comes largely pre-assembled. Minor assembly may be required, such as attaching the seat if desired, and unfolding the scooter.
4.1. Unfolding the Scooter
- Place the scooter on a flat surface.
- Release the folding mechanism latch, typically located near the base of the steering column.
- Carefully lift the steering column until it locks into place. Ensure the locking mechanism is fully engaged.
- Adjust the handlebar height to your preference and secure it.
4.2. Seat Installation (Optional)
If your model includes a seat, insert the seat post into the designated slot on the scooter deck and tighten the clamp securely. Adjust the seat height for comfortable riding.

5. Charging the Battery
The ARWIBON GT08 is equipped with a 60V 27AH high-quality lithium battery. Proper charging is crucial for battery longevity and safety.

- Ensure the scooter is turned off before charging.
- Locate the charging port, typically on the side of the deck.
- Connect the charger to the charging port, then plug the charger into a standard wall outlet.
- The charging indicator light on the charger will show the charging status (e.g., red for charging, green for fully charged).
- Charging time is approximately 6-8 hours for a full charge.
- Do not overcharge the battery. Disconnect the charger once the battery is full.
- Store the scooter and charger in a cool, dry place away from flammable materials.
6. Operating the Scooter
6.1. Starting and Riding
- Insert the key into the key lock (11) and turn it to the ON position.
- Check the Large Meter (1) and Small Gauge (2) for battery level and other parameters.
- Use the Single and Dual Drive Conversion switch (12) to select your preferred driving mode (single or dual motor).
- Gently press the Acceleration Switch (3) to start moving. Increase pressure for more speed.
- To brake, use the Left Brake (5) for the rear motor and Right Brake (4) for the front motor. The scooter is equipped with a high-performance hydraulic braking system for safer control.

6.2. Lighting and Signaling
- Use the Light Switch (6) to turn on/off the headlights.
- Toggle the High Beam (Headlights) switch (7) for high and low beam.
- Activate the Turn Signal Switch (9) to indicate turns.
- Use the Horn Switch (8) to alert others.
6.3. Terrain and Performance
The GT08 is designed with 11-inch non-tubeless off-road tires, providing excellent grip and stability across various terrains.

It boasts a strong climbing ability, capable of handling inclines of 45-60 degrees.

Suitable for various road conditions:

7. Maintenance
- Regular Cleaning: Wipe down the scooter with a damp cloth. Avoid using high-pressure water jets directly on electrical components.
- Tire Pressure: Check tire pressure regularly. Maintain recommended pressure for optimal performance and safety.
- Brake Inspection: Periodically check the hydraulic brakes for proper function and wear. Adjust or replace brake pads as needed.
- Battery Care: Charge the battery regularly, even if not in use, to maintain its health. Avoid completely draining the battery.
- Fasteners: Ensure all screws and bolts are tight before each ride.
- Storage: Store the scooter in a dry, cool place, away from direct sunlight and extreme temperatures.
8. Troubleshooting
This section addresses common issues you might encounter with your ARWIBON GT08 Electric Scooter.
- Scooter not turning on: Check if the battery is charged. Ensure the key is fully inserted and turned to the ON position.
- Loss of power during ride: The battery might be low. Charge the battery fully.
- Brakes feel weak: Inspect brake pads for wear. Check hydraulic fluid levels if applicable. Consult a professional if issues persist.
- Unusual noises: Stop riding immediately and inspect the scooter for loose parts or damage.
- Display not working: Check connections to the display. If the issue persists, contact support.
For more complex issues, please contact customer support.
9. Specifications
| Feature | Specification |
|---|---|
| Model Number | ARWIBON GT08 |
| Motor Power | 5600W (High Efficiency Brushless Motor) |
| Battery | 60V 27AH High Quality Lithium Battery |
| Tire Size | 11-inch Non-Tubeless Off-Road Tires |
| Range Per Charge | 60-80km (approx. 30-40 miles) |
| Charging Time | 6-8 hours |
| Voltage | 60V |
| Folded | Yes |
| Applicable People | Unisex |
| Braking System | Front and Rear Hydraulic Disc Brakes |
| Max Speed | 40-50 MPH |
| Climbing Angle | 45-60 degrees |
| Net Weight (with seat) | 42.8 kg (approx. 94.3 lbs) |
| Net Weight (without seat) | 40.25 kg (approx. 88.7 lbs) |
| Load Range | Up to 300 lbs |
| Certification | CE |



10. User Tips
- Weight Considerations: Be mindful of the scooter's net weight (42.8kg with seat, 40.25kg without seat) when handling or transporting it.
- Pre-Ride Check: Always perform a quick check of brakes, tires, and battery level before each ride.
- Terrain Adaptation: While the scooter is capable on various terrains, adjust your speed and riding style according to the surface conditions for safety.
- Battery Optimization: For maximum range, consider using single-drive mode and maintaining a consistent speed.
11. Warranty and Support
For warranty information, technical support, or service inquiries, please refer to your purchase documentation or contact the seller directly. Keep your proof of purchase for any warranty claims.