1. Introduction
Welcome to the user manual for your ESKY 1100mm EYAS Radio Control Trainer Airplane. This aircraft is specifically designed to provide an excellent learning experience for beginner and intermediate pilots, offering stable flight characteristics and durable construction. Please read this manual thoroughly before assembly and operation to ensure safe and optimal performance of your model.
2. Safety Information
Operating a radio-controlled aircraft requires caution and responsibility. Failure to operate this product safely and responsibly could result in injury or damage to the product or property. Always follow these safety guidelines:
- Always operate your aircraft in open areas, away from people, buildings, and other obstacles.
- Never fly near airports or restricted airspace.
- Ensure all batteries are fully charged and properly installed before each flight.
- Perform pre-flight checks as described in this manual.
- Do not operate the aircraft in strong winds or adverse weather conditions.
- Keep hands and loose clothing away from the propeller when the motor is active.
- This product is not suitable for children under 14 years of age without direct adult supervision.
3. Package Contents
Upon opening your package, please verify that all components are present:
- ESKY EYAS Airplane (main body)
- Operating Instructions (this manual)
- Original Box (for storage and transport)
- Depending on your selected variant (PNP, PNP with FC, PNP with float), additional components such as a Flight Controller or floats may be included.
Note: Controller battery and main flight battery are not included and must be provided separately.
4. Setup and Assembly
The ESKY EYAS is provided in a "Ready-to-Go" state of assembly, meaning minimal setup is required. However, some steps are necessary before your first flight.
4.1. Battery Installation
- Flight Battery: Install your 3S flight battery (not included) into the designated battery compartment. Ensure it is securely fastened to prevent shifting during flight.
- Controller Battery: Insert the required batteries (self-provided) into your remote control unit. Refer to your remote control's manual for specific battery type and installation instructions.
4.2. Remote Control Binding
Before operating the aircraft, you must bind your remote control (transmitter) to the aircraft's receiver. The ESKY EYAS operates on MODE2. Follow the binding procedure outlined in your remote control's instruction manual. Typically, this involves:
- Powering on the transmitter in binding mode.
- Connecting the flight battery to the aircraft while holding a bind button on the receiver (if applicable).
- Waiting for indicator lights to confirm successful binding.
4.3. Pre-Flight Checks
Always perform these checks before each flight:
- Battery Check: Ensure both flight battery and transmitter batteries are fully charged.
- Control Surfaces: Verify that all control surfaces (ailerons, elevator, rudder) move freely and in the correct direction in response to transmitter inputs.
- Propeller: Check the propeller for any damage (cracks, chips) and ensure it is securely attached.
- Motor: Briefly test the motor at low throttle to ensure smooth operation.
- Environment: Confirm the flying area is clear of obstacles and people, and weather conditions are suitable.

Figure 2: Close-up of the propeller and motor, crucial for pre-flight inspection.
5. Operating Instructions
The ESKY EYAS is designed for ease of use, making it ideal for learning. Familiarize yourself with the controls before attempting your first flight.
5.1. Basic Controls (MODE2)
- Left Stick (Throttle/Rudder):
- Up/Down: Controls throttle (motor speed).
- Left/Right: Controls rudder (yaw, turning the nose left or right).
- Right Stick (Aileron/Elevator):
- Up/Down: Controls elevator (pitch, nose up/down).
- Left/Right: Controls ailerons (roll, banking the wings left or right).
5.2. Takeoff
For ground takeoff, place the aircraft on a smooth, flat surface facing into the wind. Gradually increase throttle while applying slight up elevator to lift off. For hand launch, hold the aircraft firmly, apply full throttle, and gently push it forward into the wind.

Figure 3: The ESKY EYAS airplane in a typical flight-ready stance.
5.3. Flight
Maintain a safe altitude and distance. Practice gentle turns and altitude changes. The EYAS is stable, allowing for easier control. Avoid abrupt movements, especially when learning.
5.4. Landing
Approach the landing area into the wind. Gradually reduce throttle and gently apply up elevator to slow the descent. Aim for a smooth touchdown on the main landing gear, then allow the tail to settle.

Figure 4: The ESKY EYAS equipped with floats, demonstrating its versatility for water operations.
6. Maintenance
Regular maintenance will extend the life of your ESKY EYAS airplane.
- Cleaning: Wipe down the aircraft with a soft, dry cloth after each flight to remove dirt and debris.
- Propeller Inspection: Regularly check the propeller for nicks, cracks, or bends. Replace damaged propellers immediately.
- Control Linkages: Ensure all control linkages are free from obstruction and securely connected.
- Motor and ESC: Keep the motor and Electronic Speed Controller (ESC) free from dust and ensure they are not overheating.
- Battery Care: Store flight batteries in a cool, dry place at storage voltage. Do not overcharge or over-discharge.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Aircraft does not respond to controls. | Transmitter not bound, low battery in transmitter or aircraft, range issue. | Re-bind transmitter, charge/replace batteries, ensure clear line of sight. |
| Motor not spinning. | Battery not connected, ESC not armed, motor/ESC fault. | Check battery connection, ensure throttle is at zero before connecting flight battery, inspect motor/ESC for damage. |
| Aircraft flies erratically or drifts. | Control surfaces misaligned, trim settings incorrect, strong winds. | Check control surface alignment, adjust trim on transmitter, avoid flying in windy conditions. |
| Short flight time. | Battery not fully charged, old/damaged battery, aggressive flying. | Ensure battery is fully charged, replace old batteries, fly more conservatively. |
8. Specifications
| Feature | Detail |
|---|---|
| Model Number | ESKY Eagles |
| Type | Airplane |
| Material | Metal, Plastic |
| State of Assembly | Ready-to-Go |
| Dimensions | 100cm-150cm |
| Drone Weight | 775G |
| Remote Distance | 1000M |
| Flight Time | 10~20 minutes |
| Control Channels | 4 channels |
| Controller Mode | MODE2 |
| Remote Control | Yes |
| Controller Battery | Self-provided |
| Power Source | Electric |
| Charging Voltage | 3S |
| Is Batteries Included | No |
| Indoor/Outdoor Use | Indoor-Outdoor |
| Operator Skill Level | Beginner, Intermediate, Expert |
| Recommend Age | 14+ years |
| Certification | CE |
| Aerial Photography | No |
| Video Capture Resolution | Other |
| Camera Mount Type | Other |
| Origin | Mainland China |
9. User Tips
- Start with a Simulator: If you're a complete beginner, consider practicing on an RC flight simulator before your first real flight.
- Find an Open Field: Always choose a large, open area free from trees, power lines, and people for your flights.
- Wind Conditions: For your first flights, choose a day with little to no wind. As you gain experience, you can gradually fly in light winds.
- Battery Management: Always carry spare charged batteries for both the aircraft and the transmitter to maximize flying time and avoid unexpected power loss.
- Post-Crash Inspection: After any hard landing or crash, thoroughly inspect the aircraft for damage before attempting another flight. Pay close attention to the propeller, wings, and control surfaces.
10. Warranty and Support
For any issues not covered in this manual, or for warranty claims, please contact the retailer or manufacturer directly. Keep your purchase receipt as proof of purchase.
Disclaimer: This product is not suitable for children under 36 months due to small parts and potential hazards. Recommended age is 14+ years.
