Flytec V060

Contents

Flytec New V060 RC Carp Fishing Bait Boat Instruction Manual

Model: V060

1. Introduction

The Flytec New V060 RC Carp Fishing Bait Boat is an advanced remote-controlled vessel designed for efficient carp fishing. Featuring GPS anchor points, a robust loading capacity, and a durable carbon fiber color finish, this boat enhances your fishing experience by precisely delivering bait to desired locations. This manual provides essential information for the safe and effective operation and maintenance of your bait boat.

Flytec V060 RC Carp Fishing Bait Boat and Remote Control

Figure 1: Flytec V060 RC Carp Fishing Bait Boat with Remote Control

2. Setup

2.1 Unpacking and Inspection

Carefully remove all components from the packaging. Inspect the bait boat and remote control for any signs of damage. Ensure all listed components are present.

2.2 Battery Installation and Charging

Controller Battery: The remote controller requires 4 x 1.5V AA batteries (not included). Open the battery compartment on the back of the remote control and insert the batteries, observing correct polarity.

Boat Battery: The bait boat uses a 7.4V rechargeable battery (5200mAh, 12000mAh, or 18000mAh, depending on your model). Install the battery into the large battery compartment. The boat supports connecting two batteries simultaneously for extended operation.

Diagram showing the large battery compartment supporting dual batteries

Figure 2: Large Battery Compartment supporting dual batteries

Charging Times:

  • 7.4V 5200mAh: Approximately 6 hours
  • 7.4V 12000mAh: Approximately 8 hours
  • 7.4V 18000mAh: Approximately 10 hours

Ensure the boat battery is fully charged before first use.

2.3 Antenna Installation

Attach the antenna to the designated port on both the bait boat and the remote control. Ensure they are securely fastened for optimal signal transmission.

2.4 Initial Pairing

Turn on both the bait boat and the remote control. Press the 'Pairing button' on the remote control (refer to Figure 4 for location) to establish a connection. The power indicator on the remote will confirm successful pairing.

3. Operating Instructions

3.1 Remote Control Overview

Diagram of the GPS remote controller with labeled buttons

Figure 3: GPS Controller Layout

The remote control features an LCD display and various buttons for precise control:

  • Antenna: For signal transmission.
  • Lighting button: Controls the boat's navigation lights.
  • Power indicator: Shows remote control power status.
  • Left joystick: Controls boat direction (forward/backward, left/right turns).
  • Pairing button: Used to connect the remote with the boat.
  • Switch: Main power switch for the remote.
  • Left trim: Fine-tunes left/right movement.
  • Calibration: For GPS system calibration.
  • Cruise button: Activates fixed-speed cruise mode.
  • Original point button: Sets or returns to the original starting point.
  • Delete button: Deletes saved GPS points.
  • Right joystick: Controls bait silo release.
  • Silo button: Releases bait from the silo.
  • Right trim: Fine-tunes forward/backward movement.
  • Setting button (Up, Left, Right, Down): Navigates menus and adjusts settings on the LCD.

3.2 Basic Maneuvering

Use the left joystick to control the boat's movement: push forward for forward motion, pull back for reverse, and move left or right for turns. The boat features automatic correction of yaw for stable sailing.

3.3 Fixed-Speed Cruise Control

To activate fixed-speed cruise control, push the direction control stick (left joystick) forward, then press the 'cruise button' for approximately 2 seconds. The boat will maintain a constant speed in a straight line. The sailing direction can still be adjusted using the remote control while in cruise mode.

Diagram illustrating one-button fixed-speed cruise control

Figure 4: Fixed-Speed Cruise Control Activation

3.4 GPS Positioning and Anchor Points

The V060 bait boat is equipped with a GPS system that supports 160 positioning points, organized into 4 fishing grounds (40 points per ground). This allows for precise bait delivery and return to specific locations.

Diagram showing 160 GPS positioning points across 4 fishing grounds

Figure 5: GPS Positioning Points

Use the 'Original point button' to set your home point or return the boat to a previously saved location. The 'Delete button' can be used to clear saved points.

3.5 Bait Delivery

Load your bait into the large capacity bait tank. Once the boat is at the desired location, use the 'Silo button' on the remote control to release the bait.

3.6 Night Fishing

The boat features bright night navigation lights. Two white lights are located at the bow, and blue steering lights are on both sides of the stern. These lights help you easily identify the boat's sailing direction in low-light conditions.

Image showing the bait boat with bright night lights activated

Figure 6: Bright Night Lights for visibility

4. Maintenance

4.1 Cleaning

After each use, especially in saltwater, rinse the boat thoroughly with fresh water to remove any debris, salt, or bait residue. Ensure all compartments are dry before storage.

4.2 Battery Care

  • Always fully charge batteries before storage if they will not be used for an extended period.
  • Store batteries in a cool, dry place away from direct sunlight.
  • Do not overcharge or completely drain the batteries.
  • If using dual batteries, ensure both are in good condition.

4.3 General Storage

Store the bait boat and remote control in a dry, protected environment. Ensure the anti-tangle protection cover is clean and free from obstructions.

5. Troubleshooting

5.1 Common Issues and Solutions

ProblemPossible CauseSolution
Boat not responding to remoteLow battery in boat or remote; remote out of range; pairing issue.Check and charge all batteries. Ensure remote is within 500m. Re-pair the remote and boat.
Boat automatically returns to original pointLow battery alarm or over-distance return activated.This is a safety feature. Recharge the boat battery. Ensure you operate within the 500m control distance.
Inaccurate GPS positioningPoor satellite signal; calibration needed.Operate in an open area with clear sky. Perform a GPS calibration using the remote control.
Bait silo not releasingObstruction in silo; mechanical issue.Check for any debris or tangled lines in the bait silo mechanism. Ensure the silo button is pressed firmly.
Image illustrating low battery alarm and over-distance return features

Figure 7: Low Battery Alarm and Over-Distance Return Safety Features

6. Specifications

FeatureDetail
Model NumberV060
Brand NameFlytec (also XMSJ, Flying)
MaterialABS Plastic & Electronic parts
ColorCarbon Fiber
Product Size51.4 x 26.4 x 29.5 cm (20.2 x 10.4 x 11.6 inch)
Load Capacity2 kg (4.4 lbs)
Control Distance500 meters
Speed250 M/Mins
GPSYes, with Beidou Intelligent Calibration System
Anchor Points160 (4 fishing grounds, 40 points each)
Hopper Quantity1
Boat Battery7.4V 5200mAh/12000mAh/18000mAh (optional)
Control Time2-6 hours (depending on battery capacity)
Controller Battery4 x 1.5V AA Battery (Not Included)
CertificationCE
OriginMainland China
Diagram showing the dimensions of the bait boat and battery compartment

Figure 8: Bait Boat Dimensions

7. User Tips

  • Always perform a quick check of both boat and remote control battery levels before heading out for fishing.
  • Familiarize yourself with the GPS functions, especially setting and returning to anchor points, to maximize efficiency and prevent loss.
  • Practice basic maneuvering in a clear area before attempting complex bait drops.
  • Utilize the night lights for better visibility and control during evening or early morning fishing sessions.
  • Keep the anti-tangle protection cover clean to ensure smooth operation of the propellers.

8. Warranty and Support

For any questions, technical support, or warranty inquiries, please contact our customer service. All inquiries will be answered within 24 hours.

Contact Information:

Contact information including WhatsApp, Telephone, and Email

Figure 9: Customer Service Contact Details


Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.