FMS YK4082 V3

Contents

Yikong YK4082 V3 1/8 Scale RC Climbing Vehicle User Manual

Model: YK4082 V3 | Brand: FMS

1. Introduction

This manual provides essential information for the safe and efficient operation of your Yikong YK4082 V3 1/8 Scale RC Climbing Vehicle. Please read this manual thoroughly before use and retain it for future reference.

The YK4082 V3 is a 1:8 scale high-simulation RC remote control climbing car designed for off-road enthusiasts. It features a new gearbox and rear axle reverse transmission system for enhanced performance and durability. The vehicle is equipped with a robust frame, a detailed shell, and a lighting system.

Disclaimer: ⚠️ Not suitable for children under 36 months. Recommended age: 14+ years.

Yikong YK4082 V3 1/8 Scale RC Climbing Vehicle in grey
Figure 1: Yikong YK4082 V3 1/8 Scale RC Climbing Vehicle (Grey)
Multiple Yikong YK4082 V3 RC Cars, highlighting 2024 V3 model with new gearbox
Figure 2: 2024 Yikong YK4082 V3 - 1:8 Scale Rock Crawler with New Gear Box Set

2. Package Contents

Upon unpacking, please verify that all components are present and undamaged. If any items are missing or damaged, please contact your retailer or the after-sales service department immediately.

  • Main RC Vehicle (YK4082 V3)
  • Remote Controller
  • Rechargeable Battery Pack (for some models, check product variant)
  • Charger (for some models, check product variant)
  • User Manual (this document)
  • Certificates
  • Sticker Sheet

The vehicle is shipped in its original box.

Sticker sheet included with the Yikong YK4082 V3 RC Car
Figure 3: Included Sticker Sheet

3. Setup and First Use

3.1. Battery Installation (Remote Controller)

  1. Open the battery compartment cover located on the back of the remote controller.
  2. Install three AA (No. 5) alkaline batteries, ensuring correct polarity (+/-) as marked inside the compartment. (Batteries are not included and must be purchased separately.)
  3. Securely close the battery compartment cover, ensuring the buckle is fully engaged to prevent accidental opening.
  4. Important: Do not mix different brands, models, or old and new batteries to prevent leakage, short circuits, or damage to the remote controller.
Detailed view of the remote control with labeled buttons and battery compartment
Figure 4: Remote Control Overview (Battery compartment on back)

3.2. Vehicle Power Supply (RC Car)

The YK4082 V3 supports rechargeable battery packs. Please refer to your specific product model for the included power supply method.

  1. Open the battery compartment of the RC car body.
  2. Insert the rechargeable battery pack, ensuring correct polarity.
  3. Close the battery compartment cover securely.
  4. To charge, connect the charger's output end to the car's charging interface. Connect the charger's input end to a standard 220V AC household power supply. The charger's indicator light will illuminate, indicating charging has begun.
  5. Charging typically takes 2-3 hours. The indicator light will change from red to green (on some models) when charging is complete. Disconnect the power supply and unplug the charger promptly to prevent overcharging and battery damage.
  6. Rechargeable battery packs are recyclable. If the car's speed significantly decreases or it fails to start, the battery needs recharging.

Note: The product is "Ready-to-Go" but batteries for the remote control are not included, and the car's battery may require initial charging.

Internal view of the YK4082 V3 chassis showing battery straps and wiring
Figure 5: Internal Wiring and Battery Compartment

3.3. Remote Control Pairing

  1. Turn on the power switches for both the remote controller and the RC car. The remote controller's indicator light will illuminate, and the RC car may emit a startup tone (on some models).
  2. Allow 3-5 seconds for the remote controller and RC car to automatically pair. Once paired, the car can be controlled.
  3. If pairing fails, turn off both devices, check battery levels, and attempt pairing again.

4. Operating Instructions

The remote controller features an intuitive design for easy operation. The YK4082 V3 supports 4 control channels.

4.1. Direction Control Keys

  • Forward Key: Press to move the car forward at a constant speed. Release to stop.
  • Back Key: Press to move the car backward at a constant speed. Release to stop.
  • Turn Left Key: Press to turn the car left. Can be combined with the Forward key for left-front driving. Release to return to straight driving.
  • Turn Right Key: Press to turn the car right. Can be combined with the Forward key for right-front driving. Release to return to straight driving.
  • Stop Button (some models): Press to immediately stop all actions and enter standby mode.

4.2. Function Keys (Some Models)

  • Acceleration Key: Press to switch to high-speed driving mode. Press again to return to normal speed.
  • Trick Key: Press to perform preset stunt actions (e.g., rotation, drift, overturning). The car will automatically return to normal driving after the stunt.
  • Lighting/Sound Effect Key: Press to toggle the car's lighting and sound effects on or off for an enhanced play experience.
Blue Yikong YK4082 V3 RC Car climbing over rocks
Figure 6: YK4082 V3 demonstrating climbing capabilities

5. Maintenance

Regular maintenance will ensure the longevity and optimal performance of your RC climbing vehicle.

