Introduction
This manual provides instructions for the proper use and maintenance of your Philips electric toothbrush handle, compatible with models HX681, HX682, and HX686. Please read these instructions carefully before first use and keep them for future reference. This product is an electric toothbrush handle and does not include brush heads or chargers unless specified by your retailer.
1. Setup
1.1 Unpacking
Carefully remove your new toothbrush handle from its packaging. Inspect the handle for any visible damage. Ensure all components received match your order.
1.2 Initial Charge
Before first use, it is recommended to fully charge the toothbrush handle. Place the handle onto a compatible Philips charging base (not included with handle purchase). The charging indicator lights on the handle will illuminate to show the charging status. A full charge typically takes 24 hours.
Image: Four Philips electric toothbrush handles (black, light green, light yellow, dark khaki) displaying their design and charging indicators at the base.
1.3 Attaching a Brush Head
Align a compatible Philips brush head (not included) with the metal shaft on the toothbrush handle. Push the brush head down firmly until it clicks into place. There should be a small gap between the brush head and the handle.
2. Operating Your Toothbrush Handle
2.1 Power On/Off
Press the power button (usually the top button) once to turn the toothbrush on. Press it again to turn it off.
Image: A Philips HX682 electric toothbrush handle, highlighting the power and mode selection buttons, with 'clean', 'gum care', and 'white' mode indicators.
2.2 Selecting a Brushing Mode
Your toothbrush handle may feature multiple brushing modes. After turning the toothbrush on, press the mode selection button (usually the bottom button, if present) to cycle through available modes. The active mode will be indicated by an illuminated light next to the mode name on the handle.
- Clean: Standard mode for daily, superior cleaning.
- Gum Care: Gentle massage for gums, ideal for sensitive areas.
- White: Designed to remove surface stains for a brighter smile.
2.3 Brushing Technique
Wet the brush head and apply a small amount of toothpaste. Place the brush at a 45-degree angle to your gums, ensuring the bristles reach both the tooth surface and the gumline. Gently move the brush across your teeth. The toothbrush will provide a timed brushing experience, typically 2 minutes, with quadpacer intervals to signal when to move to a different section of your mouth.
3. Maintenance and Care
3.1 Cleaning the Brush Head and Handle
After each use, rinse the brush head thoroughly under running water while the toothbrush is still on to remove any remaining toothpaste and debris. Turn off the toothbrush, remove the brush head, and rinse both the brush head and the metal shaft area of the handle. Wipe the toothbrush handle with a damp cloth. Do not immerse the handle in water.
3.2 Replacing the Brush Head
For optimal performance and hygiene, replace your brush head every 3 months, or sooner if the bristles are splayed or worn. To replace, pull the old brush head straight off the handle and push a new, compatible Philips brush head onto the shaft until it clicks into place.
3.3 Storage
Store the toothbrush handle in a dry place when not in use. If storing for an extended period, ensure the handle is fully charged to maintain battery health.
4. Troubleshooting
- Toothbrush not turning on: Ensure the handle is fully charged. If it still doesn't turn on, try placing it on the charger for a few minutes.
- Reduced brushing power: This usually indicates a low battery. Recharge the handle fully. If the issue persists after charging, the battery may be nearing the end of its lifespan.
- Brush head not staying on: Ensure the brush head is correctly aligned with the metal shaft and pushed down firmly until it clicks. If the brush head is old or damaged, replace it with a new one.
- Charging indicator not working: Check if the charger is properly plugged into a working outlet and if the handle is correctly seated on the charging base.
5. Specifications
| Feature | Detail |
|---|---|
| Product Type | Electric Toothbrush Parts (Handle) |
| Compatible Models | Philips HX681, HX682, HX686 |
| Origin | Mainland China |
| High-concerned chemical | None |
| Approx. Package Dimensions (L x W x H) | 40 cm x 20 cm x 20 cm |
| Approx. Package Weight | 0.16 kg |
6. User Tips
- For optimal battery life, avoid fully discharging the handle frequently. It's best to keep it charged regularly.
- Always rinse the brush head thoroughly after use to prevent toothpaste buildup and ensure hygiene.
- If traveling, ensure the handle is fully charged and consider using a travel case to protect the brush head and prevent accidental activation.
- Periodically clean the charging contacts on both the handle and the charging base to ensure efficient charging.
7. Warranty and Support
For detailed warranty information, product registration, and customer support, please refer to the official Philips website or contact your authorized retailer. It is advisable to retain your proof of purchase for any warranty claims or service requests.