9IMOD F405 Flight Stack

Contents

9IMOD F405 Flight Stack User Manual

F405 Flight Control & 55A/60A ESC for FPV Racing Drones

1. Introduction

The 9IMOD F405 Flight Stack is a high-performance integrated solution for FPV Racing Drones, combining an F405 Flight Control unit with either a 55A or 60A 4-in-1 Electronic Speed Controller (ESC). This stack supports BlueJay firmware and bidirectional DSHOT, offering large solder pads for easy assembly, even for beginners. It is designed to be compatible with all DJI Air Units and provides 4 available UART ports. The F405 main control chip, onboard OSD chip, and barometer ensure reliable performance in various flight environments.

2. Key Features

  • Open-source Betaflight Flight Controller.
  • High Configuration: STM32F405RGT6 master chip, ICM42688 gyroscope, BMP280 barometer.
  • Supports connectivity to all DJI Air Units.
  • Offers 4 available UART ports, and a dual BEC setup with 5V and 12V outputs.
  • Built-in OSD module for one-step parameterization.
  • Standard sockets and pads are all led out for convenient user customization.
  • ESC is equipped with a TVS transient suppression diode onboard for enhanced surge voltage protection.
  • ESC utilizes high-performance MOS for good current resistance, long durability, and stability.
  • High-performance processor supports DSHOT600 protocol for smooth and powerful acceleration.
  • F405 FC supports Betaflight firmware; ESC supports BlueJay and bidirectional DSHOT.
  • Supports multiple signal protocols (DSM/SBUS/TBS Crossfire/ELRS).
  • Supports multiple open-source firmware (ArduPilot, Betaflight, INAV).

3. Product Overview

The 9IMOD F405 Flight Stack consists of two main components: the F405 Flight Controller and a 4-in-1 ESC (either 55A or 60A). These components are designed to be stacked together, providing a compact and efficient solution for FPV drones.

Front and back view of the F405 Flight Controller and the 4-in-1 ESC
Figure 3.1: Front and back view of the F405 Flight Controller and 4-in-1 ESC.
Close-up of the F405 Flight Controller highlighting the STM32F405RGT6 master chip
Figure 3.2: Close-up of the F405 Flight Controller, showing the STM32F405RGT6 master chip.
Promotional image showing key features of the F405 BLS 55A 60A Stack
Figure 3.3: Key features of the F405 BLS 55A/60A Stack.

4. Specifications

4.1 F405 Flight Control Specifications

FeatureSpecification
Master chipSTM32F405RGT6
GyroscopeICM42688
Battery Input3-8S
USB PortType-C
BarometerBMP280
OSD chipAT7456E
BluetoothNot Supported
RSSISupport, marked as RSSI
Supported Flight Control FirmwareBetaflight
Firmware NameDAKEFPVF405
Installation Hole Position30.5x30.5mm/M4
Size36mm x 36mm x 8mm
WeightBare board 8g

4.2 55A 4-in-1 ESC Specifications

FeatureSpecification
MCUEFM8BB21F16G-C-QFN20R
Continuous Current55A x 4
Transient Current60A-10S
ProgramBlueJay
MOS3109
TVS Protection DiodeYes
Electrolytic Capacitor1000uF Low ESR Capacitor
Motor ProtocolDshot300/600
Battery Input3-6S Lipo
AmmeterSupport
Power OutputVBAT
Installation Hole Position30.5x30.5mm/M4
SizeLength 43x37x7mm
WeightBare board 12g

4.3 60A 4-in-1 ESC Specifications

FeatureSpecification
MCUEFM8BB21F16G-C-QFN20R
Continuous Current60A x 4
Transient Current65A-10S
ProgramBlueJay
MOS5C430
TVS Protection DiodeYes
Electrolytic Capacitor1000uF Low ESR Capacitor
Motor ProtocolDshot300/600
Battery Input3-8S Lipo
AmmeterSupport
Power OutputVBAT
Installation Hole Position30.5x30.5mm/M4
SizeLength 43x37x7mm
WeightBare board 12g

5. Connection Diagrams

Refer to the following diagrams for proper wiring of your F405 Flight Stack with various components. Ensure all connections are secure and correctly polarized before powering on.

