1. Introduction
Thank you for choosing the LiitoKala 3.2V 25Ah LiFePO4 Battery Cell. This high-performance rechargeable lithium iron phosphate battery is designed for durability and reliability, offering a long cycle life and stable power output. It is suitable for a wide range of applications including solar energy storage, electric vehicles, marine applications, and other power systems.
This manual provides essential information on the safe handling, operation, maintenance, and specifications of your battery cell. Please read it thoroughly before use to ensure optimal performance and safety.
2. Safety Information
WARNING: Failure to follow these safety instructions may result in fire, serious injury, or property damage.
2.1 General Safety Precautions
- KEEP OUT OF REACH OF CHILDREN. In case of ingestion, seek medical attention immediately.
- Do not immerse the battery in water or allow it to get wet.
- Do not use or store the battery near sources of heat such as a fire or heater.
- Use only chargers specified for LiFePO4 batteries. Incorrect charging methods or equipment can damage the battery and cause fire or other problems.
- Do not reverse the positive (+) and negative (-) terminals.
- Do not connect the battery directly to wall outlets or car cigarette-lighter sockets.
- Do not put the battery into a fire or apply direct heat to it.
- Do not short-circuit the battery by connecting wires or other metal objects to the positive (+) and negative (-) terminals.
- Do not carry or put the battery together with necklaces, hairpins, or other metal objects.
- Do not strike, throw, or subject the battery to severe impact.
- Do not place the battery in a microwave oven or pressurized container.
- Do not use the battery in combination with primary batteries (such as dry-cell batteries) or batteries of different capacity, type, or brand.
- If the battery emits odor, heat, deformation, discoloration, or any other abnormal phenomenon, immediately remove it from the appliance or charger and discontinue use.
- Do not pierce the battery casing with a nail or other sharp object, break it open with a hammer, or step on it.
- Do not directly solder the battery terminals.
- Do not attempt to disassemble or modify the battery in any way.
2.2 Handling Leaking or Damaged Batteries
- If the battery leaks and electrolyte gets in your eyes, do not rub them. Instead, rinse them immediately with clean running water and seek medical attention. If left untreated, electrolyte can cause eye injury.
- If the battery leaks and electrolyte gets on your skin or clothing, immediately rinse the affected area with clean running water. If left untreated, skin inflammation can occur.
- If the battery leaks or emits an odor, immediately remove it from the proximity of any exposed flame. The leaking electrolyte can ignite and cause a fire or explosion.
2.3 Safety Valve
The battery is equipped with a safety valve designed to open and relieve pressure if the internal temperature exceeds 200 °C, reducing user safety risks.

3. Specifications
Below are the detailed specifications for the LiitoKala 3.2V 25Ah LiFePO4 Battery Cell:
| Parameter | Value |
|---|---|
| Brand | LiitoKala |
| Battery Type | Lithium Iron Phosphate (LiFePO4) |
| Model Number | 46135-3.2V25Ah |
| Nominal Voltage | 3.2V |
| Rated Capacity | 25Ah |
| Minimum Capacity | 25Ah |
| Internal Resistance | ≤ 1.5mΩ |
| Suggested Constant Current | 12.5A (0.5C) |
| Discharge Cut-Off Voltage | 2.5V |
| Maximum Charging Voltage | 3.65V |
| Maximum Continuous Discharge Current | 75A (3C) |
| Constant Charge Current | 25A (1C) |
| Charging Method | CC / CV (Constant Current / Constant Voltage) |
| Cycle Life | ≥ 4000 times (80% DOD) |
| Charging Temperature | 0°C to 60°C |
| Discharge Temperature | -20°C to 60°C |
| Dimensions (Diameter x Length) | 46.3 ± 0.3mm x 136.3 ± 0.3mm (+30mm for terminals) |
| Battery Weight | 0.5 ± 0.1 kg |
| Screws Type | M6 |


4. Setup and Installation
This battery cell is designed for integration into various power systems. Proper installation is crucial for safety and performance.
4.1 Connecting the Battery Cell
- Observe Polarity: Always connect the positive (+) terminal of the battery to the positive terminal of your system and the negative (-) terminal to the negative terminal. Incorrect polarity can cause damage to the battery and connected equipment.
- Secure Connections: Ensure all connections are tight and secure to prevent loose contacts, which can lead to overheating or power loss.
- Included Accessories: DIY battery connectors, washers, and nuts are provided to facilitate secure connections.


4.2 System Integration
For specific installation instructions regarding your particular application (e.g., solar light, electric tricycle, motor home, electric boat, wind power), please refer to the instruction manual of the equipment in which this battery cell will be used.

5. Operation
5.1 Charging
- Standard Charge Procedure: Charge the battery at a constant current rate of 0.5C (12.5A) until the battery voltage reaches 3.65V. Then, switch to constant voltage charging at 3.65V, continuing until the charge current tapers to ≤0.05C (1.25A).
- Charging Temperature: Ensure charging is performed within the temperature range of 0°C to 60°C.
- Charger Compatibility: Always use a charger specifically designed for LiFePO4 batteries with the correct voltage and current ratings.
5.2 Discharging
- Discharge Cut-Off Voltage: Do not discharge the battery below 2.5V. Discharging below this voltage can damage the cell and reduce its lifespan.
- Maximum Discharge Current: The maximum continuous discharge current is 75A (3C). Avoid exceeding this limit.
- Discharge Temperature: Ensure discharging is performed within the temperature range of -20°C to 60°C.
5.3 Cycle Life
The LiitoKala LiFePO4 battery cell is designed for a long operational life, with a cycle life of ≥4000 times at 80% Depth of Discharge (DOD).

6. Maintenance
6.1 Storage
- Short-Term Storage: For short periods, store the battery at approximately 30% State of Charge (SOC).
- Long-Term Storage: For extended storage (more than one month), store the battery at a temperature between -20°C and 45°C. It is recommended to recharge the battery to 40-50% capacity every three months to prevent over-discharge and maintain cell health.
- Storage Environment: Store batteries in a cool, dry place away from direct sunlight, heat sources, and flammable materials.
6.2 Cleaning
If the battery terminals become dirty, wipe them clean with a dry cloth before use. Clean terminals ensure good electrical contact, preventing power loss and charging failures.
7. Troubleshooting
- Battery Not Charging or Powering Device: Check all connections for tightness and ensure terminals are clean. Verify the charger is compatible and functioning correctly.
- Battery Shows Signs of Damage (Leakage, Swelling, Overheating): Immediately discontinue use. Isolate the battery in a safe, non-flammable container and dispose of it according to local regulations for hazardous waste. Do not attempt to use or repair a damaged battery.
- Charger Stops During Pre-Charging: If your charger has a pre-charging phase and stops because the cell voltage does not rise above 2V within the specified time, the battery cell may be abnormal or deeply discharged. Consult your system's manual or a qualified technician.
8. Warranty and Support
8.1 Warranty Period
This LiitoKala battery cell comes with a warranty period of one year from the manufacturing date. The warranty covers defects proven to be due to manufacturing processes, not customer abuse or misuse.
8.2 Support
For any questions, technical assistance, or warranty claims, please contact LiitoKala Power Co., LTD. or your authorized dealer. When contacting support, please have your model number and purchase information ready.
For further detailed technical specifications and guidelines, you may refer to the official product specification document: LiitoKala 3.2V25Ah-46135 Product Specification (PDF).