iScooter W9 Electric Scooter User Manual

1. Introduction

Thank you for choosing the iScooter W9 Electric Scooter. This manual provides essential information on the safe operation, assembly, maintenance, and troubleshooting of your new electric scooter. Please read it thoroughly before your first ride to ensure optimal performance and safety.

2. Important Safety Warnings

⚠️ Please mind potential fire risk and strictly follow the instruction manual for charging and storage. While using the product, please wear protective equipment and fully comply with the applicable law and regulations.

• Always wear a helmet and other protective gear (knee pads, elbow pads) when riding.
• Do not ride in wet conditions, heavy rain, or through puddles.
• Avoid riding on slippery surfaces, steep inclines, or uneven terrain.
• Ensure all screws and quick releases are securely fastened before each ride.
• Do not allow children under the recommended age to ride the scooter.
• Observe local traffic laws and regulations.
• Do not perform stunts or sudden maneuvers.
• Keep both hands on the handlebars while riding.
• Avoid distractions while riding, such as using a mobile phone.
• Do not carry passengers or heavy loads.
• Regularly check the brakes, tires, and battery for proper function.

3. Package Contents

Carefully unpack your iScooter W9 and check that all items are present and in good condition. If any items are missing or damaged, please contact customer support.

• iScooter W9 Electric Scooter
• Instruction Manual
• Charger (1)
• Double Open-End Wrench (1)
• T-Type Wrench (1)
• L-Type Hexagonal Wrench (1)
• Inner Tube (1)

4. Product Overview

Familiarize yourself with the different parts of your iScooter W9 Electric Scooter.

• Control Unit: Central control for scooter functions.
• Handlebar Mounting Sleeves: Secure handlebars.
• Brake Levers: Control front and rear disc brakes.
• Throttle: Accelerates the scooter.
• Display: Shows riding mode, speed, battery level, and other information.
• Height Adjustment Clamp: Adjusts handlebar height.
• Folding Mechanism: Allows the scooter to be folded for storage.
• Turn-Signals (2 Sides): Indicate turns.
• Footrests: For rider's feet.
• 2-in-1 Taillight and Brake Light: Rear illumination and brake indication.
• Disc Brake Rotor: Part of the braking system.
• Charging Port: Where the charger connects.
• Underbody Lights (2 Sides): Additional lighting for visibility.
• Headlight with Horn: Front illumination and audible warning.

5. Setup and Initial Assembly

Your iScooter W9 comes partially assembled. Follow these steps to complete the setup.

5.1 Unfolding the Scooter

1. Place the scooter on a flat surface.
2. Release the folding mechanism latch (refer to Figure 4.1).
3. Lift the handlebar stem until it locks into the upright position.
4. Secure the height adjustment clamp.
5. Attach the handlebars if they are separate, ensuring they are firmly in place.
6. Check all connections and ensure the scooter is stable before riding.

5.2 Initial Charge

Before your first ride, fully charge the scooter's battery. Refer to the 'Charging' section for detailed instructions.

5.3 App Connection (Voltix)

The iScooter W9 is compatible with the Voltix application. Download the app from your smartphone's app store. Follow the in-app instructions to pair your scooter via Bluetooth. The app allows you to monitor speed, battery level, trip distance, and potentially adjust settings.

6. Operating Instructions

6.1 Display Functions

1. Riding Mode: Indicates the current speed mode (ECO, D, S).
2. MAX: Maximum Speed / AVG: Average Speed / ERROR: Displays maximum or average speed, or an error message.
3. Engine Overheating Alarm: Alerts if the motor temperature is too high.
4. Turn Signals: Indicates active turn signal.
5. Headlight: Indicates if the headlight is on.
6. Cruise Control: Indicates if cruise control is active.
7. Ready to Go: Status indicator.
8. Connected App: Shows if the scooter is connected to the mobile app.
9. Battery Level: Displays remaining battery charge.
10. Trip Distance: Shows distance traveled in the current trip.
11. Real-time Speed: Current riding speed.
12. Total Distance: Total distance accumulated.

6.2 Driving Modes

The iScooter W9 offers four speed modes to adapt to different driving environments. Simply press the switch briefly at different times during startup to cycle through modes.

6.3 Braking System

The iScooter W9 features a dual braking system for precise control and safety.

