Introduction
This manual provides essential information for the setup, operation, maintenance, and troubleshooting of your HSP 94188 1:10 Scale Nitro Gas Power RC Truck. Designed for off-road enthusiasts, this 4WD high-speed hobby remote control truck features a powerful 18CXP nitro engine and a robust chassis for an exhilarating experience. Please read this manual thoroughly before operating your RC truck to ensure safe and optimal performance.
Front-side view of the HSP RC Nitro Gas Power Hobby Truck, showcasing its vibrant body design and large off-road tires.
Warning: Not suitable for children under 36 months. Adult supervision is required during operation. Always take care when handling and operating the vehicle.
Setup
Your HSP 94188 RC Truck comes in a Ready-to-Go (RTR) state, meaning most assembly is complete. However, some initial setup is required before its first use.
- Unpacking: Carefully remove all components from the original packaging box. Ensure all parts listed in the 'Package Includes' section are present.
- Remote Controller Batteries: The remote controller requires batteries (not included). Open the battery compartment on the remote controller and insert the required batteries, observing correct polarity.
- Fueling: This is a nitro-powered vehicle. Fill the extra-large capacity leak-proof fuel tank with appropriate nitro fuel. Ensure the spring-load fill cover is securely closed after fueling. Do not overfill.
- Initial Checks: Before starting the engine, perform a visual inspection:
- Check all screws and fasteners for tightness.
- Ensure the wheels are securely attached.
- Verify that the steering and throttle servos respond correctly to the remote controller inputs.
- Inspect fuel lines for any kinks or leaks.
Overhead view of the complete chassis layout, illustrating the placement of all major components.
Operating Instructions
Familiarize yourself with the remote controller and the vehicle's controls before attempting high-speed operation.
Remote Control
- Your truck is controlled by a 2-channel remote controller operating in MODE2.
- The remote control range is approximately 150 meters.
- Ensure the remote controller is powered on before the vehicle.
Engine Start (Nitro 18CXP)
- Ensure the fuel tank is filled.
- Prime the engine by covering the exhaust pipe and pulling the pull-starter a few times until fuel reaches the carburetor.
- Insert a glow plug igniter onto the glow plug.
- Pull the pull-starter firmly and smoothly until the engine starts. Remove the glow plug igniter once the engine is running.
- Allow the engine to warm up for a few minutes before driving.
Close-up of the 18CXP nitro engine with its blue cooling head and exhaust manifold.
Driving
- The truck features a 4-wheel drive system and a two-speed transmission for versatile off-road performance.
- It can reach speeds of 60-70 km/h.
- Use the throttle trigger on the remote for forward and reverse movement, and the steering wheel for direction.
Braking
- The truck is equipped with a disc brake system for quick and responsive stopping.
- Apply brakes gently to avoid skidding, especially at high speeds.
Expected run time is approximately 6-15 minutes, depending on driving style and tuning.
Maintenance
Regular maintenance is crucial for the longevity and performance of your HSP 94188 RC Truck.
- Engine Care: The 18CXP nitro engine operates at high RPMs (up to 36000rpm). After each run, clean the engine thoroughly, check the glow plug, and ensure proper lubrication. Refer to specific nitro engine maintenance guides for detailed instructions.
- Chassis and Suspension: The 6061/T6 solid anodized aluminum chassis provides durability. Regularly inspect the oil-filled shock absorbers, universal joint cups, and ball bearings for wear or damage. Keep the chassis clean from dirt and debris.
- Tires: The pre-trimmed aggressive durable tires are designed for off-road use. Check for wear, punctures, and ensure they are securely mounted.
- Air Filter: The high-flow dual foam element air filter is user-serviceable. Clean or replace it regularly, especially after dusty conditions, to prevent dirt from entering the engine.
- Differentials: The front/rear differentials feature good quality bevel gears and are designed with 5 screws for easy maintenance. Periodically inspect and lubricate the differential gears.
- Fuel System: Keep the fuel tank and fuel lines clean. Ensure the fuel tank cap seals properly to prevent leaks.
- Brake System: The disc brake system uses user-replaceable pads. Check the pads for wear and replace them as needed to maintain effective braking.
Detailed view of the front suspension system, including shock absorbers and control arms.
Troubleshooting
Here are some common issues and their potential solutions:
- Engine Not Starting:
- Check fuel level.
- Ensure glow plug is functional and igniter is charged.
- Verify engine is primed correctly.
- Check for air leaks in fuel lines or carburetor.
- Loss of Control/Poor Response:
- Check remote controller batteries.
- Ensure vehicle receiver batteries (if applicable) are charged.
- Verify antenna is properly extended on both remote and vehicle.
- Inspect servo connections and functionality.
- Engine Stalling:
- Check engine tuning (carburetor settings).
- Ensure fuel flow is unobstructed.
- Inspect air filter for clogging.
Specifications
| Feature | Specification |
|---|---|
| Model Number | 94188 |
| Scale | 1:10 |
| Type | Car (Off-road Truck) |
| Drive System | 4-Wheel Drive (4WD) |
| Engine | 18CXP Nitro Engine |
| Displacement | 2.95cc |
| Max Engine Speed | 36000rpm |
| Power | 1.0hp (Max 1.80HP) |
| Top Speed | 60-70 km/h |
| State of Assembly | Ready-to-Go (RTR) |
| Remote Control | Yes |
| Control Channels | 2 CHANNELS |
| Controller Mode | MODE2 |
| Remote Distance | About 150m |
| Run Time (Flight Time) | About 6~15min |
| Material | Plastic (Body), 6061/T6 Anodized Aluminum (Chassis) |
| Dimensions (L*W*H) | 420mm * 330mm * 185mm (Truck), 61 * 34 * 23cm (Package) |
| Wheelbase | 275mm |
| Tire Track | 210mm |
| Ground Clearance | 32mm |
| Wheels | 120mm * 60mm |
| Gear Ratio | 1:13.3 |
| Throttle Servo | 3KG |
| Steering Servo | 3KG |
| Torque | 3kg |
| Carburetor | 7mm |
| Crankshaft | 12mm OS |
| Exhaust Mode | Side-discharge |
| Is Electric | No Battery (Nitro Powered) |
| Is Batteries Included | No |
| Package Weight | 2.0 kg |
| Package Includes | Original Box, Operating Instructions, Remote Controller |
Packaging box for the HSP RC Truck, displaying product images and dimensions (600mm x 350mm x 230mm).
User Tips
- Many users enjoy upgrading their RC trucks. Common upgrades include remote start systems, fuel filters, exhaust coolers, and lighting kits.
- The truck is noted for its solid build quality, making it a good platform for both beginners and those looking to customize.
- The vehicle comes pre-assembled ('Ready-to-Go'), so you can get started quickly after initial setup.
Warranty and Support
This product typically comes with a 1-month warranty. For any issues or support inquiries, please contact your retailer or the manufacturer directly. Ensure you retain your proof of purchase for warranty claims.