5.1 Analog VTX, GPS, Buzzer, Camera, Receiver, and Motors

F405 Full Socket Version Wiring Diagram for analog VTX, GPS, Buzzer, Camera, Receiver, and Motors
Figure 5.1: Wiring diagram for F405 Flight Stack with analog video transmission (VTX), GPS, buzzer, camera, SBUS receiver, and motors.

5.2 Digital VTX, Camera, and Receiver

F405 Full Socket Version Wiring Diagram for digital VTX, Camera, and Receiver
Figure 5.2: Wiring diagram for F405 Flight Stack with digital video transmission (VTX), camera, and Crossfire Nano Rx receiver.

6. Firmware and Software

The F405 Flight Stack is highly versatile and supports a range of open-source firmware and software for configuration and flight control:

  • Flight Controller Firmware: Betaflight (recommended), ArduPilot, INAV.
  • ESC Firmware: BlueJay (supports bidirectional DSHOT).

For detailed instructions on flashing firmware and configuring settings, please refer to the official documentation of the respective software (e.g., Betaflight Configurator, BlueJay Configurator).

7. Installation

The F405 Flight Stack features a standard installation hole position of 30.5x30.5mm, compatible with M4 screws. When installing, ensure proper isolation between the Flight Controller, ESC, and the drone frame to prevent short circuits. Use the provided silicone vibration absorbers to minimize vibrations affecting the gyroscope.

8. Troubleshooting

While no specific troubleshooting steps are provided, general issues can often be resolved by:

  • Checking Connections: Ensure all wires are securely connected and correctly polarized according to the diagrams.
  • Firmware: Verify that the correct and latest stable firmware versions are flashed to both the Flight Controller and ESC.
  • Configuration: Double-check all settings in your chosen flight control software (e.g., Betaflight Configurator) to ensure they match your drone's components and desired behavior.
  • Power Supply: Confirm that the battery voltage is within the supported range (3-8S Lipo for FC, 3-6S Lipo for 55A ESC, 3-8S Lipo for 60A ESC).

For persistent issues, consult online communities and official documentation for Betaflight, BlueJay, or other relevant software.

9. Package Contents

The package for the 9IMOD F405 Flight Stack typically includes the following items:

9.1 For 55A ESC Version

Package contents for the F405 Flight Control + 55A ESC version
Figure 9.1: Package contents for the F405 Flight Control + 55A ESC version.
  • F405 Flight Controller x 1
  • 55A ESC x 1
  • Package Box x 1
  • TS100 GPS Connect Cable x 1
  • ESC Connect Cable x 1
  • R8SM Receiver Connect Cable x 1
  • Analog Video Transmission Connect Cable x 1
  • Camera Connect Cable x 1
  • ELRS Receiver Connect Cable x 1
  • Power cable + XT60 x 1
  • Low ESR capacitor x 1
  • Silicone vibration absorber x 8
  • Screw x 4
  • Hex nut x 4

9.2 For 60A ESC Version

Package contents for the F405 Flight Control + 60A ESC version
Figure 9.2: Package contents for the F405 Flight Control + 60A ESC version.
  • F405 Flight Controller x 1
  • 60A ESC x 1
  • Package Box x 1
  • TS100 GPS Connect Cable x 1
  • ESC Connect Cable x 1
  • R8SM Receiver Connect Cable x 1
  • Analog Video Transmission Connect Cable x 1
  • Camera Connect Cable x 1
  • ELRS Receiver Connect Cable x 1
  • Power cable + XT60 x 1
  • Low ESR capacitor x 1
  • Silicone vibration absorber x 8
  • Screw x 4
  • Hex nut x 4

10. Statement of Compliance

10.1 Disclaimer

⚠ WARNING: This product can expose you to chemicals including phthalates (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

11. Warranty and Support

For any questions or support regarding your 9IMOD F405 Flight Stack, please contact your seller or refer to the product page for additional information. Specific warranty details are typically provided by the point of purchase.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.