Ausom L1 E-Scooter User Manual

1. Introduction

Welcome to the Ausom L1 E-Scooter user manual. This guide provides essential information for the safe operation, maintenance, and troubleshooting of your new electric scooter. Please read this manual thoroughly before your first ride to ensure optimal performance and safety.

Important Safety Notice

⚠️ Please mind potential fire risk and strictly follow the instruction manual for charging and storage. While using the product, please wear protective equipment and fully comply with the applicable law and regulations.

2. Package Contents

Ensure all items are present in the package:

• 1 x Ausom L1 E-Scooter
• 1 x User Manual (this document)
• 1 x Charger
• 1 x 3mm Allen Key
• 1 x 4mm Allen Key
• 3 x NFC Card (One with Lanyard)
• 1 x Gloves

3. Setup and Assembly

Unfolding the Scooter

The Ausom L1 E-Scooter is designed for easy portability and folds in three quick steps. To unfold, reverse the folding process:

1. Release the folding mechanism latch (typically located near the base of the handlebar stem).
2. Carefully raise the handlebar stem until it locks securely into place.
3. Ensure all locking mechanisms are engaged before riding.

Handlebar Adjustment

The handlebar height can be adjusted to suit riders between 150cm and 200cm (4'11"-6'7"). Use the quick-release lever or adjustment mechanism on the handlebar stem to set it to a comfortable height, then secure it firmly.

4. Operating Instructions

Power On/Off and NFC Access

To power on your Ausom L1 E-Scooter, use one of the provided NFC cards. Tap the NFC card against the designated area on the display. The scooter will power on, and the 4.5-inch LCD display will activate. To power off, typically hold the power button or tap the NFC card again. The built-in NFC and password unlocking system ensures secure access.

Riding

• Starting: With the scooter powered on, place one foot on the deck and push off with the other foot to gain initial momentum. Once moving, gently press the responsive throttle to engage the motor.
• Speed Control: Use the responsive throttle to control your speed. The 800W brushless motor provides rapid acceleration up to 45 km/h (28 mph).
• Display Information: The 4.5-inch LCD screen provides real-time information including current speed, battery level, and selected riding mode (PARK, ECO, SPORT, RACE).
• Braking: The scooter is equipped with E-ABS and dual front & rear disc brakes for instant and confident stopping power. Squeeze the brake levers on the handlebars to slow down or stop. E-ABS assists in controlled braking, even on slippery surfaces.
• Visibility: The full LED lighting system includes a powerful headlight, taillight, brake light, and turn signals. Use the turn signal toggle switch on the handlebar to indicate turns and ensure you are visible to others, especially in low-light conditions.

Charging the Battery

To charge the scooter, connect the charger to the charging port on the scooter and then plug it into a standard 100-240V AC outlet. The charging time is approximately 11 hours for a full charge. Always use the provided charger.

5. Maintenance

• Tire Pressure: Regularly check the tire pressure of your 10" tubeless tires. The best tire pressure is 36 PSI. Proper inflation ensures optimal ride quality, range, and tire longevity.
• Cleaning: Clean the scooter regularly with a damp cloth. Avoid using high-pressure water jets directly on electronic components.
• Brake Inspection: Periodically inspect the brake levers, cables, and disc pads for wear and proper function. Adjust or replace components as needed.
• Battery Care: To prolong battery life, avoid completely draining the battery and store the scooter in a cool, dry place when not in use. Follow the safety notice regarding charging and storage to prevent fire risks.
• General Check: Before each ride, perform a quick check of all bolts, nuts, and quick-release mechanisms to ensure they are tight and secure.

6. Troubleshooting

This section addresses common issues you might encounter with your Ausom L1 E-Scooter.

• Scooter does not power on:
  • Ensure the battery is charged.
  • Verify the NFC card is correctly tapped to the display.
  • Check for any loose connections.
• Reduced range or power:
  • Check tire pressure; under-inflated tires can reduce range.
  • Ensure the battery is fully charged.
  • Riding conditions (uphill, heavy load, strong winds) can affect range.
• Brakes feel weak or noisy:
  • Inspect brake pads for wear and replace if necessary.
  • Check brake cables for proper tension and adjustment.
  • Clean disc rotors if they are contaminated.
• Unusual noises during operation:
  • Check for loose components or fasteners.
  • Inspect wheels and suspension for any obstructions or damage.

If you encounter issues not covered here or require further assistance, please contact customer support.

7. Specifications

Detailed technical specifications for the Ausom L1 E-Scooter:

Note: The Ausom lab achieved maximum range with a load of 65 kg (143 lbs), riding at a constant speed of 15km/h (9 mph) on a flat road at 20℃ (68℉) without strong winds. Actual range may vary based on rider weight, terrain, speed, and environmental conditions.

8. User Tips

• For optimal range, maintain consistent speeds and ensure tires are properly inflated to 36 PSI.
• Always wear a helmet and appropriate safety gear when riding.
• Familiarize yourself with local e-scooter regulations before riding on public roads.
• Utilize the NFC lock feature for enhanced security when parking your scooter.
• The swingarm suspension and 10-inch tubeless tires are designed for various terrains; however, always ride cautiously on uneven surfaces.

9. Warranty and Support

For warranty information, technical support, or service inquiries, please refer to the seller's official website or contact their customer service department. Keep your purchase receipt as proof of purchase.