1. Introduction
Thank you for choosing the Wancle CBG-9000/9002 Conical Burr Coffee Grinder. This manual provides essential information for the safe and efficient use, maintenance, and troubleshooting of your appliance. Please read it thoroughly before first use and keep it for future reference.

Image: The Wancle CBG-9000/9002 Conical Burr Coffee Grinder, showing the bean hopper, ground coffee container, and control knob.
2. Safety Instructions
- Please read the instructions for use carefully before using your appliance for the first time and retain them for future reference: Wancle cannot accept any liability for non-compliant appliance use.
- Do not use the appliance if it has been dropped and there is visible damage to it (e.g. the protection panel), or if it fails to function normally. In this case, it must be sent to an approved service center.
- If the power cable is damaged it must be replaced by the manufacturer, an approved service center, or a similarly qualified person, to avoid danger.
- Always unplug the appliance as soon as you stop using it, if you leave it unattended or during assembly, disassembly, or cleaning.
- This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
- This appliance may be used by persons with a lack of experience and knowledge or reduced physical, sensory, or mental capabilities, as long as they are supervised or have been instructed about using the appliance safely and are fully aware of the dangers involved.
- Children shall not play with the appliance.
- Please handle the knife with care when the container is empty and during cleaning, the blades are very sharp.
- Check that your power supply voltage corresponds to that shown on the appliance (alternating current only). Any error in plugging in your appliance may cause irreversible damage and invalidate the guarantee.
- This appliance is not intended to be used by persons (including children) with reduced physical, sensory, or mental capacities, or persons lacking in experience or knowledge, unless they are supervised or have been instructed about using the appliance by a person responsible for their security.
- In the interests of safety, only use Wancle accessories and spare parts designed for your appliance.
- Warning: Any misuse could lead to potential injury.
- Warning: The appliance must not be immersed in water or any other liquid.
- This appliance is intended for indoor, domestic household use only. It is not intended to be used in the following applications, and the guarantee will not apply for:
- staff kitchen areas in shops, offices, and other working environments;
- farmhouses;
- by clients in hotels, motels, and other residential type environments;
- bed and breakfast type environments.
- Refer to the instructions for initial and regular cleaning of surfaces in contact with foodstuff and for cleaning and maintenance of your appliance.
3. Product Overview
Familiarize yourself with the components of your Wancle Coffee Grinder:
- A. Bean hopper: Holds whole coffee beans.
- B. Bean hopper lid: Covers the bean hopper.
- C. Body of appliance: The main unit housing the motor and grinding mechanism.
- D. Switch (ON/OFF): Power button to start and stop grinding.
- E. Removable upper mill: The top burr grinder component that can be removed for cleaning.
- F. Ground coffee holder: Collects the ground coffee.
- G. Ground coffee holder lid: Covers the ground coffee holder.
- H. Number of cups selector: Dial to select the desired quantity of coffee.
- I. Grind setting: Adjustable ring to select the fineness of the grind.
- J. Powder blower: Used to clear residual grounds from the grinding system.
4. Setup
Before First Use
- Remove all packaging materials from the appliance.
- Place the appliance on a dry, level, and stable surface.
- Ensure that the mains voltage in your household matches the information on the product label located on the base of the appliance.
- Align the holder of the removable upper mill with the arrow on the main body, then place it down onto the machine.
- Insert the bean hopper (funnel) with its arrow aligned with the arrow on the main body, then twist the hopper clockwise to the desired grind setting.
Initial Assembly Steps
- Remove the ground coffee holder lid and ensure the holder is correctly positioned in the base.
- Remove the bean hopper lid and add whole coffee beans into the bean hopper. Replace the bean hopper lid, ensuring it is correctly positioned.
- Attach the powder blower to the bean hopper by popping the upper cover onto it.
Video: Demonstrates the assembly and initial setup of the coffee grinder, including placing the hopper, adding beans, and inserting the powder chamber.
5. Operating the Appliance
- Set Grind Fineness: Adjust the grind setting selector to your desired level (refer to the 'Grind Settings' section for guidance).
- Plug In: Connect the appliance to a suitable power outlet.
- Start Grinding: Press the ON/OFF switch (D) to begin grinding.
- Automatic Stop: The appliance will automatically stop once the selected quantity of coffee has been milled.
- Manual Stop: To stop the appliance before the cycle completes, press the ON/OFF switch again.
- Clear Residual Grounds: After grinding, attach the powder blower (J) to the bean hopper and press down on its top to blow out any residual grounds from the grinding system.
- Collect Ground Coffee: Remove the ground coffee holder (F), gently tap the receptacle, and pour the ground coffee directly into your coffee maker's filter or use a measuring spoon for espresso machines.
- Additional Grinding: To obtain more ground coffee, you can repeat the operating cycle by pressing the ON/OFF switch again.
Caution!
- For your appliance to run correctly, make certain that:
- The bean hopper is correctly positioned.
- The removable upper mill is correctly placed in the body of the appliance.
6. Grind Settings
Grind Setting Advice
Use the grind setting selector (I) to adjust the fineness of your ground coffee according to your coffee maker type and personal taste. For first-time use, we recommend starting with an intermediate position suitable for your coffee maker, then fine-tuning it to your preference. Once you've used the appliance a few times, you will find your ideal grind. Do not change the grind setting while the mill is running.