• Front Disc Brake: Provides strong stopping power for the front wheel.
• Rear Disc Brake: Provides strong stopping power for the rear wheel.
• Electronic Brake: Integrated into the system for additional control.

Always apply brakes gently at first, especially at higher speeds, to avoid sudden stops or loss of control.

6.4 Lighting System

The scooter is equipped with a comprehensive lighting system for safe driving, especially in low-light conditions.

• Headlight: Illuminates the path ahead.
• Turn Signals: Located on both sides to indicate your turning direction.
• Underbody Lights: Enhance side visibility.
• Taillight and Brake Light: For rear visibility and to signal braking.

7. Charging the Battery

The iScooter W9 is powered by a 48V 14Ah battery. Ensure proper charging procedures are followed to maintain battery health and safety.

• Charging Time: Approximately 6-8 hours for a full charge.
• Charger Input: 100-240 V 50/60 Hz
• Charger Output: DC54.6V 1.5A

Charging Procedure:

1. Ensure the scooter is turned off.
2. Locate the charging port (refer to Figure 4.1).
3. Connect the charger to the charging port.
4. Plug the charger into a standard wall outlet.
5. The charger indicator light will typically show red during charging and turn green when fully charged.
6. Once fully charged, disconnect the charger from the scooter and then from the wall outlet.

Warning: Use only the original charger provided with your iScooter W9. Do not charge unattended. Do not charge near flammable materials. Store the scooter and charger in a dry, cool place.

8. Folding and Storage

The iScooter W9 features an easy-to-use folding mechanism for convenient storage and transport.

Folding Procedure:

1. Ensure the scooter is turned off.
2. Release the height adjustment clamp and lower the handlebars.
3. Engage the folding mechanism latch (refer to Figure 4.1).
4. Carefully fold the handlebar stem down towards the deck until it locks into place.

Dimensions:

• Unfolded Size: 115 x 60 x 128 cm (45.7 x 25.2 x 52.2 inches)
• Folded Size: 115 x 20 x 50 cm (45.7 x 9 x 16.5 inches)

Storage:

• Store the scooter in a dry, cool place away from direct sunlight and extreme temperatures.
• If storing for an extended period, ensure the battery is charged to about 50-70% and recharge it every 1-2 months to prevent deep discharge.

9. Maintenance

Regular maintenance will prolong the life of your iScooter W9 and ensure safe operation.

• Cleaning: Wipe the scooter with a damp cloth. Do not use high-pressure water or corrosive cleaners.
• Tires: Regularly check tire pressure and for any signs of wear or damage. The 10-inch pneumatic all-terrain tires are designed for various conditions.
• Brakes: Inspect brake levers, cables, and disc rotors for wear. Adjust brakes as needed to ensure responsive stopping power.
• Battery: Follow charging guidelines. Avoid fully draining the battery or overcharging it.
• Fasteners: Periodically check all screws and bolts to ensure they are tight.
• General Inspection: Look for any loose parts, unusual noises, or damage before each ride.

10. Troubleshooting

This section addresses common issues you might encounter with your iScooter W9.

• Scooter not turning on: Check battery level. Ensure the power button is pressed correctly.
• Scooter not charging: Verify the charger is properly connected to both the scooter and the power outlet. Check for damage to the charger or charging port.
• Loss of power/reduced range: Battery may be low or degrading. Check tire pressure. Riding uphill or against strong winds can reduce range.
• Brakes not effective: Inspect brake pads and rotors for wear. Adjust brake cable tension.
• Unusual noises: Check for loose components, rubbing parts, or debris in the wheels.
• Error message on display: Refer to the display functions (Figure 6.1) for general error indications. If the issue persists, contact support.

11. Specifications

Detailed technical specifications for the iScooter W9 Electric Scooter.

12. User Tips

• For optimal battery life, avoid frequently riding at maximum speed or on very steep inclines.
• Regularly check tire pressure; proper inflation improves range and ride comfort.
• Utilize the different driving modes (ECO, D, S) to conserve battery or achieve higher speeds as needed.
• The dual shock absorption system (front and rear) provides a smoother ride on varied terrain.
• Always be aware of your surroundings and anticipate potential hazards.

13. Warranty and Support

For warranty information, technical support, or service inquiries, please refer to the documentation provided at the time of purchase or contact your retailer. Keep your proof of purchase for any warranty claims.