Introduction
This manual provides instructions for the installation and care of your new replacement Volume Knob and Channel Selector Knob set. These knobs are designed to restore the functionality and appearance of your compatible two-way radio. Please read these instructions carefully before proceeding with installation.
Specifications
| Attribute | Detail |
|---|---|
| Accessory Type | Radio Accessory |
| Battery Included | No |
| High-concerned chemical | None |
| Certification | CE |
| Origin | Mainland China |
| Package Weight | Approx. 0.03 kg (30 grams) |
| Package Dimensions (L x W x H) | Approx. 3 cm x 3 cm x 3 cm |
Package Contents
- 1x Volume Knob
- 1x Channel Selector Knob
Compatible Radio Models
This knob set is compatible with the following two-way radio models:
- Kenwood TK3160
- Kenwood TK3107
- Kenwood TK3207
- Kenwood TK3360
- Kenwood TK2207
- Kenwood TK2107
- KG-816
- NX320
Setup and Installation
Before installation, ensure your radio is powered off and the battery is removed to prevent accidental operation or damage.
-
Remove Old Knobs:
Gently pull the existing volume and channel selector knobs straight off their respective shafts. If they are stuck, a small, flat tool may be used carefully to pry them off, taking care not to damage the radio casing or shafts.
-
Identify New Knobs:
The set includes a Volume Knob and a Channel Selector Knob. Visually inspect them to ensure they match the original knobs' function and shaft type (e.g., D-shaped or splined). The volume knob typically has a smaller diameter or a distinct marking for volume control, while the channel selector knob is often larger and may have detents for channel selection.
-
Install New Knobs:
Align the new Volume Knob with the volume control shaft and press it firmly into place until it is seated securely. Repeat this process for the Channel Selector Knob on its corresponding shaft. Ensure both knobs rotate smoothly and engage properly.
-
Test Functionality:
Reinsert the battery and power on your radio. Test the volume control and channel selection to confirm proper operation. If a knob does not function correctly, remove it and re-install, ensuring it is fully seated and aligned.
Operating Instructions
Once installed, the replacement knobs function identically to the original parts of your radio.
- Volume Knob: Rotate clockwise to increase volume, counter-clockwise to decrease volume.
- Channel Selector Knob: Rotate to select desired channels or frequencies. Each click typically corresponds to a channel change.
Maintenance
To ensure longevity and proper function of your knobs:
- Cleaning: Wipe the knobs with a soft, dry cloth. For stubborn dirt, a slightly damp cloth with mild soap can be used, followed by immediate drying. Avoid harsh chemicals or abrasive cleaners.
- Storage: If removed, store the knobs in a clean, dry place away from direct sunlight and extreme temperatures.
Troubleshooting
- Knob does not fit: Double-check the compatibility list with your radio model. Ensure you are attempting to install the correct knob (volume vs. channel) on the corresponding shaft.
- Knob is loose or falls off: Ensure the knob is pressed firmly onto the shaft until it clicks or feels secure. If it remains loose, the shaft or the knob's internal fitting might be worn.
- Knob does not turn or function: Verify that the knob is correctly aligned with the shaft. If the issue persists, the problem may lie with the radio's internal components rather than the knob itself.
User Tips
No specific user tips were available from reviews or Q&A for this product. Always refer to your radio's original manual for detailed operating instructions.
Warranty and Support
For any questions regarding the product, compatibility, or installation, please contact the seller directly. Information regarding specific warranty terms should be obtained from the seller at the time of purchase.