Loefme HZB-12/K

Contents

Loefme Electric Ice Maker User Manual

Model: HZB-12/K

Loefme Electric Ice Maker, front view with ice cubes and features listed

Loefme Electric Ice Maker, front view, highlighting its quick ice release, 1.4L capacity, 110 ice cubes, 6-minute ice production, automatic cleaning, and a convenient carrying handle.

Important Safety Instructions

Your safety and the safety of others are very important. Always read and obey all safety messages.

When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire, electric shock, and injury to persons or property. Read all instructions before using any appliance.

  • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
  • Do not operate this, or any other appliance with a damaged cord. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
  • This ice maker must be positioned so that the plug is accessible. Connect to properly polarized outlets only. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the receptacle.
  • Do not run the power cord over carpeting or other heat insulators. Do not cover the cord. Keep cord away from traffic areas, and do not submerge in water.
  • We do not recommend the use of an extension cord, as it may overheat and become a risk of fire. If you must use an extension cord, use No. 0.75mm² minimum size and rated no less than 16A/250V~ with a plug.
  • Unplug the ice maker before cleaning or making any repairs or servicing.
  • Exercise caution and use reasonable supervision when appliance is used near children.
  • Do not use your ice maker outdoors. Place the ice maker away from direct sunlight and make sure that there is at least 10cm of space between the back of your unit and wall. Keep a minimum distance of 10cm on each side of your unit free.
  • Do not use other liquid to make the ice cube other than water.
  • Do not clean your ice maker with flammable fluids. The fumes can create a fire hazard or explosion.
  • Do not tip over.
  • If the ice maker is brought in from outside in wintertime, give it a few hours to warm up to room temperature before plugging.
  • This appliance is intended to be used in household and similar applications such as staff kitchen areas in shops, offices and other working environments; farm houses and by clients in hotels, motels and other residential type environments; bed and breakfast type environments; catering and similar non-retail applications.
  • Warning: Risk of fire/flammable materials used. Please dispose of the appliance according to local regulations for its flammable blowing gas.
  • Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
  • Do not damage the refrigerant circuit.
  • Do not use mechanical devices or other means to accelerate the defrosting process or ice harvesting process, other than those recommended by the manufacturer.
  • Do not use other type of electrical appliances.

Getting to Know Your Unit

Familiarize yourself with the components and control panel of your Loefme Ice Maker.

Components Overview

The ice maker consists of several key parts:

  1. Ice shovel
  2. Ice full sensor
  3. Ice basket
  4. Top cover with transparent window
  5. Air exhausting
  6. Water drain cap: located at the front bottom side of the unit.
  7. MAXIMUM WATER LEVEL: Remove the ice basket to see the water level mark.
  8. Handle

Control Panel & Functions

Control panel of the ice maker with buttons and indicators: Add Water, Ice Full, Power, ON/OFF, Select (S/L)

Figure 1: Control Panel layout with indicators for Add Water, Ice Full, Power, and buttons for ON/OFF and ice size selection (S/L).

The control panel features an easy-to-use touch display with visible functions:

  • ADD WATER Indicator: Lights up when water level is low.
  • ICE FULL Indicator: Lights up when the ice basket is full.
  • POWER Indicator: Indicates the unit is powered on.
  • ON/OFF Button: Press to turn the unit on or off.
  • SELECT Button (S/L): Press to choose between Small (S) or Large (L) ice cube size.

Setup Guide

Follow these steps to set up your ice maker for first use.

1. Unpacking Your Ice Maker

  1. Remove all exterior and interior packaging materials. Check for the ice basket and ice scoop inside. If any parts are missing, please contact customer service.
  2. Remove any tapes used to fix the ice shovel, ice basket, and ice scoop. Clean the water tank and ice basket thoroughly.
  3. Place the ice maker on a level and flat countertop, away from direct sunlight and other heat sources (e.g., stove, furnace, radiator). Ensure there is at least 10cm (4 inches) of space between the back and both sides of the unit and the wall.
  4. Allow the refrigerant fluid to settle for at least one hour before plugging in the ice maker. This helps improve the lifespan of the compressor.
  5. Ensure the appliance is positioned so that the power plug is easily accessible.

2. Assemble Handle

Rotate the handle to align with the mounting hole on the machine, then firmly attach it to the unit. The square hole on the back top panel is designed to prevent the ice scoop from falling.

3. Connecting Your Ice Maker

DANGER: Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, please call customer service.

  • This unit must be properly grounded for your safety. The power cord is equipped with a three-prong plug that mates with standard three-prong wall outlets to minimize the possibility of electric shock.
  • Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician.
  • This appliance requires a standard 220-240V, 50Hz electrical outlet with three-prong ground.

Operating Instructions

Watch this video for a visual guide on setting up and operating your ice maker, including the self-cleaning function.

Video: Demonstrates initial setup, automatic cleaning, ice making process, and ice usage.

Using Your Ice Maker

  1. Open the cover, remove the ice basket, and pour potable water into the tank. Ensure the water level is below the MAX water level mark.
  2. Press the "ON/OFF" button on the control panel to begin the ice making cycle.
  3. Select the desired ice cube size (Small "S" or Large "L") by pressing the "SELECT" button. If the room temperature is below 16°C (60°F), it is recommended to select small ice cubes to prevent them from sticking together.
  4. The ice making cycle takes approximately 6 to 13 minutes, depending on the selected ice cube size and room temperature. The recommended room temperature is 10°C to 38°C.
  5. If the water pump cannot inject water, the ice maker will stop automatically, and the "ADD WATER" indicator will light up. To resume, fill water up to the MAX water level mark and press the "ON/OFF" button twice. Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before restarting.
  6. The ice maker stops when the ice basket is full, and the "ICE FULL" indicator will light up. Remove ice cubes to resume ice making.