  • Cleaning: After each use, especially in dusty or wet conditions, clean the vehicle to remove dirt and debris. Use a soft brush or cloth. Avoid using harsh chemicals or excessive water directly on electronic components.
  • Battery Care: Always disconnect the battery from the vehicle when not in use. Store batteries in a cool, dry place. Follow manufacturer guidelines for charging and discharging to maximize battery life. Dispose of old batteries responsibly according to local environmental regulations.
  • Inspection: Periodically inspect all moving parts, screws, and connections for looseness or damage. Tighten any loose screws and replace damaged parts as needed.
  • Lubrication: Apply appropriate RC-grade lubricant to moving parts like gears and bearings as recommended by advanced RC hobby practices to reduce wear and tear.
  • Storage: Store the vehicle in a dry, cool environment away from direct sunlight and extreme temperatures.

6. Troubleshooting

  • Vehicle Not Responding / Pairing Failure:
    • Ensure both the remote controller and the RC car are powered on.
    • Check if batteries in both devices are sufficiently charged. Replace or recharge if necessary.
    • Turn off both devices, then turn them back on and attempt the pairing process again.
  • Vehicle Running Slowly / Not Starting:
    • This indicates low battery power. Recharge the vehicle's battery pack immediately.
    • Check the batteries in the remote controller and replace if weak.
  • Intermittent Control / Short Range:
    • Ensure you are operating the vehicle within the effective control range (typically over 150 meters in open environments).
    • Avoid operating in areas with significant electromagnetic interference.
    • Check battery levels in both devices.

7. Specifications

FeatureSpecification
Model NumberYK4082 V3
Brand NameFMS / Yikong
TypeRC Car, Climbing Vehicle, Off-Road
Scale1:8
MaterialMetal, PVC (Environmentally-friendly ABS engineering plastic)
Control Channels4 channels
Remote ControlYes
State of AssemblyReady-to-Go
Dimensions (L*W*H)635mm * 290mm * 300mm
Wheelbase370mm
Ground Clearance95mm
Approach Angle65°
Departure Angle48°
Is Batteries IncludedNo (for remote control), Rechargeable pack for car (model dependent)
Is ElectricYes (Electric RC Car)
ESC880 80A waterproof brushed ESC (supports Ni-MH, 2-4S LiPo batteries, 3 driving modes: normal/race/climbing)
CertificationCE
Recommend Age14+y
Package Weight7.5 kg
Package Dimensions77cm (L) x 33cm (W) x 33cm (H)
Side view diagram of YK4082 V3 with detailed dimensions including length, wheelbase, height, ground clearance, and angles
Figure 7: Vehicle Dimensions and Angles
Internal chassis diagram showing motor, center of gravity, and battery box positions for optimized performance
Figure 8: Optimized Internal Component Placement (Motor forward 32mm, CoG down 13.8mm, Battery box forward 70.5mm)
Close-up of metal oil shock absorbers and 880 80A waterproof brushed ESC
Figure 9: Metal Oil Shock Absorbers and ESC
Comparison table of gear ratio parameters for previous and new versions of the YK4082 V3
Figure 10: Gear Ratio Comparison (Previous vs. New Version)
Diagram showing internal gearbox components and gear tooth counts
Figure 11: Gearbox Internal Components
Underside view of the YK4082 V3 chassis and drivetrain
Figure 12: Chassis and Drivetrain Underside View
Detailed view of the front suspension and steering linkage
Figure 13: Front Suspension and Steering Linkage
Detailed view of the rear axle and differential lock mechanism
Figure 14: Rear Axle and Differential Lock Mechanism
Visual representation of available color options for the YK4082 V3: Silver Blue, Sun Yellow, Dark Red, Reflex Blue
Figure 15: Available Color Options

8. User Tips

  • Battery Life: A 5200 mAh battery can provide approximately 40 minutes of stop-and-go play or about an hour of continuous play. Consider purchasing additional batteries for extended fun.
  • Charging Time: While ordinary chargers may take 6-7 hours, a fast charger (e.g., B6 charger) can fully charge the battery in 1-2 hours.
  • Remote Control Range: The remote control typically offers a range of over 150 meters in open areas. However, practical visibility limits effective control at such distances.
  • Advanced Features: The YK4082 V3 features a door bridge structure, high/low gear shifting, and front/rear differential locks, along with full vehicle linkage lights, offering a highly realistic and versatile driving experience.
  • Quality: Users have noted the high quality and robust build of the YK4082 V3, making it a worthwhile investment for RC enthusiasts.

9. Warranty and Support

For any missing or damaged parts, or for technical support, please contact your retailer or the manufacturer's after-sales service department.

An official user manual in PDF format is available for detailed instructions and diagrams. You can access it via this link: View User Manual (PDF).

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.