Introduction
Thank you for choosing the SANDA 6258 Digital Watch. This electronic watch is designed for versatility and durability, featuring a clear digital display, multiple functions, and 5ATM water resistance. This manual will guide you through the setup, operation, and maintenance of your new timepiece.
Figure 1: SANDA 6258 Digital Watch (Orange variant)
Setup
Your SANDA 6258 watch comes with a pre-installed battery. Follow these steps for initial setup:
- Initial Power On: The watch should display the time upon arrival. If the screen is blank, ensure the battery is properly seated (though it comes pre-installed).
- Time Setting:
- Locate the 'Set' button (typically on the right side of the watch).
- Press and hold the 'Set' button until the time display starts flashing, indicating adjustment mode.
- Use the 'Mode' button to cycle through hours, minutes, date, and other settings.
- Use the 'Night Light' button (or another designated button, refer to 'Function Analysis' image) to adjust the flashing value up or down.
- Once all settings are correct, press the 'Set' button again to exit adjustment mode.
- 12/24-Hour Format: In time setting mode, you can usually toggle between 12-hour and 24-hour formats using one of the adjustment buttons.
Figure 2: Function Analysis - Button Layout
Operating Instructions
The SANDA 6258 watch offers several features accessible via its buttons. Refer to Figure 2 for button identification.
- Night Light: Press the 'Night Light' button (top left) to activate the luminous display. This provides a soft, non-glaring blue backlight for clear viewing in low light conditions.
- Mode Selection: Press the 'Mode' button (bottom left) to cycle through different functions:
- Normal Time Display (shows time, date, week)
- Stopwatch Timing
- Countdown Timer
- Alarm Clock
- Dual Time Zone
- Stopwatch:
- From Normal Time, press 'Mode' until 'ST' or 'Stopwatch' mode is displayed.
- Press the 'Set' button to start/stop the stopwatch.
- Press the 'Night Light' button to reset the stopwatch.
- Countdown Timer:
- From Normal Time, press 'Mode' until 'CD' or 'Countdown' mode is displayed.
- Press and hold 'Set' to enter setting mode. Adjust hours, minutes, and seconds using 'Mode' to select and 'Night Light' to change values.
- Press 'Set' to confirm settings.
- Press 'Set' again to start/pause the countdown.
- Press 'Night Light' to reset.
- Alarm Clock:
- From Normal Time, press 'Mode' until 'AL' or 'Alarm' mode is displayed.
- Press and hold 'Set' to enter setting mode. Adjust alarm time using 'Mode' to select and 'Night Light' to change values.
- Press 'Set' to confirm settings.
- Press 'Night Light' to toggle the alarm ON/OFF. An alarm icon will appear when active.
- Hourly Chime: This feature can usually be activated or deactivated in the alarm setting mode. Look for an icon resembling a bell or speaker.
- Dual Time Zone:
- From Normal Time, press 'Mode' until 'DT' or 'Dual Time' mode is displayed.
- Press and hold 'Set' to enter setting mode. Adjust the second time zone using 'Mode' to select and 'Night Light' to change values.
- Press 'Set' to confirm settings.
Figure 3: Luminous Display (Backlight)
Figure 4: Overview of Watch Functions
Video 1: Demonstration of the SANDA 6258 watch features and backlight.
Maintenance
- Water Resistance (5ATM/50m): The watch is resistant to splashes, rain, and brief immersion in water (e.g., showering, swimming in shallow water). Do NOT press any buttons while the watch is submerged, as this can compromise the water seal. Not suitable for diving or hot water activities.
- Cleaning: Clean the watch case and strap with a soft, damp cloth. Avoid using harsh chemicals or abrasive materials.
- Battery Replacement: The watch uses an imported original battery (75-80mAh). When the display dims or functions become erratic, it may be time for a battery replacement. It is recommended to have this done by a professional to ensure the water resistance seal is maintained.
- Storage: Store the watch in a cool, dry place away from direct sunlight and extreme temperatures.
- Impact: While the watch features an ABS case and is designed to be shock-resistant, avoid severe impacts to prevent damage to the internal electronic movement or acrylic mirror.
Figure 5: 5 ATM Water Resistance
Figure 6: Detail Display of Watch Materials
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Display is blank or dim. | Low battery. | Replace the battery. |
| Time is incorrect. | Time not set properly or accidentally reset. | Refer to the 'Setup' section to reset the time. |
| Water inside the watch. | Buttons pressed underwater or exceeding 5ATM limit. | Immediately take the watch to a professional for inspection and repair to prevent further damage. |
| Buttons are unresponsive. | Watch may be in a locked mode or internal issue. | Try a soft reset (if applicable, by holding all buttons for a few seconds) or battery removal/reinsertion. If problem persists, seek professional service. |
Specifications
| Feature | Detail |
|---|---|
| Brand | SANDA |
| Model Number | 6258 |
| Display Type | Digital (Number) |
| Movement Type | Electronic Movement |
| Case Material | ABS Resin |
| Strap Material | Silicone |
| Mirror Material | Acrylic (Hardlex) |
| Case Shape | Tonneau (Barrel Shaped) |
| Case Thickness | 17mm |
| Dial Diameter | 50mm |
| Band Width | 26mm |
| Band Length | 26.5cm |
| Clasp Type | Buckle |
| Water Resistance Depth | 5Bar (50m) |
| Battery Included | Yes (75-80mAh) |
| Features | Back Light, Shock Resistant, LED Display, Repeater, Chronograph, Complete Calendar, DIVER, Alarm, Dual Time, Countdown, Hourly Chime, 12/24-hour format, Date, Week |
| Certification | CE |
Figure 7: Product Information and Dimensions
User Tips
- For optimal visibility, use the night light feature in dimly lit environments.
- Ensure the watch is securely fastened but not overly tight for comfort and to prevent skin irritation.
- Regularly check the time and date settings, especially after battery changes or if the watch has been stored for a long period.
Warranty and Support
Your SANDA 6258 Digital Watch comes with a store warranty. For any issues or inquiries, please contact the seller or authorized service center. Keep your purchase receipt as proof of purchase.
For technical support or service, please refer to the contact information provided by your retailer or the official SANDA website.