Warning: Direct sunlight or strong sunlight reflection may cause the infrared sensor to malfunction. If the unit does not stop even when ice cubes obstruct the sensor, move the unit to a location without direct sunlight.

Image showing ice maker producing 9 bullet ice cubes in 6 minutes

Figure 2: Visual representation of the ice making process, showing 9 bullet ice cubes being produced in 6 minutes.

Care and Maintenance

Automatic Self-Cleaning Program

The ice maker features an automatic self-cleaning function to simplify maintenance.

  1. Ensure the unit is plugged in.
  2. Press and hold the "ON/OFF" button on the control panel for more than 5 seconds to activate the self-cleaning program.
  3. The cleaning cycle takes approximately 30 minutes. During this time, the "S" and "L" indicators will flash alternately.
  4. After cleaning, drain the water from the inner tank through the drainage outlet at the bottom of the machine.
Diagram showing steps for automatic self-cleaning: Add water, Press ON/OFF for 5s, and internal cleaning process

Figure 3: Steps for activating and completing the automatic self-cleaning function.

General Cleaning and Maintenance

It is strongly recommended to clean your ice maker thoroughly before first use and regularly thereafter.

  1. Take out the ice basket.
  2. Clean the interior with diluted detergent, warm water, and a soft cloth.
  3. Rinse the inside parts with water and drain the water by unplugging the drain cap on the front bottom side.
  4. The exterior of the ice maker should be cleaned regularly with a mild detergent solution and warm water.
  5. Dry the interior and exterior with a clean, soft cloth.
  6. For easier cleaning, the entire top panel can be opened up, cleaned, and then reinstalled.
  7. If the machine is not to be used for a long time, drain all water completely and dry the interior.
  8. Change the water in the water reservoir every 24 hours to ensure reasonable hygiene.

Troubleshooting Guide

Refer to the table below for common issues and their solutions.

ProblemPossible CauseSolution
"ADD WATER" indicator is on.Lack of Water.Stop the ice maker, fill water, and press "ON/OFF" button again to restart the unit.
"ICE FULL" indicator is on.Ice is full in basket.Remove ice from ice basket. Continuous press "Select" button for 5 seconds; the unit can make 10 cycles even if the "Ice" indicator is on.
Ice cubes stick together.The ice making cycle is too long.Stop the ice maker, and restart it when the ice blocks melt. Select the small size ice cube selection.
Ice making cycle is normal but no ice formed.Water temperature in inner tank is too low.Replace the water. Temperature of water recommended at 8-32°C.
Room temperature or water temperature in inner tank is too high.The room temperature should be 10-38°C, water temperature should be 8-32°C.
Refrigerant in cooling system leaks.Verify by a qualified technician.
Pipe in the cooling system is blocked.Verify by a qualified technician.

Product Specifications

Product dimensions: 29.40cm width, 22.20cm depth, 29cm height

Figure 4: Product dimensions, showing width (29.40cm), depth (22.20cm), and height (29cm).

AttributeValue
ModelHZB-12/K
Power220-240V~ / 50Hz
Protection TypeI
Climate TypeSN/N/ST/T
Ice Making Current0.8A
Ice Harvest Current1.0A
RefrigerantR600a/15g
Net Weight6.4Kg
VesicantC5H10
Dimensions (W*D*H)222x290x294mm
Ice Production Capacity12kg/24h
Ice Storage Capacity0.6kg (70-110 ice cubes)
Ice Dispense Time6-8 minutes / 9 pieces
Bullet Ice Cube DimensionsS: 20x25mm, L: 25x30mm
Water Capacity1.4L

User Tips

Based on user experiences, here are some helpful tips for using your ice maker:

  • The first batch of ice may not be perfectly formed or of the desired size; subsequent batches typically improve in quality.
  • Ice cubes produced by this machine are generally smaller and may be slightly moist compared to ice from a traditional freezer. They might melt faster, so plan accordingly.
  • If you need a large quantity of ice, consider making a reserve by transferring produced ice to a freezer bag and storing it in your freezer.
  • While designed for low noise, the machine does produce some operational sound.

Warranty and Support

This product is manufactured by Ningbo Hicon Industry Technology Co., Ltd.

Manufacturer: Ningbo Hicon Industry Technology Co., Ltd.
Manufacturer Address: No.55, 4th Binhai Road, Qianwan New Area, Ningbo, Zhejiang Province, P. R. China
Phone: +86 13048907387
E-mail: support@loefme.com

The product is certified with CE, RoHS, and WEEE standards, ensuring compliance with European safety and environmental regulations.

For specific warranty details, please refer to your purchase documentation or contact the seller/manufacturer directly.

A Declaration of Conformity (DoC) is available, stating compliance with EMC directive 2014/30/EU, LVD directive 2014/35/EU, and RoHS Directive-2011/65/EU (as amended by (EU)2015/863).

You can view the full Declaration of Conformity in the provided PDF manual (page 9).

For technical support or service inquiries, please contact the manufacturer using the details above.

Included Accessories

The following items are included with your Loefme Electric Ice Maker:

  • 1 x Ice Maker Unit
  • 1 x Instruction Manual (this document)
  • 1 x Power Cord
  • 1 x Ice Scoop
  • 1 x Handle
  • 1 x Ice Basket
Loefme Ice Maker with included accessories: ice basket and ice scoop

Figure 5: Loefme Ice Maker with its included ice basket and scoop.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.