1. Introduction
The SCULPFUN Standard Limit Switch kit is designed to enhance the functionality of your SCULPFUN S9 or S10 laser engraving machine. By installing these limit switches, your engraver gains precise homing and positioning capabilities, which are essential for repeatable tasks and batch production. This manual provides detailed instructions for installation, operation, maintenance, and troubleshooting.
2. Package Contents
Please inspect the package contents upon arrival. If any items are missing or damaged, please contact your vendor.

Figure 2.1: Contents of the SCULPFUN Standard Limit Switch Kit.
- 2 x Limit Switches (with pre-attached brackets)
- 2 x Connection Cables
- 1 x Screw Pack (for mounting)
- 4 x Cable Management Clips
3. Specifications
| Feature | Detail |
|---|---|
| Brand Name | SCULPFUN |
| Compatibility | SCULPFUN S9/S10 Laser Engraving Machines, 45° V-slot aluminum beams |
| Package Size | 145 x 105 x 75 mm (5.7 x 4.1 x 2.9 in) |
| Package Weight | 150 g (5.2 oz) |
| Origin | Mainland China |
4. Setup
Follow these steps to install the limit switches on your SCULPFUN S9 or S10 laser engraver.
4.1. General Installation Overview
The limit switches are designed to be installed at the end of travel for both the X and Y axes. This allows the machine to detect its physical limits and establish a precise home position (0,0).

Figure 4.1: The limit switches are perfectly compatible with SCULPFUN S9 and S10 models.
4.2. Mounting the Limit Switches
- Identify Mounting Locations: For the X-axis, the switch typically mounts on the left or right side of the gantry. For the Y-axis, it mounts on the front or rear frame. Choose positions where the moving part (laser module for X, gantry for Y) will trigger the switch lever at the desired home position.
- Secure the Switch: Place the limit switch bracket onto the 45° V-slot aluminum beam. Use the provided screws to firmly attach the bracket to the frame. Ensure the switch lever is positioned so that it will be reliably pressed by the moving component when it reaches the end of its travel.

Figure 4.2: Close-up view of a limit switch correctly mounted on the engraver's frame.

Figure 4.3: Limit switch installed on the X-axis rail.

Figure 4.4: Limit switch installed on the Y-axis rail.
4.3. Wiring the Limit Switches
- Connect Cables to Switches: Take one of the provided connection cables and plug one end into the connector on the limit switch module.
- Connect to Control Board: Carefully route the other end of the cable to your laser engraver's control board. Connect it to the corresponding limit switch input. Typically, these ports are labeled X-MIN, X-MAX, Y-MIN, or Y-MAX. Refer to your SCULPFUN S9/S10 engraver's main user manual for the exact location of these ports.

Figure 4.5: Limit switch with its connection cable attached.
4.4. Cable Management
Use the provided cable management clips to secure the cables along the engraver's frame. This prevents the cables from snagging on moving parts or interfering with the engraving process.
5. Operating Instructions
Once the limit switches are installed and wired, your laser engraver can utilize their functionality.
5.1. Homing Function
After installation, your laser engraver's control software (e.g., LightBurn, LaserGRBL) should now recognize the limit switches. When you initiate a