HOMCOM 851-018

Contents

HOMCOM Motion Sensor Rubbish Bin

Model: 851-018

Introduction

Thank you for choosing the HOMCOM Motion Sensor Rubbish Bin. This manual provides essential information for the safe and efficient use of your new appliance. Designed for modern homes and offices, this 72-litre capacity bin offers a hygienic and convenient waste management solution with its touchless operation and multi-compartment design for easy waste separation.

Front view of the HOMCOM Motion Sensor Rubbish Bin
The HOMCOM Motion Sensor Rubbish Bin in stainless steel finish.

Package Contents

Please check the package for the following items:

  • 1 x HOMCOM Motion Sensor Rubbish Bin Unit
  • 1 x Removable Lid
  • 1 x Upper Inner Bin (47L)
  • 2 x Lower Inner Bins (12.5L each)
  • Instruction Manual

Setup

  1. Unpacking: Carefully remove all components from the packaging. Retain packaging for future transport or storage.

  2. Battery Installation: The bin requires 6 x AA batteries (not included). Locate the battery compartment, typically on the underside of the lid. Insert the batteries, ensuring correct polarity (+/-).

  3. Positioning: Place the rubbish bin on a flat, stable surface. Ensure there is enough clear space above and in front of the sensor area (within 15 cm) for optimal operation and lid movement.

  4. Insert Inner Bins: Place the large 47L inner bin into the upper compartment. Slide the two 12.5L inner bins into the lower pull-out drawer. These are designed for separating different types of waste, such as dry and wet waste or recycling.

    Diagram showing multiple compartments for waste separation
    The bin features a 47L upper compartment and two 12.5L lower compartments for efficient waste separation.

Operating Instructions

Motion Sensor Operation

  1. Ensure batteries are installed correctly and the bin is powered on (if there's a power switch).

  2. Wave your hand or an object within 15 cm of the infrared sensor located on the lid. The lid will open automatically in approximately 0.5 seconds.

    Diagram illustrating touchless sensor operation
    Activate the lid by waving your hand within 15 cm of the infrared sensor.
  3. The lid will remain open for a few seconds, allowing you to dispose of waste. It will then close automatically.

Manual Operation

If preferred, or if batteries are depleted, the lid can be operated manually:

  • Press the 'OPEN' button on the lid to open it.
  • Press the 'CLOSE' button to close the lid.
Close-up of manual OPEN and CLOSE buttons on the bin lid
Manual control buttons for opening and closing the lid.

Waste Separation

Utilize the three compartments for efficient waste separation:

  • Upper Compartment (47L): Ideal for general dry waste or recycling.
  • Lower Compartments (2 x 12.5L): Use these pull-out bins for wet waste, organic waste, or specific recycling categories.

Maintenance and Cleaning

Regular cleaning will ensure the longevity and hygiene of your rubbish bin.

  • Exterior Cleaning: The bin features a fingerprint-proof stainless steel surface. Wipe the exterior with a soft, damp cloth and a mild detergent. Avoid abrasive cleaners or scourers that could scratch the finish.

    Visual representation of the fingerprint-proof surface
    The fingerprint-proof surface simplifies cleaning and maintains a sleek appearance.
  • Inner Bins: The inner bins are removable for easy emptying and cleaning. Wash them with warm soapy water and rinse thoroughly. Ensure they are completely dry before placing them back into the main unit.

  • Lid Cleaning: Wipe the lid, especially around the sensor area, with a soft, damp cloth. Do not immerse the lid in water as it contains electronic components.

  • Battery Replacement: Replace batteries when the sensor operation becomes sluggish or stops working. Always replace all 6 AA batteries at the same time.

Troubleshooting

  • Lid not opening/closing automatically:

    • Check if the batteries are correctly installed and have sufficient power. Replace all 6 AA batteries if necessary.
    • Ensure there are no obstructions blocking the sensor or the lid's movement.
    • Clean the sensor window to remove any dirt or debris.
  • Lid opens unexpectedly:

    • Ensure the bin is not placed in an area with high traffic or direct sunlight, which can sometimes interfere with infrared sensors.
  • Manual buttons not working:

    • Check battery power.
    • Ensure buttons are not jammed or obstructed.

Specifications

FeatureSpecification
BrandHOMCOM
Model Number851-018
Waste Capacity72 Litres (47L upper, 2 x 12.5L lower)
Overall Dimensions42L x 30W x 81H cm
MaterialStainless Steel, ABS Plastic
ColourStainless Steel Colour, Black, Green, Grey
Lid Cover Size42L x 30W x 9H cm
Inside Opening Size39L x 26W cm
Sensor TypeInfrared Motion Sensor
Sensor Activation Time0.5 seconds
Sensor AreaWithin 15 cm
Upper Trashbin Size39L x 29W x 37H cm
Bottom Trashbin Size23.5L x 17W x 32H cm (each)
Power Source6 x AA batteries (not included)
Net Weight10 kg
CertificationsCE, RoHS tested product
Dimensions diagram for the 72L bin and its inner compartment
Detailed dimensions of the bin and its internal components.

User Tips

  • Optimize Battery Life: To extend battery life, avoid placing the bin in high-traffic areas where the sensor might be triggered unnecessarily.
  • Proper Waste Bags: Use waste bags that fit snugly within the inner bins to prevent them from slipping and obstructing the lid mechanism.
  • Sensor Awareness: Be mindful of the 15 cm sensor range. Approaching too quickly or from too far away may not trigger the lid consistently.
  • Regular Cleaning: Wipe down the sensor area and the lid regularly to prevent dust or grime buildup from affecting sensor performance.

Warranty and Support

For warranty information or technical support, please refer to the documentation provided at the point of purchase or contact your retailer. Keep your purchase receipt as proof of purchase.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.