Image: Close-up of the grinding knob, showing settings from fine to coarse.

Image: Visual guide illustrating 25 grind settings from fine to coarse, with recommendations for espresso, fine grind, medium grind, and coarse grind.
Recommendations for Grind Fineness
| Gear | Thickness | Suitable for | Concentration |
|---|---|---|---|
| 1~4 | Extra Fine | Italian | Extra Thick |
| 5~8 | Slightly Fine | Moka pot | Thick |
| 9~13 | Fine | Siphon pot or ice brew | Medium Thick |
| 14~17 | Medium | Drip pot | Light |
| 18~21 | Coarse | Hand pouring | Light |
| 22~25 | Very coarse | French press | Light |
7. Cup Selection
Advice to Select the Number of Cups
Use the number of cups selector (H) to program the quantity of ground coffee you desire. The more cups you select, the longer the appliance will operate.

Image: The grinding knob with cup selection from 2 to 12, indicating a quick preset cup mode.
8. Maintenance
General Maintenance
- Always unplug your appliance before cleaning.
- Never place the body of the appliance, power supply cord, or plug in water or under running water.
- Do not use detergents or abrasive pads to clean the appliance.
- Clean the lids and the ground coffee holder in warm, soapy water.
- Over time the color of the coffee beans may stain the plastic parts of your appliance; this is normal.
- These parts may be cleaned by soaking them in mild bleach (non-abrasive) straight after use.

Image: Demonstrates the use of the powder blower for effortless cleaning and residue removal.

Image: Comparison showing a clean powder chamber (left) versus one with static buildup (right), highlighting the grinder's static-control technology.
Disassembling the Upper Grinding Head
- Turn the bean hopper (funnel) counterclockwise until it stops. Align the arrow on the body with the arrow on the funnel, then remove the funnel.
- Align the holder of the removable upper mill (E) with the arrow on the main body (C), then lift it upwards to remove.
- Use a damp cloth to carefully clean the inside of the bean hopper.
Installing the Funnel
- Return the removable upper mill (E) to the machine. Ensure its holder is aligned with the arrow on the main body (C).
- Insert the bean hopper (funnel) with its arrow aligned with the arrow on the main body (C), then rotate the funnel clockwise to the desired position.
- Carefully clean the ground coffee dispenser and the body of the appliance using a damp cloth.
Notice for Assembly/Disassembly
- When disassembling and installing the funnel of the flat grinder coffee machine, please align the arrow on the coffee funnel with the arrow on the top of the body, so that the funnel can be taken out or installed.
- The holder of the removable upper mill is aligned with the arrow on the main body. Only then can the funnel be assembled.
9. Troubleshooting
The appliance does not operate or stops during operation
- Check the electrical connection.
- The bean hopper is not positioned correctly or not fitted.
- The appliance is switched off automatically due to motor overheats.
- A coffee bean may have jammed the burrs.
The automatic dosing quantity is not to your liking.
- Doses of coffee are programmable; refer to the programming section for reference.
10. Specifications
| Attribute | Value |
|---|---|
| Model | CBG-9000/9002 |
| Power (W) | 200W |
| Voltage | US: 120 VAC, 60 Hz; EU: 220-240 VAC, 50/60HZ |
| Product Weight | 1.0kg (2.2lb) |
| Product Size | 185 x 96 x 237.5 mm (7.28 x 3.78 x 9.35 in) |
| Housing Material | ABS |
| Type | Burr Grinders (Conical) |
| Number of grinding levels | 11 or more (25 precise grindings) |
| Loading coffee beans | up to 90 gr |
| Certification | ETL, CE, EMC, RoHS |

