1. Important Safety Information
Before using the iScooter W6, please read this manual carefully and keep it for future reference. Failure to follow instructions may result in injury or damage.
- **Fire Risk:** Please mind potential fire risk and strictly follow the instruction manual for charging and storage.
- **Protective Equipment:** Always wear appropriate protective equipment (e.g., helmet, knee pads, elbow pads) while operating the scooter.
- **Legal Compliance:** Fully comply with all applicable local laws and regulations regarding electric scooter use.
- **Charging Safety:** During charging, the scooter cannot be turned on. Keep the charging port cover closed when not charging.
- **Children's Safety:** This appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure they do not play with the appliance.
2. Product Overview
The iScooter W6 is a 10-inch electric scooter featuring a 500W motor, 36V 10.5Ah battery, and a range of 25-30km. It includes inflatable tires, a rear disc brake, and app connectivity.

Components List
- Bell
- Brake Lever
- Folding Buckle
- Headlight
- Display
- Throttle
- Hanger
- Stem
- Folding Knob
- Kickstand
- Charging Port
- Hook
- Rear Fender
- Taillight & Brake Light
- Disc Brake
3. Setup and Assembly
3.1 Unfolding the Scooter
- Press the folding buckle to release it from the hook.
- Lift the stem to the riding position.
- Fully tighten the folding knob.

3.2 Handlebar Assembly
- Raise the stem to the riding position and fully tighten the folding knob.
- Install the handlebar assembly onto the stem.
- Pre-tighten all four bolts.
- Fully tighten the bolts using the supplied hex wrench.
4. Operating Instructions
4.1 Power Button Functions
The power button is located on the display unit.
- Power ON/OFF: Press and hold the Power button to turn the scooter on/off.
- Headlight & Taillight ON/OFF: With the scooter powered on, press the Power button once to turn the headlight & taillight on/off.
- Switching Riding Mode: With the scooter powered on, double-press the Power button to cycle through the riding modes.
- Switching Speed Unit: With the scooter powered on, press the Power button three times to switch between km/h and mph.
- Zero Start and Non-zero Start: With the scooter powered on, press the Power button four times to switch between zero start and non-zero start.
- Cruise Control ON/OFF: With the scooter powered on, press the Power button five times to enable or disable cruise control.
Note: The scooter will automatically shut down if there is no operation for 10 minutes.
4.2 Speed Modes
The scooter offers multiple speed modes. The default modes are 6 km/h, 15 km/h, and 25 km/h. Higher speeds can be unlocked.

Unlocking Higher Speeds:
- After turning on the device, hold the brake handle.
- Press the power button 5 times to break the speed limit.
Switching Modes:
Simply short-press the switch for different times at startup to switch modes, allowing you to easily cope with different riding environments.
4.3 Smart LCD Display
The LCD display provides real-time information about your ride.

4.4 Braking System
The W6 is equipped with a stable dual brake system for quick and efficient stopping.
- Rear Brake: Mechanical disc brake.
- Front Brake: Hidden electronic brake.

4.5 Lighting System
For enhanced safety, especially during low-light conditions:
- Front LED Headlight: Provides illumination for night riding.
- Rear Warning Light: Activates during braking to alert others.

4.6 Voltix App Connectivity
The scooter supports the Voltix App for enhanced control and convenience. You can download the app from the App Store (iOS) or Google Play Store (Android) by searching for "Voltix" or scanning the QR code provided in the manual.


5. Charging
To charge your iScooter W6:
- Ensure the scooter is turned off.
- Open the charging port cover.
- Connect the charger to the charging port.
- Plug the charger into a power outlet.
The scooter is fully charged when the charger indicator changes from red to green. While the scooter has charging protection to prevent overcharging, it is not recommended to leave it plugged in for extended periods after a full charge.

6. Maintenance
6.1 General Care
- Regularly clean the scooter with a damp cloth. Do not use harsh chemicals or abrasive materials.
- Keep the charging port cover closed when not charging to prevent dust and moisture ingress.
6.2 Tire Maintenance
The W6 features 10-inch wear-resistant pneumatic tires with inner and outer layers, including anti-puncture protection.

- Check tire pressure regularly to ensure optimal performance and safety.
- Inspect tires for wear and tear or damage before each ride.
6.3 Battery Care
- Avoid completely draining the battery.
- Charge the battery regularly, even if the scooter is not in use for extended periods, to maintain battery health.
- Store the scooter in a cool, dry place away from direct sunlight and extreme temperatures.
7. Troubleshooting
If you encounter any issues with your iScooter W6, refer to the table below for common error codes. If the problem persists or you encounter other error codes, please contact customer support.
| Code | Definition |
|---|---|
| E10 | Communication Fault |
| E14 | Throttle Fault |
| E15 | Brake Lever Fault |
| E16 | Motor Hall Sensor Fault |
| E50 | Over-voltage |
8. Specifications

| Feature | Specification |
|---|---|
| Model Number | W6 |
| Tire Size | 10 inch (Inner & Outer Tire) |
| Motor Power | 500W |
| Voltage | 36V |
| Battery Capacity | 10.5Ah |
| Range Per Charge | 25-30km (15-18 miles) |
| Max Speed | 35km/h (Unlocked Modes) |
| Charging Time | 5-6 hours |
| Max Load Capacity | 264 lbs (120 kg) |
| Unfolded Size | 112 x 49 x 111 cm (44.1 x 19.3 x 43.7 in) |
| Folded Size | 112 x 49 x 47 cm (44.1 x 19.3 x 18.5 in) |
| Net Weight | 15 kg (33 lbs) |
| Rear Brake | Disc Brake + Hidden Electronic Brake |
| Suspension | Rear Shock Absorber |
| Waterproof Rating | IPX4 |
| Certification | CE |
| With App | Yes |
*Note on Range: Measured under conditions of 100% battery, 70kg load, and 15km/h speed. Actual range may vary based on load, humidity, wind speed, and riding habits.
*Note on Max Load: For the best riding experience, 70% of the maximum load is recommended.
9. User Tips
- **Speed Unlock:** To access the full speed potential of 35km/h, remember to hold the brake and press the power button 5 times after turning on the scooter.
- **Wet Weather:** The scooter has an IPX4 waterproof rating, meaning it can withstand splashes from any direction. However, it is not recommended to ride in heavy rain or submerge the scooter. Always wipe it dry after exposure to moisture.
- **Portability:** The quick-folding design makes it easy to carry and store, fitting into car trunks or for carrying up stairs.
- **Visibility:** Utilize the front LED headlight and rear warning light for increased visibility, especially when riding at night or in low-light conditions.
10. Warranty and Support
For detailed warranty information and support, please refer to the official user manual PDF available at: User manual (PDF).
You can also contact the manufacturer directly for support:
- Manufacturer: Dongguan Yicheng Shengda Information Technology Co., Ltd.
- Email: support@e-scootworld.com
For EU customers, the authorized representative is:
- EC REP: GAVIMOSA CONSULTORIA, SOCIEDAD LIMITADA
- Address: CASTELLANA 9144, 28046 Madrid
- Email: compliance.gavimosa@outlook.com
- Contact: Jorge Wilson
- Tel: +34 688185858