1. Introduction
This manual provides detailed instructions for the BENINCA TO.GO 2VA garage door remote control. It covers product specifications, compatibility, programming procedures, and general maintenance to ensure optimal performance and longevity of your device.
2. Specifications
| Feature | Detail |
|---|---|
| Model Number | TO.GO 2VA |
| Encoding Method | Rolling code |
| Frequency | 433.92 MHz (433MHz) |
| Code Type | Rolling code (ARC 128bit) |
| Buttons | 2 |
| Battery | Included |
| Origin | Mainland China |
| Certification | CE |
3. Package Contents
Your package should contain the following items:
- Remote Control (BENINCA TO.GO 2VA)
- Battery (pre-installed or included separately)
- Keychain
- English Manual
4. Compatibility
This remote control is compatible with the following BENINCA rolling code remotes:
- BENINCA TO GO 2VA 4VA
- BENINCA TO GO 2WV
- BENINCA TO GO 4WV
- BENINCA IO.2WV
- BENINCA LO.T2WMR
- BENINCA T2 WV
- BENINCA T4 WV
- BENINCA CUPIDO-2
- BENINCA CUPIDO-4 (all colors)
Important Note:
- Access to your receiver/opener is required for programming. Please ensure you have access before attempting to program the remote.
- Your existing remote control must be identical to the product image, and your model must be listed above for compatibility.
5. Setup and Programming
To program your new BENINCA TO.GO 2VA remote control, follow these steps:
- Locate the Receiver: Open the casing of your garage door receiver. It is typically located next to your motor unit.
- Activate Programming Mode: On the receiver circuit board, press the programming button (often labeled 'PGM'). The LED light on the receiver will illuminate. Release the button.
- Program the Remote: Within the next 10 seconds, press one of the buttons on your new remote control. Release the button.
- Confirmation: Wait for 10 seconds. Your new remote control should now be programmed and ready for use.
6. Operating Instructions
Once programmed, operating your BENINCA TO.GO 2VA remote control is straightforward:
- Press the desired button on the remote control to activate your garage door opener.
- The LED indicator on the remote will light up during transmission.
- Ensure you are within range of your garage door receiver for the signal to be received.
Video 1: Unboxing and basic demonstration of the BENINCA TO.GO 2VA remote control.
7. Maintenance
7.1 Battery Replacement
The remote control comes with a battery included. If the remote's range decreases significantly or the LED indicator does not light up when a button is pressed, the battery may need to be replaced. Refer to the remote's casing for instructions on how to open it and replace the battery. Ensure you use the correct battery type as specified by the manufacturer.
7.2 Cleaning
Clean the remote control with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these can damage the casing or internal components.
8. Troubleshooting
- Remote not working after programming: Double-check that you followed all programming steps correctly. Ensure you have access to the receiver and that your remote model is compatible.
- Reduced range: Replace the battery. Ensure there are no obstructions between the remote and the receiver.
- LED not lighting up: Replace the battery. If the issue persists, the remote may be faulty.
- Interference: Other wireless devices operating on similar frequencies might cause interference. Try to identify and minimize such sources.
9. User Tips
- Always test the remote's functionality from various distances and angles after programming to ensure reliable operation.
- Keep the remote control in a safe place to prevent accidental button presses or damage.
- Consider having a spare remote or an alternative access method (e.g., keypad) for convenience.
10. Warranty and Support
For warranty information or technical support, please refer to the documentation provided by your seller or contact the manufacturer directly. Keep your purchase receipt as proof of purchase for any warranty claims.