Image: Diagram showing the dimensions of the coffee grinder: 9.5cm (width), 18cm (depth), 23.5cm (height). Bean hopper capacity 90g, ground coffee container capacity 120g.
11. User Tips
Advice about Coffee
- The aroma of coffee depends on the quality of the grind.
- Generally, the quicker the coffee-making technique, the finer the ground coffee should be.
- The grind used for an espresso is therefore finer than that for a filter coffee.
- A very fine ground coffee intended for espresso will give you a bitter-tasting coffee when used for a filter coffee.
- Using a coarser grind for an espresso coffee will give you a weak-tasting coffee.
- Once you have chosen the appropriate coffee ground fineness for your coffee-maker, you can just add more ground coffee to get a stronger taste without any additional bitterness.
Practical Hints
- Keep your coffee beans in the refrigerator in a sealed container. To preserve the full aroma of your coffee, we advise you to grind your coffee just a few moments before making it.
12. Warranty and Support
Wancle Limited Guarantee
Wancle guarantees this product against any manufacturing defect in materials or workmanship for 1 year, starting from the initial date of purchase or delivery date.
This manufacturer's commercial guarantee covers all costs related to restoring the proven defective product so that it conforms to its original specifications, through the repair or replacement of any defective part and the necessary labor.
- At Wancle's choice, a replacement product may be provided instead of repairing a defective product.
- Wancle's sole obligation and your exclusive resolution under this guarantee are limited to such repair or replacement.
Conditions & Exclusions
- Wancle shall not be obliged to repair or replace any product which is not accompanied by a valid proof of purchase.
- The defective product may be returned to the store of purchase.
- This guarantee applies only for products purchased and used for domestic purposes and will not cover any damage which occurs as a result of misuse, negligence, failure to follow Wancle instructions, or a modification or unauthorized repair of the product, faulty packaging by the owner, or mishandling by any carrier.
- It also does not cover normal wear and tear, maintenance or replacement of consumable parts, or the following:
- using the wrong type of water or consumable
- mechanical damages, overloading
- damages or poor results specifically due to wrong voltage or frequency as stamped on the product ID or specification
- the ingress of water, dust, or insects into the product
- scaling (any de-scaling must be carried out according to the instructions for use)
- damage as a result of lightning or power surges.
- damage to any glass or porcelain ware in the product
- accidents including fire, flood, etc
- professional or commercial use
Consumer Statutory Rights
- Wancle's commercial guarantee does not affect the Statutory Rights a consumer may have or those rights that cannot be excluded or limited, nor rights against the retailer from which the consumer purchased the product.
- This guarantee gives a consumer specific legal rights, and the consumer may also have other legal rights which vary from Country to Country.
- The consumer may assert any such rights at his sole discretion.
For a detailed user manual in PDF format, please refer to: Wancle CBG-9000/9002 User Manual (PDF)
13. Contact Information
Manufacturer Information
Company Name: Dongguan Pinle Electronic Technology Co., Ltd
Company Address: tangxiazhen, tangxiadiyigongyelu, 11hao304shi, dongguan, guangdong, 523710, CN
Email: support@wancle.net
Website: www.wancle.net
EU Representative
GAVIMOSA CONSULTORIA, SOCIEDAD LIMITADA
CASTELLANA 9144, 28046 Madrid, Spain
UK Representative
APRIL WELL LIMITED
Unit 39c St Olavs Court Business Center
Lower Road, London, England, SE16 2XB
aprilwell18@outlook.com